The water surface in reservoir X is 6 m higher than that in reservoir Y. A 150 mm diameter pipe 270 m long connected to reservoir X leads to a junction where it is connected to a 100 mm diameter pipe 150 m long, connected to reservoir Y. At the junction, a 200 mm diameter pipe 720 m long is connected to the other two pipes. If the 200 mm diameter pipe discharges 40 lit/sec of water into the air and using n = 0.011 for all pipes, what is the difference in elevation between its free end and the water surface in reservoir X?

Q: 7. A heavy Oil (y = 9000 N/m³) is flowing at a rate of 0.65 m³/s in the system shown. If the total…

A: Q = 0.65 m3/s HL = 2.5 m PB = 70 kPa

Q: The three water-filled tanks shown in the figure below are connected by pipes as indicated. If minor…

A:

Q: 22. A 350 mm pipeline 3000 m long runs on a constant grade between two reservoir of surface…

A: The objective of the question is to calculate the energy produced by the pump. The energy produced…

Q: Reservoirs A, B, and C are connected as shown in Figure 2.28. The water elevations in reservoirs A,…

A: Given data Reservoirs A, B, C are connected, which means the flow is from A to B, and B to C…

Q: Water is being discharged from an upper reservoir to a lower reservoir through a turbine (assume 80%…

A: Given  Discharge = 0.15 cumec Efficiency = 80%  Height difference = 197.3- 50 = 147.3 m To calculate…

Q: Two reservoirs 1500 m apart have a water surface elevation difference of 18 m. A cast iron pipe with…

A:

Q: Reservoirs A, B and C are connected by pipelines 1, 2 and 3 respectively which meets at the junction…

A: 3 reservoirs are connected by pipelines 1,2 and 3 which meets at junction D Elevation of reservoir A…