Three reservoirs A, B and C are connected by a pipe system as shown in the following figure. The length and diameter of pipe 1, 2 and 3 are 2000m, 1000m, 500m and 30cm, 25cm, 20cm respectively. Find the discharge into or from the reservoir B and C if the rate of flow from reservoir A is 50 lit/s. Find the height of water level in the reservoir C. Take coefficient of friction = 0.005  for all three pipes.

Q: Question 20 There are three pipes and each has different friction or roughness factors below: Saint…

A:

Q: Two pipes are connected in parallel between two reservoirs A and B. The diameter, length Statement…

A: Dia of pipe 1 = 10 cmLength of pipe 1 = 1000 mCoefficient of friction for pipe 1 = 0.02Dia of pipe 2…

Q: Estimate the flow under the dam below given: k = 5.2x10^-4 cm/s, h1 = 32ft, h2 = 11ft. Answer in…

A: Coefficient of permeability, To find: Flow under the dam.

Q: 3.18. Water is pumped from a supply reservoir to a ductile iron water transmission line, as shown in…

A: Given : Dia of pipe == 750 mm Pressure at A = 350 kPa

Q: 5: There are two reservoirs, A and B, with the water surface elevation in A 10 m higher than that in…

A:

Q: The pressure in the outlet pipe from the reservoir is 61.3 kPa abs and h =15 m. Because of the…

A:

Q: 3 2 Figure Q1

A: Given : Height at 1 = 2.4 m Width, b = 4 m Discharge, Q = 12 m3/s

Q: Show step by step sol

A: P1= 981 PaV1 = 1.53 m/sExplanation:

Q: Problem 1: Water at 60°C flows at a rate of 0.015 m³/s from the reservoir through the pipe system…

A: To Determine 1. If flow is laminar or turbulent inside the pipe 2. The energy loss, b, due to…

Q: A pipe having a length of 6 km and diameter 0.7 m connects two reservoirs A and B. If the difference…

A: For a given pipe,Length,L = 6 KMDiameter,d=0.7 mDifference between level of reservoir A and B, h=30…

Q: A water reservoir of 300 (Height) x 300 (width) x 500 (depth) m has its free surface at 250 m above…

A: Height of reservoir = 300m Width = 300m Depth = 500m Dia of orifice = 500mm Coefficient of…

Q: 3. Flownet shown below, dimensions in meters. Point A is located 12m below the base of the dam.…

A: Given:Total head ,H=12.9 mLocation of point A=12 m below the base of dam

Q: Water is being discharged from an upper reservoir to a lower reservoir through a turbine (assume 80%…

A: Given  Discharge = 0.15 cumec Efficiency = 80%  Height difference = 197.3- 50 = 147.3 m To calculate…

Q: 1 3 2 Figure Q1

A: Supercritical Flow:- Depths of flow less than critical depths resulting from relatively steep…

Q: Problem 4 Solve Problem 15.29 in the textbook. This is a 3-reservoir problem. Draw a sketch of the…

A: Step: 1 Reservoir is large lake in a particular area, city where water is stored for various…

Q: If the flow between the two reservoirs is 3 L/s, calculate the difference in elevation between the…

A:

Highway Drainage

Highway drainage is the process of extracting and regulating the excess surface water on the pavement by giving the desired slope. The construction of a highway drain helps to divert the water present on the surface, and sub-grade by the means of slope. Highway drainage systems are a necessary part of smooth functioning of traffic, since the highway drainage systems provide proper disposal of unwanted substances from the highways.