To solve the problem concisely using smulink in MATLAB. 8. Build the following communication system model. The model, shown in the following figure, contains the most basic elements of a communication system: a source for the signal, a channel with noise, and means of detecting errors caused by noise. Bernoulli Binary Bernoulli Binary Generator BSC Tx Error Rate Rx Calculation Error Rate Calculation Binary Symmetric Channel Display Set the Error probability for the Binary Symmetric Channel Block 0.01, 0.05, 0.1 and 1.0, and the sampling rate for Bernoulli Binary Generator Block 0.001. Connect the blocks and display the following information for each value of Error probabilities: . The bit error rate. . The number of errors. The total number of bits that are transmitted. Hint: See example-4, page (6-16).

To solve the problem concisely using smulink in MATLAB. 8. Build the following communication system model. The model, shown in the following figure, contains the most basic elements of a communication system: a source for the signal, a channel with noise, and means of detecting errors caused by noise. Bernoulli Binary Bernoulli Binary Generator BSC Tx Error Rate Rx Calculation Error Rate Calculation Binary Symmetric Channel Display Set the Error probability for the Binary Symmetric Channel Block 0.01, 0.05, 0.1 and 1.0, and the sampling rate for Bernoulli Binary Generator Block 0.001. Connect the blocks and display the following information for each value of Error probabilities: . The bit error rate. . The number of errors. The total number of bits that are transmitted. Hint: See example-4, page (6-16).

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

1) A 5 turn, 100 K2 potentiometer shaft is turned 720 degree, the voltage Vout between the arm and ground changes by 16 volts. a. What is the gain (Kp) of the potentiometer in volt/degree? b. What is the ER, the maximum voltage? c. If the measured resistance at midpoint is 50.5 K2, what is its linearity?
6 - What is a thermistor?A) Resistance changes with pressureB) Resistance changes with temperatureC) Diameter changes to pressureD) Length varies with temperatureE) Resistance changes with light
Q2: Define the component of Furnace temperature control system as a block diagram and the function of each unit
Write one paragraph describing why you think chrome has a shiny surface.
How does the concept of duality apply to electrical circuits?
The Voltmeter Ammeter method for measuring resistance is Select one: a. An appropriate method for measuring the resistance indirectly. b. An appropriate method for measuring the resistance directly. C. An appropriate less accuracy than direct resistance measuring methods.
A 50 μA basic D'Arsonval movement with an internal resistance of 500 is to be used as a voltmeter. The value of the multiplier resistance required to measure a full-scale voltage range of 0-5 volts is?
Subject:Circuits INote:Support the problems with circuit diagram and label the pertinent partsPlease with full solution
The illustration below shows the components of a simple circuit diagram.choose from the choices on the left the best term or description that will match each component and the function.write your answer on the prescribed box
How do you find the values for a combination circuit?
Question 4 (a) A PMMC movement with a coil resistance of 25 0 requires 0.8 mA for full scale deflection. Specify: a. The coil voltage required for full scale deflection. b. The shunt resistance required for a 0-1 A ammeter. c. The multiplier resistance required for a 0-10V voltmeter. d. Draw both instruments.