Three similar ideal cells (no internal resistances) supply current of 0.5 Ampere to a 10 ohm resistor when they are in parallel. How much current will they suply to the same resistor when they are connected in series aiding?

Three similar ideal cells (no internal resistances) supply current of 0.5 Ampere to a 10 ohm resistor when they are in parallel. How much current will they suply to the same resistor when they are connected in series aiding?

Principles of Physics: A Calculus-Based Text

5th Edition

ISBN:9781133104261

Author:Raymond A. Serway, John W. Jewett

Publisher:Raymond A. Serway, John W. Jewett

Chapter21: Current And Direct Current Circuits

Section: Chapter Questions

Problem 68P

See similar textbooks

Related questions

Q: During a physics demonstration, a fully charged 98 µF capacitor discharges through a 125 Ω resistor.…

Q: Three 9.0- Ω resistors are connected in series with a 12 - V battery.Find (a) the equivalent…

A: Given, The resistance in each resistors, R=9.0ohm The voltage in the battery,…

Q: A 9.0-Ω resistor and a 6.0-Ω resistor are connected in series with a power supply. (a) The voltage…

Q: A simple RC circuit consists of a 1-μF capacitor in series with a 3000-Ω resistor, a 6-V battery,…

Q: A 10.0 V battery is connected across two resistors in series. If the resistors have resistances of…

Q: In the circuit shown in Fig. both capacitors are initially charged to 45.0 V. (a) How long after…

A: Given data, Initial potential difference at the capacitors = 45 V Final potential difference = 10 V

Q: A 100 resistor and an initially empty 20 uF capacitor are connected in series and connected to a 6 V…

Q: What is the smallest capacitor needed in a computer power supply in order to produce at least 4.45 V…

A: Resistance= R= 6 Ohms Motherboard voltage= V= 5volts Time = t =0.21 sec

Q: A circuit has a 21Ω resistor, a 895Ω resistor and a 104 resistor all connected in series with each…

A: If Resistances R1, R2, R3 connected in series then equivalent resistance of the circuit is Req=…

Q: A coffee maker is rated at 1200 W, a toaster at 1100 W, and a waffle maker at 1400 W. The three…

Q: A heart pacemaker fires 72 times a minute, each time a 25.0-nF capacitor is charged (by a battery in…

Q: A 100uf capacitor and a 3.6kohms resistor are connected in series. How long will it take for the…

A: To determine the time it takes for the capacitor to change its charge completely, we need to…

Q: A 6.00 nF capacitor that is initially uncharged is connected in series with a 900 resistor and an…

A: when the capacitor is first not charged. It will then send all of the charge via the circuit…

Q: A household circuit operating at 240 V has four appliances connected in Parallel. The resistances of…

Q: An airplane black box contains a bunch of unknown resistances and batteries connected in unknown way…

A: Given Data:- R1= 9Ω resistor draws a current i1=0.80 A and R2=17 Ω resistor draws a current i2=0.50…

Q: Two resistors of 36Ω and 55Ω are connected in series. If the voltage drop across the 36-Ω resistor…

Question

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

Consider the circuit below. The battery has an emf of = 30.00 V and an internal resistance of r = 1,00 . (a) Find the equivalent resistance of the circuit and the current out of the battery. (b) Find the current through each resistor, (c) Find die potential drop across each resistor, (d) Find the power dissipated by each resistor, (e) Find the total power supplied by the batteries.
Show that if two resistors R1and R2are combined and one is much greater than the other (R 1 >>R 2 ): (a) Their series resistance is very nearly equal to the greater resistance R 1. (b) Their parallel resistance is very nearly equal to smaller resistance R2.
When resistors with different resistances are connected in parallel, which of the following must be the same for each resistor? Choose all correct answers, (a) potential difference (b) current (c) power delivered (d) charge entering each resistor in a given time interval (e) none of those answers
If the terminals of a battery with zero internal resistance are connected across two identical resistors in series, the total power delivered by the battery is 8.00 W. If the same battery is connected across the same resistors in parallel, what is the total power delivered by the battery? (a) 16.0 W (b) 32.0 W (c) 2.00 W (d) 4.00 W (e) none of those answers
The power dissipated in a resistor is given by P = V2/R, which means power decreases if resistance increases. Yet this power is also given by P = I2R, which means power increases if resistance increases. Explain why there is no contradiction here.
Integrated Concepts A 12.0-V emf automobile battery has a terminal voltage of 16.0 V when being charged by a current of 10.0 A. (a) What is the battery’s internal resistance? (b) What power is dissipated inside the battery? (c) At what rate (in °C/min ) will its temperature increase if its mass is 20.0 kg and it has a specific heat of 0.300 kcal/kg. °C, assuming no heat escapes?
The terminals of a battery are connected across two resistors in parallel. The resistances of the resistors are not the same. Which of the following statements is correct? Choose all that are correct. (a) The resistor with the larger resistance carries more current than the other resistor. (b) The resistor with the larger resistance carries less current than the other resistor. (c) The potential difference across each resistor is the same. (d) The potential difference across the larger resistor is greater than the potential difference across the smaller resistor. (e) The potential difference is greater across the resistor closer to the battery.
Power P0 = I0 V0 is delivered to a resistor of resistance R0. If the resistance is doubled (Rnew = 2R0) while the voltage is adjusted such that the current is constant, what are the ratios (a) Pnew/P0 and (b) Vnew/V0? If, instead, the resistance is held constant while Pnew = 2P0, what are the ratios (c) Vnew/V0, and (d) Inew/I0?
Figure 21.55 shows how a bleeder resistor is used to discharge a capacitor after an electronic device is shut off allowing a person to work on the electronics with less risk of shock, (a) What is the time constant? (b) How long will it take to reduce the voltage on the capacitor to 0.250% (5% of 5%) of its full value once discharge begins? (c) If the capacitor is charged to a voltage V0through a 100-O resistance, calculate the time it takes to rise to 0.865V0(This is about two time constants.)
The values of the components in a simple series RC circuit containing a switch (Fig. P21.53) are C = 1.00 F, R = 2.00 106 , and = 10.0 V. At the instant 10.0 s after the switch is closed, calculate (a) the charge on the capacitor, (b) the current in the resistor, (c) the rate at which energy is being stored in the capacitor, and (d) the rate at which energy is being delivered by the battery.
A battery with an internal resistance of 10.0 produces an open circuit voltage of 12.0 V. A variable load resistance with a range from 0 to 30.0 is connected across the battery. (Note: A battery has a resistance that depends on the condition of its chemicals and that increases as the battery ages. This internal resistance can be represented in a simple circuit diagram as a resistor in series with the battery.) (a) Graph the power dissipated in the load resistor as a function of the load resistance. (b) With your graph, demonstrate the following important theorem: The power delivered to a load is a maximum if the load resistance equals the internal resistance of the source.
Draw two graphs of charge versus time on a capacitor. Draw one for charging an initially uncharged capacitor in series with a resistor, as in the circuit in Figure 21.38, starting from t = 0. Draw the other for discharging a capacitor through a resistor, as in the circuit in Figure 21.39, starting at t = 0, with an initial charge Q0. Show at least two intervals of t.