The volumetric efficiency of a certain piston pump is 97%. If the pump delivers 14 L/min at 1200 rpm, find the Volumetric displacement of the pump.

Q: For a given pumping application, the required volume flow rate is 0.8 m²/s and a head of 12 m of…

A: Given that: Volume flow rate of a pump is 0.8 m3/s Head is 12 m Acceleration of gravity is 9.81 m/s2…

Q: A pump delivers 10 L/min with a pressure rise of 80 bar. The shaft speed is 1420 rev/min and the…

A:

Q: calculate the Displacement Volume, VD (m3)

A:

Q: 8.78. A pump is designed to operate at 1 800 r/min with 83.7% efficiency, and deliver 250 1/s with a…

A: Given:N=1800 rpmη=83.7%Q=250 L/s =250*10-3 m3/sP=141 KW

Q: ce an angle of 28° velocity direction

A:

Q: A pump is driven at 1800 RPM and delivers 12 GPM at 2000 psi. If the volumetric efficiency is 90%,…

A:

Q: 6. A centrifugal pump is directly coupled to a motor. The pump rating is 3,281 liters per minute…

A: Given data: Q=3281 lit/min=54.68×103 m3/secH=8 mη=65%N=770 rpnd=40 mm Need to determine the torque…

Q: 2. In the test of a centrifugal pump with water, the rate of discharge was found to be 260 li/s, the…

A: Given:Discharge, Q= 260 L/sPressure at the exit, P2g=13 kg/cm2Pressure at the inlet, P1g=15 cm of…

Q: 1. The Head -flowrate curve for a centrifugal pump is given by: Hp = 28 -30Q? Where, Hp is in meter…

A: It is mentioned in the question that both the pumps are connected in series, and we know that when…

Q: EX1: Given are the following data for a commercial centrifugal water pump: ri =10 cm, r2 = 17.5 cm,…

A: A Centrifugal pump is a mechanical device that converts the low-pressure fluid into the…

Q: Q.1) for the system shown in figure (a). The pump has the characteristics shown in figure (b). What…

A: Pressure in lower tank, PL=35 lb/in2=35*144=5040 lb/ft2Pressure in the upper tank, PU=10…

Q: B/A pump operates at 17237.5 kPa, discharges 11.4 liter/min and requires a pow 3.75 kW to drive the…

A: Given Pressure P=17237.5kPadischage rate Q=11.4 ltr /min=0.0114 m3/min=0.011460 m3/sspeed N=1725…

Q: A system requires a pump to deliver 30 gal/min at 1500 lbf/in2 at an engine speed of 2000 rpm.…

A: We know that volume flow rate is the product of displacement volume and speed of engine so this is…

Q: Q3/ A reaction turbine has mean blade speed of 220 m/s and blade speed to steam velocity ratio of…

A: To determine the angle at inlet of blade and work done per kg of steam flow, we can use the…

Q: A Large wind turbine has blade span diameters of 110 m. It sits high off the ground where the…

A: Given Data⇒Blade span diameterd=110 maverage wind speedv=7 msDensity of airρ=1.25…

Q: 2/3 Summarize the rotor theory of centrifugal pumps, focusing on the following topics: Action of…

A: A centrifugal pump is a mechanical device designed to move a fluid by means of the transfer of…

Q: d. Determine the velocity in the discharge side. e. Determine the velocity on the suction side. f.…

A: Since you have posted a question with multiple sub-parts, we will solve the first three subparts for…

Q: Select the correct response 88.56 m 61.75 m 81.56 m

A: GivenQ=50L/s=0.05 m3/sN=1450rpmNS≥760 rpm

Q: When two similar pumps operates in parallel, the volumetric capacity of the system changes by a…

A: When the pumps are added in parallel the volumetric flow rate (Q) is given by - Qnet =Q1 + Q2

Q: bar. Calculate the theoretical and actual flow if it has a volumetric efficiency of 88%, the real…

A: we have to determine the flow rate and power

Q: 1.The engine has a given capacity of 60kw, calculate the power requirement in a hydraulic system…

A:

Q: In a pumping system handling water, the level in the suction tank is 3.2m below the pump shaft…

A: NOTE:- As per our company guidelines we are supposed to answer only one question. Kindly repost…

Q: A pump has a displacement volume of 6 in^3. It delivers 24 gpm at 1000 rpm and 1000 psi. If the…

A: The displacement volume is The rotational speed is The pressure is The input torque is The discharge…

Q: A centrifugal pump is to deliver 227 m³/hr of water from a source 4 meters below the pump to a…

A: Given data: A centrifugal pump delivers 227 m3/hr of water from a source 4 meters below the pump…

Q: determine the rotation rate for the smaller , homologus pump . Using ONLY AFFINITY LAWS

A: To calculate the rotation rate of the smaller pumpgiven flow rategiven head of the pumpspeed of the…

Q: Determine the pump head (unit: meter or kPa), using the following parameters

A:

Q: A pump test reports the section pressure at a pump inlet to be 20 kPa below atmosphere.  The…

A: Given Data: The inlet pressure of the pump  Pi = -20 kPa. The outlet pressure of the pump Pf= 520…

Q: A pump with a volumetric displacement of 4 in^3/rev runs at 3600 rpm and produces 1500 psi. The…

A: The volumetric efficiency of the pump.Given:The volumetric displacement is .The angular speed of the…

Q: The pump has an er diameter of 8 cr 1750

A: The outer diameter of the pump is .The inner diameter of the pump is .The width of the blade is .The…

Q: A certain fan delivers 340 m/min of air at a static pressure of 25.4 mm of water gage when operating…

A: Calculate the rpm of the desired fan using the relation between volume flow rate and rpm. N2N1=Q2Q1…

Q: The wind turbine gives the following data: Blade length, l = 39 m, Wind speed, V= 12.4 m/s, Air…

A:

Q: The power (in MW) of a full sized

A: Given; A test conducted on a 1/5 scale model of a francis turbine under a head ,h=2mVolumetric flow…

Q: If a certain centrifugal pump generates 50 meters of head pumping water with a 1.0 specific gravity,…

A: GivenH=50mS.Gw=1S.G=1.82

Q: Determine the least number of stages for a multi-stage pump to deliver 80 L/s against a total head…

A:

Q: The data of a radial flow pump with 8 blades on its rotating impeller are as follows. a-) Find the…

A: Given: n=1200RPMηv=0.95ηh=0.84C2m=3m/st2=157mmβ2=30oB2=27mmηm=0.95D2/D1=2Z=8 To find: Head of the…

Q: For a pumper truck pumping water to a fire, the back pressure is the additional pressure on the pump…

A: The total height of the building is h= (16 ft)*9 h= 144 ft

Q: The fluid flow rate was 1 m3 / s and the head was 10 m in the experiment performed at 2000 rpm with…

A:

Q: Consider the following data relating to performance of a centrifugal pump: speed 1200 rpm, flow rate…

A:

Q: A centrifugal pump is to extract water 40 meters below the pump centerline. Water is delivered to a…

A: Given: The head delivered by the pump, H = 5 meter The head below the pump, h = 40 m The diameter of…

Q: A centrifugal pump delivers 30 liters/s of water when the shaft power is 15 kW and the efficiency is…

A:

Applied Fluid Mechanics

A fluid is a substance that is continuously deformed by the application of shear stress. The rate of deformation of a fluid depends on its viscosity. The fluid tries to flow when it interacts with some other system.