The vertical posts are supported by planks of the dam post with cross-section bx b. The spacing of the posts are s = 0.8m with the water level at h = 2m.

Q: AW360 x 72 standard steel shape is used to support the loads shown on the beam in Figure A. The…

A: Given data,Fig is givenP=5.7KNw=15.6KN/mM=44KN.ma=1.45mFINDMaximum tensile bending stressMaximum…

Q: Calculate the maximum stress in a 5mm thick steel plate with an 18 mm diameter round hole, given h…

A: t = 5 mmD = 18 mm hgross = 12 cm or 120 mm

Q: Two wooden planks, each 18 mm thick and 250 mm wide, are joined by the glued mortise joint shown.…

A: Given Thickness 18 mmLoad  19 kNCut d = 30 mmTo find out Maximum ave shear stress

Q: A W 305 x 87, 7.5m llong, is pinned at both ends and braced in the weak direction at the third…

A: Given :W 305 x 87 section L = 7.5 m or 7500 mm A = 10965 mm2 Ix = 331.2 x 106 mm4 Iy = 55.78 x 106…

Q: For the following cantilever beam and loading, a. Find the beam's maximum shear stress. Indicate…

A:

Q: Two 1/4 in. thick plywood sheets are joined by a 3/8 in. diameter bolt that transfers a shear force…

A: The objective of the question is to determine whether the plywood is overstressed in bearing. This…

Q: Two wooden members, each having a width of b = 6.6 in. and a depth of d = 2.2 in., are joined by a…

A: Given:- b=6.6 ind=2.2 inβ=30o To find:- Value of force P

Q: A W18 x 40 standard steel shape is used to support the loads shown on the beam. Assume P = 25 kips,…

A: W18×40 section  Determine the magnitude of maximum bending stress in the beam.

Q: The Q used in calculating the shear stress in the web does not seem correct

A: Answer We know that Q is first Moment of area about Neutral axis. For Calculation of shear stress at…

Q: Two wooden members, each having a width of b = 6.0 in. and a depth of d = 2.0 in., are joined by a…

A:

Q: 3. The diameter of the steel rod d=10Omm, F=5kN, E=210GPA. Determine the maximum strain and the…

A:

Q: 1-51. During a tension test, the wooden specimen is subjected to an average normal stress of 2 ksi.…

A:

Members with compression and bending

Compression members are structural elements that carry compressive axial force. They are the vertical members of a building that support beams and their design, which is governed by buckling and strength. Columns are known as struct or compression members, which are subjected to compressive forces. These members provide stiffness to the building and avoid any imperfection regarding the transfer of axial load. For instance, webs in a truss, braces in a framed structure, tiers, and so on.