The wire AE is stretched between the corners A and E of a bent plate. Knowing that the tension in the wire is 408 N, determine magnitude of the moment about point C (Nm) of the force exerted by the wire on corner A. Round off only on the final answer expressed in 3 decimals.

Q: 0.4 m A 4.8 m 0.6 m 5.6 m 4.8 m x PROBLEM 3.51 A farmer uses cables and winch pullers B and E to…

A:

Q: Q2.1: Knowing that the distance AB is 250 mm determine the maximum moment about (B) which can be…

A:

Q: he magnitude of the force P is 583 N. Determine the magnitude of the moment (Nm) of P about the line…

A: Given   To find: Moment of the force P about the line CF.

Q: A steam turbine has an inlet of 2 kg/s water at 1000 kPa, 350 °C and velocity of 15 m/s. The exit is…

A:

Q: Determine the magnitude of the moment of the force F about point O

A:

Q: An 12-lb force P is applied to a shift lever. Determine the moment of P about B when a is equal to…

A: Given Data P=12 lb

Q: A precast concrete wall section is temporarily held by two cables as shown. Knowing that t cable BD…

A: Find the position  coordinates  for the points B and DThe position vector of BDThe position vector…

Q: -G 80° F -F 80° Two couples act on a rectangle with a base of 4m and a height of 6 m. Determine the…

A:

Q: The wire AE is stretched between the corners A and E of a bent plate. Knowing that the tension in…

A:

Q: Forces P and Q of magnitude 250 N and 500 N, respectively, are applied on the bent board as shown.…

A:

Q: Knowing that the two forces shown can be replaced by an equivalent force acting at O (no couple),…

A: If a force F is inclined at an angle θ with the horizontal, then the component of force along the…

Q: as shown in the figure. Knowing that the lever is 225 mm long and that a = 25 °, determine the…

A: given:length of the bar l=225mmα=250

Q: 200 mm 25° A D 125 m C B

A: To find  The moment of the force P about D. Given   The force P is 328 N. Concept used  The moment…

Q: A farmer uses cables and winch pullers B and E to plumb one side of a small barn. If it is known…

A:

Q: A gate is held in the position shown by cable AB. If the tension in the cable is 6.90 kN, determine…

A:

Q: 3.4 A 300-N force is applied at A as shown. Determine (a) the moment of the 300-N force about D, (b)…

A:

Q: A force of 90 N is applied on a lever AB as shown in the figure. Knowing that the lever is 225 mm…

A: given force F=90Nlength of lever AB L=225mm=0.225mmoment about point B is MB=13.5Nmα= angle makes by…

Q: Practice Problem 2.4.9: The magnitude of the force Pis 50 kN. Determine the moment of P about (a)…

A: a) Moment about point A        MA=Psin254+Pcos254=50sin254+50cos254=265.78 kN.m

Q: The magnitude of the force Qis 350 N. Determine the magnitude of the moment (Nm) of Q about point C.…

A:

Q: A 300-N force is applied at A as shown. Determine (a) the moment of the 300-N force about D, (b) the…

A: Given Data: Applied force is F = 300 N. The angle θ=25°. The moment about D can be calculated as,…

Q: The wire AE is stretched between the corners A and E of a bent plate. Knowing that the tension in…

A: MOMENT A moment is a movement of the body when a body is rotating on an axis. The moment is also…

Q: Q2. The turnbuckle is tightened until the tension in cable AB is 2 kN. Determine the moment about…

A: For the given system  Tension in AB (F) = 2 kN To determine  Moment about point O

Q: Q 2) For the figure shown, what is the moment about A of the force exerted by the cable BC. Knowing…

A:

Q: Q2. The force F acts on the end of the nine at B. Determine (a) the moment of this force aoout point…

A: Given :-  F = 70 N a = 0.9 m 0.3 m C = 0.7 m Theta = 60 deg

Q: A gate is held in the position shown by cable AB. If the tension in the cable is 6.75 kN, determine…

A:

Q: A force P of magnitude 330 lb acts on the frame shown at point E. (a) Determine the rectangular…

A: