The truss shown is used to support a 9 kg block with a pin at A and a roller at E. Given a = 1.1 m, b = 0.7 m, c = 1 m and d = 1.3 m find the internal forces in members AB, AD, and ED. a b A E The force in member AB is The force in member AD is The force in member ED is B D N in (Click to select) ✓ N in (Click to select) N in (Click to select) (Click to select) tension compression

Q: Determine Iy. 50 mm 50 mm 300 mm 50 mm y -200 mm an -X We Problem 4

A:

Q: i cant read this.. can you write it out??

A:

Q: Using the diagram, determine the maximum diameter for DIA B.

A:

Q: 80mm 60mm Vax's Gomm 40mm Find the location of the Controid. Show All work. 1

A:

Q: Problem 6 You've been asked to design a stamping tool as shown. What are the internal forces at A…

A: FBD

Q: Write the four different types of Resultant Loadings?

A: Loading: The loading on the beam or any members is the load acting on a beam under which beam…

Q: 3

A:

Q: How did you get theta =45?

A: Consider following given figure of a structure.here we need to determine the angle between member DE…

Q: 2. Determine the reading on the vernier scale as indicated by the arrows. 25 30 35 40 10 20 30 40 50…

A: Least count of Vernier caliper = 0.02 mm

Q: The belt sander shown is initially at rest. If the driving drum B has a constant angular…

A:

Q: Wind flows over a flat plate of length L = 25 mm and width W = 8 mm. The plate is maintained at a…

A:

Q: Q2. (Answer One) AW-+号how tht +-0 ) "-/(). show that +-

A: Given To find prove the following

Q: Determine the x-y and n-t components of the 39-kip force F acting on the simply-supported beam. F =…

A:

Q: how did the equation simplify to a = 0.984?

A:

Q: 15.21 The rated speed of drum B of the belt sander shown is 2400 rpm. When the power is turned off,…

A: There are two types of acceleration associated with circular motion one is tangential acceleration…

Q: If the allowable tensile stress of the wires AB and AC is oallow = 250 Mpa, determine the largest…

A:

Q: What is the moment's function?

A: Moment deals with the physical quantities situated at some distance relative to the reference point.…

Q: name these lines

A: The names of the given lines is given below.

Axial Load

When a bar of the uniform cross-section is acted by a load, such that the load acts along the longitudinal axis of the bar, such kinds of loadings are known as axial loadings. In general terms, a load is an external force acting on a component. An axial load acts perpendicular to the geometric cross-section of the component. Based on the direction of the application of the load, an axial load can be tensile or compressive. The analysis of bodies under the action of axial loads is generally studied under the branch of mechanics, known as statics.