To what constant deceleration would a car moving along a straight road be subjected if the car were brought to rest from a speed of 92 ft/sec in 9 sec? What would the stopping distance be?

The ideal diameter of a rod needed for a machine is 75 mm. The actual diameter can vary from the ideal diameterby 0.05 mm. What range of diameters will be acceptable to the customer without causing the rod to be rejected?

A driver of a car stopped at a gas station to fill up his gas tank. He looked at his watch, and the time read exactly 3:40 p.m. At this time, he started pumping gas into the tank. At exactly 3:44, the tank was full and he noticed that he had pumped 10.7 gallons. What is the average rate of flow of the gasoline into the gas tank?

A plug gage tapers 3.10 mm along a 38.00 mm length, as shown in Figure 215. Set up a proportion and determine the amount of taper in the workpiece for each of the following problems. Express the answers to 2 decimal places.

A car crosses an intersection as a fire engine approaches the intersection at 50 ft/s. how far does the fire engine travel while stopping, if the acceleration is −6t?   Round to two decimal places.