Three phase full convertor with 152 resistive load high inductance. The supply star three phase with 350V calculate: A. Current load at firing angle 60° B. Power consumed from the supply C. For the current above if the firing angle change to 130° calculate the restored power. D. The firing angle required for load current of 12 Amper E. Maximum output Average current.

Three phase full convertor with 152 resistive load high inductance. The supply star three phase with 350V calculate: A. Current load at firing angle 60° B. Power consumed from the supply C. For the current above if the firing angle change to 130° calculate the restored power. D. The firing angle required for load current of 12 Amper E. Maximum output Average current.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

A de-de converter is to be built to the following specifications: Allowed de input voltage range: +3 V to +18 V Output voltage (average value): +24 V Output voltage ripple: ±0.05 V maximum at rated load Rated load: 120 W, resistive Input current ripple: ±100 mA maximum at rated load Switching frequency: 100 kHz Common ground between input and output a. Draw a circuit which can perform this function. How many switches have gates? b. What is the range of duty ratio values for each switch? c. Find circuit part (L, C, R) values which will meet the stated specifications.
3. help please
In the full-wave rectifier circuit of figure 12, the transformer has a turns ratio of 1:2. The transformer primary winding is connected across an AC source of 230V (rms), 50 Hz. The load resistor is 50. For this circuit, determine the DC output voltage (3 significant figures)* Your answer
Parts D and E only please, thank you!
. Design a half wave rectifier using an op-amp. The output voltage should be -10V(peak) and the input voltage shouldbe 50Vac(peak) (1kHz, 0°).
EX2: (Buck dc-dc converter. Evaluation of the output voltage ripple) A buck converter has the following specifications: Vin= dc input voltage =50 V, D = duty cycle=D0.4, L=400 µH, C=100 µF f,= switching frequency = 20 kHz, R=20 2 Assuming that the converter is ideal, calculate: a) The output voltage. b) The maximum and minimum inductor current values. c) The output voltage ripple.
20Vp Vout 9V 15V Draw output wave for this circuit mentioning maximum and minimum peak voltages
Consider the full-wave bridge rectifier circuit. The input signal is 120 V (rms) at 60 Hz. The load resistance is R250. The peak output voltage is to be 9 V and the ripple voltage is to be no more than 5 percent. Determine the required turns ratio and the load current. Note: please solve within 30 minutes. Avoid plagiarism.
A 60 Hz sinusoidal voltage is applied to an SCR full-wave rectifier. If the DC output voltage is 162 V and the firing angle of the SCR is 60 degrees, the peak voltage of the input sinusoidal would be: O A. 197 V O B. 228 V O C. Can't tell; need more information. O D. 340 V O E. None of the other choices are correct
9- Buck type DC-DC converter, if the input voltage is 789 V and the occupancy-backlash ratio is 0.9, which of the following options is the correct load voltage. a) 710.1 etc) None c) O 7101 V d) O 78.9 V
Voltage Regulator and Power Supply 2
In ............ mode of operation, fully controlled converter will keep a delay angle range between 90 to 180.