To compress the volume of the cylinder to 50%, how large should the mass M be, if the mass of the cylinder head is 1kg? Assume that the temperature of the cylinder volume is kept constant with circulating coolant. Due to the overheated coolant, the temperature of the cylinder has risen to double the volume. What should be T2, if T1 is 200K?

To compress the volume of the cylinder to 50%, how large should the mass M be, if the mass of the cylinder head is 1kg? Assume that the temperature of the cylinder volume is kept constant with circulating coolant. Due to the overheated coolant, the temperature of the cylinder has risen to double the volume. What should be T2, if T1 is 200K?

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

at the top and rotates about its vertical axis at 105 r/min. Before open rotation started the container was full. Calculate how much water will remain after the container has been brought to rest. (247 litre) 5. A closed cylindrical container with diameter 650 mm is rotated at 600 r/min about its vertical axis. Calculate the pressure that will develop with the cylinder when the container is completely filled with water. (208.5 kPa) 6. A A cylindrical completely filled with water. A paddle with diameter 200 mm rotates at the bottom of the container at a speed of 120 r/min. Calculate: container has internal diameter of 600 mm and an a. The tangential velocities of the water at radii of 75 mm and 225 mm respectively. b. The corresponding pressure heads at the above radii measured from at the bottom of the container. (0.942 m/s, 0.559 m/s, 45.2 mm, 145.1 mm) A compound vortex that has formed in a large water reservoir consists of a central forced vortex and a surrounding free vortex. The…
A constant pressure of about 300 psi is required. If the water is at atmospheric pressure at 15oC, what temperature would the engineer need to maintain while the train is operating?
The value of surface tension is less at 50 oc 80 oC 103 oF 300oC No correct answer
If the compressor suction pressure is 70 pounds per square inch gaugepressure (psig) and the outside temperature is 85°F, what should thedischarge pressure be reading?
The cylinder, which has a sensitively moving piston inside, is filled with V₁ = 0.93421 The temperature outside is T₁ = 8 °C and the air pressure is p₁ = 101 kPa The piston is quickly pressed into the cylinder, causing the volume in the cylinder to decrease to V3 = 0.2975 1 and the pressure to increase to p2 = 210 kPa. The piston is locked in place and the cylinder is immediately brought to the laboratory. After that, it happened that the gas temperature became same as the laboratory temperature of T3 = 22 °C Determine the gas pressure when the gas temperature has reached the final temperature of the laboratory. What is the algebraic expression for pressure in terms of V_1, T_1, p_1, V_3 and T_3 P3 = What is the pressure? P3 = kPa
Please help!!! (Will provide helpful ratings for correct solution)
What is the pressure in psf in an altitude where the temperature is 513.4298073 degrees Rankine?