The uniform blocks A and B weigh 90lb and 60lb, respectively. The coefficients of static friction at the three contacting surfaces are shown in the figure.  Find the maximum value for P in the direction shown which maintains static equilibrium. The sliding surfaces are flat and parallel to the applied force P.

Q: Two blocks A and B meet in contact as shown in the figure. If he coefficients of static friction for…

A: given- weight of block A=200lb            weight of block B =100lb…

Q: The two blocks used in a measuring device have negligible weight. The spring is compressed 4 in.…

A:

Q: A uniform circular disk, of 6-kg mass and 0.4-m radius, is placed at the corner, in contact with a…

A: Given: mass of circular disk =  6 kg radius of circular disc = 0.4 m Suppose the static friction…

Q: The box shown in the figure has a weight of 250 pounds. The coefficient of static friction between…

A:

Q: Determine whether the block shown below is in equilibrium, and find the magnitude and direction of…

A: Given:  The coefficient of static friction is μs=0.30,  The coefficient of kinetic friction is…

Q: The cylinder with mass, m = 30 kg, and 400 mm diameter rests against the surfaces as shown in the…

A:

Q: A body weighing 100 lb rests on an inclined plane, as shown. The coefficient of static friction…

A:

Q: Q3: The coefficient of static friction [10 M] 300 mm -700 mm between the drum and brake bar is Us =…

A:

Q: A sliding door with weight F= 100 Ib is mounted on a horizontal rail as shown in the figure. The…

A:

Q: in static equilibrium in the position shown? The uniform bar AB weighs 500 lb, and the weight of…

A: Weight of the bar AB .Weight of the block C .The static coefficent of static friction .

Q: The coefficient of friction between 200 Ib homogeneous cylinder and the horizontal plane is 0.4 as…

A: Write the expression of friction force in case of slipping.   Fk=μkN=μkW   But, in this case…

Q: A heavy cask (full of wine!) sits on an inclined plane. It is held in place by a rope that is…

A:

Q: Please plot the FBDs that allow you to find the weight of block D to keep the whole system in…

A:

Q: Two block A and B are connected by a rope which wraps areound a peg with static coefficient of…

A: Static coefficient of friction µ= 0.2 The weight of block B WB = 50-lb Force at block B   F=35-Ib…

Forming and Shaping

Metal forming is a category of metalworking process through which the material can be given the desired shape and size by subjecting it to plastic deformation, where the component undergoes bulk deformation process upon application of loads. Unlike the shearing and machining process, the material does not undergo up to a failure point as indicated in the stress-strain curve. Hence, the stresses induced during the forming process are greater than yield strength but less than the failure strength of the material. The process does not lead to the loss of material, so it can be said to be an economical process. During forming, the material is subjected to tensile forces, compressive forces, bending, and shearing loading conditions. The material should possess the property of ductility to undergo the forming process.