Answered: three reservoirs system in the figure…

three reservoirs system in the figure contains water. L1 = 2000 m, f 1= 0.013, D1 = 1m L2 = 2300 m, f2 = 0.02, D2 = 0.60m L3 = 2500 m, f = 0.023, D3 = 1.20m what is Q2 in m3/s.

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: 8.5 A small reservoir has a spillway crest at elevation 200.00 m. Above this elevation, the storage…

A: A small reservoir has a spillway crest at elevation 200.00 llp0w The storage and outflow from…

Q: Refer to the previous problem. Determine the time to empty the hemispherical bowl through the…

A: C = 0.60 r = 2m diameter of orifice = 50mm It has been asked in the question to determine the time…

Q: A prismatic tank having variable cross- Atmosphere section (base areas: A¡ = 20 m² and A2 = 10 m²)…

A: dm˙=mass flow rate=ρ2πrdrufrom result…

Q: Water flows steadily through a pipe junction as shown in the diagram. The velocities provided are…

A: Given Data Velocity in pipe-1 (V1) = 5 m/s Velocity in pipe-3 (V3) = 12 m/s Area of pipe-1 (A1) =…

Q: The area within the contour line at the site of reservoir and the face of the dam are as under -…

A: Area of contour line at the reservoir and the face of the dam:-S.No.contour…

Q: The elevations of water surfaces in reservoirs A and B are 300 ft and 250 ft, respectively, and…

A: To Determine the elevation of the surface of reservoir C, El C.

Q: 01: A pipeline joining a lake and a reservoir whose water levels differ by 91.4 m has a diameter of…

A: As math type not available, providing hand written solution, and according to our policy providing…

Q: Estimate the uplift pressure under bottom left corner of this dam If the entire dam sits 2ft below…

A: coefficient of permeability, Height, Height,

Q: Estimate the flow under the dam below given: k = 5.2x10^-4 cm/s, h1 = 32ft, h2 = 11ft. Answer in…

A: Coefficient of permeability, To find: Flow under the dam.

Q: 3 m P Lower reservoir 100 m 1 m Upper reservoir 10 m

Q: A confined aquifer underlies an unconfined aquifer as shown in the illustration below. Given the…

Q: If 150 L/s of water flows through the system shown in the figure below, calculate the pressure at 2.…

A: For the point 1 - P1 = 0, V1 = 0, Z1 = 35m For the point 2 - Z2 = 0

Q: A long pipeline carries 75.0 ft3/s of water from reservoir 1 to junction A, where it is distributed…

A: Given Hazen-Williams coefficient= 150

Q: 20 15 165 10 250 np curve in the form of quadratic equation. s installed in a pipeline to augment…

A: we will plot the pump characterstic curve from given databy the curve if Q =170L/shead developed =…

Q: Two tanks A and B. of constant cross-sectiona rea of 10 m² and 2.5 m², respectively, are onnected by…

Q: Reservoir 1 = In figure, if L1= 20 m, diameter 30 cm, velocity = 0.1 m/s, friction ?= factor= 0.023,…

Q: As shown in figure 3., water flows through pipe A 1.5 m in diameter at 2.5 m/s and passes through…

A: Diameter of pipe A, DA=1.5mDiameter of pipe B, DB=1mDiameter of pipe C, DC=0.7mVeocity of flow in A,…

Q: FIGURE Q2 The diameters of the nozzle and the pipe are given by dn = 25 mm and d, = 50 mm,…

A: To determine flow rate through the nozzle and the pressure at points A and B. Given, Diameter of…

Q: (c) The outflow rate (ft3/s) and storage (ft³/s-hr) for an emergency spillway of a certain reservoir…

Q: 5: There are two reservoirs, A and B, with the water surface elevation in A 10 m higher than that in…

Q: A rectangular concrete channel 5m wide carries water as shown in the figure below. The channel bed…

A: GIVEN : WIDTH ( B )= 5 m SLOPE OF BED = 0.0013 TO FIND DISCHARGE ( Q )

Q: 17. An open cylindrical tank 4 m in diameter and 10 m high contains 4 m of oil sg = 0.9. An orifice…

A: The objective of the question is to calculate the time required to discharge all the oil from a…

Q: The river discharges into the reservoir shown at a rate of 400,000 ft³/s, and the outf the reservoir…

A: Given :

Q: A pipe 300 m long is to convey 600 liters per second of water between two reservoirs. If the…

Q: 17. An open cylindrical tank 4 m in diameter and 10 m high contains 4 m of oil sg = 0.9. An orifice…

Q: 2 A rectangular channel of 2.5 m width is carrying a discharge of 4 m³/s. Considering that…

Q: A long pipe is installed to carry water from one large reservoir to another. The total lenght of the…

A: Pumping power is calculated by multiplying the volume of the fluid per unit time (flow capacity) by…

Q: Compute for the flow rate in cubic meter per second of oil with p = 950 kg/m³ and v = 0.00002 m?/s,…

Q: 2. Water flows at a rate of 90lt/s from reservoir A to reservoir B through three concrete pipes…

A: given data, L1=6000m,D1=0.3m,f1=0.018; L2=4000m,D2=0.23m,f2=0.015; L3=2500m,D3=0.2m,f3=0.012 since…

Q: flows at 2.08 cm/s. At a second point downstream, but on the same level, the canal is 16.21 m wide

A: at point A b1 =18.74 m y1 = 3.79 m v1 = 2.08 cm/ s at point B b2 = 16.21 m y2 = v2 = 10.8…

Q: A water reservoir of 300 (Height) x 300 (width) x 500 (depth) m has its free surface at 250 m above…

A: Height of reservoir = 300m Width = 300m Depth = 500m Dia of orifice = 500mm Coefficient of…

Q: The storage-outflow characteristics for a reservoir are given below. Storage (106 m³) 70 80 85…

A: To find:graph of storage outflow function

Q: For the following flows, determine the components of rotation about the various axes. (a) u = xy°z,…

Q: 4. Considering the following figure with flow from A to D, compute the total head loss from A to D…

A: Find total head loss in pipe from A to D

Q: 1 3 2 Figure Q1

A: Supercritical Flow:- Depths of flow less than critical depths resulting from relatively steep…

Q: Three reservoirs Z, Y, and X meet at Junction P. Reservoir Y (25m above Reservoir X) is at Elev.…

Q: 7. When just full, a reservoir has a surface area of 0.8 km², and this area is approximately…

Q: Q3. Water flows along the rectangular channel such that after it falls to the lower elevation, the…

Q: A rectangular concrete channel 5m wide carries water as shown in the figure. The channel bed slope…

A: Given Data:b=5my1=2.4my2=1.5ms=0.0022

Q: An open rectangular tank is 4m long, 2m wide and 2m high kounted on a truck full of waterm Calculate…

A: Using formula to find water present in tank

Question

three reservoirs system in the figure contains water.

L1 = 2000 m, f 1= 0.013, D1 = 1m

L2 = 2300 m, f2 = 0.02, D2 = 0.60m

L3 = 2500 m, f = 0.023, D3 = 1.20m

what is Q₂ in m³/s.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1 Given

Step 2 Solution

Step 3

Step 4

Step 5 Answer

Step by step

Solved in 5 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

Three Decimal Places Only
Determine the radius of the orifice that will allow a tank of horizontal cross-section of 2.5 m^2 to have its liquid surface draw down at the rate of 0.2 m/s for a constant head of 4m on the orifice with Cc= 0.66 and Cv= 0.96
A reservoir is to be constructed to regulate the flow of a river. The monthly inflow amounts are given below. Assuming 100% regulation, estimate the storage capacity of the reservoir. Month 0 St (106 m³) 5 N 7 D 8 J 9 F 12 M 15 A 14 M 9 J 4 J 2 A 1 S 4
Example 12.3. A small reservoir has a spillway crest elevation 200.0 m. Above this elevation, the storage and outflow from the reservoir can be expressed as: Storage: S=36000 + 18000y m³, Outflow Q=10y m³/s, where y is height of water above spillway crest in m. Route an inflow hydrograph which can be approximated by a triangle as: 1=0 at t=0, 1=30 m³/s at t=6 h and I = 0 at t = 26 h Assume at t= 0.y=0 and use At = 2 h
I need the answer to the question in fluid mechanics
DRAW AN ILLUSTRATION OF THE FIGURE. SHOW COMPLETE AND DETAILED SOLUTIONS.
z=174 m A B z=152 m z=91 m T = and Op ≈pg əx (Pump) C F A pump is used to deliver water from a reservoir to a large tank for a flowrate of 1310 L/s at 20 °C. The connecting pipe connects the reservoir at B with a square-edged entrance. From B to C, the pipe is 760 m long and has three gate valves, four 45⁰ elbows, and two 90° elbows. Gage pressure at C is 197 kPa. From F to G, the pipe is 760 m long and contains two gate valves (Kg.-0.136), four 90° elbows (K90-0.51) and connects the tank with an exit (Kext=1). All pipe is 508 mm in diameter (D) and made by cast iron ( = 0.26 mm). 1) Calculate the average velocity of water in the pipe. 2) Calculate the gage pressure at F. z=104 m 3) If the pump's efficiency is 80%, calculate the power input to the pump. 4) If the shear stress can be calculated using the equation D Op hL major 4 0x L Calculate the average wall shear stress in section F-G. G H
3.
A cylindrical tank with a large diameter is filled with water to a depth D = 0.416 m. A hole of cross-sectional area A = 7.83 cm? in the bottom of the tank allows water to drain out. (a) What is the rate at which water flows out, in cubic meters per second? (b) At what distance below the bottom of the tank is the cross-sectional area of the stream equal to one-half the area of the hole? (a) Number i Units (b) Number i Units
A semi-infinite body is constructed from a uniform flow with velocity Vo = 13.1 m/s and a source with strengthA = 1148 at the origin. Determine the stagnation point on the body (rstag-TT) and compute the velocity components Vr and Ve and the velocity components Vy and Vy on the surface of the body at 0 = 1.9 rad. Give your answers to 3 decimal places. Istag m Vr = Ve = Vx = Vy =[ m/s m/s |m/s m/s
answer is given just give the solution and right answer.
3) An incompressible flow velocity field is given as 1 1 [m/s] r r where r is in meters. (a) Calculate the mass flow rate through the cylindrical surface at r =1 m from z = 0 to z =1 m as shown in Figure A (b) Show that mass is conserved in the annular control volume from r = 1 m to r = 2 m and z = 0 to z = 1 m as shown Figure B a 2 m. I m 1 m 1 m 1 m