There is 1 mol of He gas at 177 °C in the given manometer system. When the temperature of this gas is increased to 627 °C, what is the difference between mercury levels in the manometer? A)25B)50C)15D)10E)5

Q: Calculate the minimum wall thickness for a cylindrical vessel that is to carry a gas at a pressure…

A: Given: pressure, p = 1300 psi Diameter, D = 2 ft = 2×12 in = 24 in Stress, σt = 10 ksi = 10000 psi

Q: Provide the heating energy(kj)for the bulbs in below questions for a day,month and year.Provide a…

A: This problem is simple calculation which is normally used to determine the energy consumption in…

Q: Which of the following is the volume occupied by the refrigerant 134a with a mass of 12.4 kg at a…

A:

Q: In the given manometer system, there is 1 mole of He gas at 177 °C. When the temperature of this gas…

A:

Q: 24. A container with water is placed on a scale, and the scale reads 12 N. Now a 2.00-kg piece of…

A:

Q: 20 - The pressure of a closed container with a constant volume of 30 liters is 300 kPa. Which of the…

A: Given:V=30 litresP=300 KPam= 5 KgR-134a

Q: The pressure of a closed container with a constant volume of 30 liters is 300 kPa. What is the final…

A: Answer: 18.73 oC Using Table A-12 cengel thermodynamics textbook

Q: - If the temperature of methane gas at a temperature of 20ºC in a tank of constant volume and…

A:

Q: 3. The unit of kinematic viscosity is a) gm/cm-sec2 b) dyne-sec/cm2 c) gm/cm2-sec d) cm2/sec

A: Write the expression of kinematic viscosity. Here, μ is the dynamic viscosity, and ρ is the…

Q: - The pressure of a closed vessel with a constant volume of 22.4 liters is 300 kPa. Which of the…

A:

Q: Specific heat value at constant pressure (c_p) is function of temperature and given as 1/T where T…

A:

Q: Fluid with a density of 900 kg/m^3 is applying pressure on the gate shown. The depth of the water is…

A: Given data: Density of the fluid, ρ=900 kg/m3. Height of the gate, h=12 m and it's width, b=4 m. As…

Q: The hydraulic press is filled with oil (p= 800 kg/m³), as shown. The piston at B has a diameter of…

A: Load, m= 500 kg Weight, W= mg= 500(9.81)= 4905 N Density of oil,ρ= 800 kg/m3 Diameter of piston B,…

Q: 3. The cylindrical diving bell is open at the bottom and closed at the top, as shown. It is lowered…

A:

Q: luid with a density of 900 kg/m^3 is applying pressure on the gate shown. The depth of the water is…

A: Write the expression for the hydrostatics force.

Q: Find the dynamic viscosity of i) 50°F water ii ) 140°F water (in BG units) What is the ratio of the…

A: Given data: case 1 - Temperature =  50 deg.F case 2 -  Temperature = 140 deg.F   To find: a. dynamic…

Q: When is Strain hardening used? How is it performed?

A: Strain hardening is used when there is a need to increase the hardness of the material. It also…

Q: 1.0 A 100-cm diameter, 50-cm height wood disc, floats flat on its face in water with 36 cm…

A:

Q: Someone claims that the absolute pressure in a liquid of constant density doubles when the depth is…

A:

Q: CAMERO 1. A gage attached to a pressurized nitrogen tank reads a gage pressure of 70.5 cm of…

A: Note: As per the policy, we can solve the first three parts. Please resubmit the remaining part…

Q: 4. (2) The circumference of the earth is approximately: A) 5400NM B) 10800NM C) 21600NM D) 43200NM

A: Given that, object is earth  Let's take the earth radius to be  R=6378 km

Q: Blood pressure is 80 mm Hg . Convert it into absolute pressure? (1 atm = 760 mm Hg)

A: Absolute pressure is the sum of gauge pressure and atmospheric pressure.  Pabs = Pg + Patm where…

Q: Blood pressure is 100 mm Hg . Convert it into absolute pressure? (1 atm = 760 mm Hg)       A)760 mm…

A:

Q: 1) Fill in the unknown properties for the materials given below. PLEASE EXPLAIN THE CALCULATIONS YOU…

A: Solution, Water All the values can be obtained using steam tables of water. To define a state only…

Q: 1) Fill in the unknown properties for the materials given below. PLEASE EXPLAIN THE CALCULATIONS YOU…

A: a). Given, T=60 °C, h=2560 kJ/kg

Q: 10. The fuel gage for a gasoline tank in a car reads proportional to the bottom gage pressure as in…

A: Given: Height of tank, specific gravity of gasoline and water height Required: Height of air remain…

Q: As shown in the figure, if the velocity of the center of mass of the small cylinder is v = 8 (m/s),…

A:

Q: A fruit of 250 grams is cooled inside refrigerator from 30 C to 2 C. Determine the amount of the…

A: Given data: Mass of the fruits (m) = 250 g                                    = 0.25 kg Initial…

Q: A solid aluminum (SG = 2.70) has a measured mass of 66 grams in air and 46 grams when immersed in…

A:

Q: he sandbag with a mass of 31 - 12 kg will be hung from the ceiling with a steel rope consisting of 6…

A: m=Mass of sandbag=31.12 kgN=Number of wire=6A=Cross sectional area of Wire=0.1 cm2=0.1×10-4 m2g=10…

Q: 26. A container with water is placed on a scale, and the scale reads 12 N. Now a 2.00-kg piece of…

A:

Q: 4. The ceiling of a tunnel is in the shape of a parabola having a span of 10.00 meters and a height…

A:

Q: The quality of water is decreased from 100% (saturated vapor) to 50%. Which one of these will not be…

A: when water qualitu decreases from saturated vapor to towards saturated liquid, then its a phase…

Q: A spherical neutrophil 16µm in diameter is resting as shown in the attached photo. The pressure…

A: Hello. Since your question has multiple sub-parts, we will solve the first three sub-parts for you.…

Q: ) One kg of gas at 240 °C,expands adiabatically, so that its volume is doubled and th temperature…

A:

Q: Specific heat value at constant pressure (c_p) is function of temperature and given as 1/T where T…

A:

Q: A 0.60m3 tank contains saturated steam at 0.3 Mpa. Heat is transferred until the pressure reaches…

A:

Q: The surface tension of soapy water at 20 °C is σs =0.028 N/m. What would be the effective pressure…

A:

Q: 12 - A homogeneous, planar plate of constant thickness in the figure the coordinates of the…

A:

Q: Differential area dA of a gate is given as ydy where dy is the differential length and y is the…

A:

Q: h of the following is not a unit of pressure?       a)  N/m2   b)  mbar   c)  Pascal   d)…

A: Which of the following is not a unit of pressure?

Q: 2) A sealed rigid vessel has volume of 1 m³ and contains 2 kg of water at 100°C. The vessel is now…

A:

Q: With a 0.50 in diameter hole in the support bar, what is the approximate value of the stress…

A: Option (b) is correct Kt= 2.30

Q: A beaker is filled with a liquid up to a height h. If A and B are two points, one on the free…

A: