The traffic shows data on speeds and corresponding densities on a section of a rural collector road. If it can assumed that the traffic flow characteristics can be described by the Greenberg's model, develop an appropriate relationship between the speed and flow and their modelled plotted points to be shown in the Q-u diagram. How strong the correlation of the two are? Also determine the capacity of this section of the road. Traffic Data Speed (kph) 60 46 40.8 39.3 35.7 32.6 30.8 28.4 24.7 18.5 Density (Veh/km) 20 32 38 40 45 50 53 57 65 80

Q: Q1: A car depart city A towards city B with linear velocity= 30 km/hr, and another car departs city…

A:

Q: ) REFER TO THE TABLE BELOW TO FIND THE LOWER SPEED LIMIT, HIGHER SPEED LIMIT AND MEDIAN SPEED LIMIT.…

A: To Find :- Lower speed limit Higher speed limit Median speed limit

Q: 99 Under Nath

A: Given:- optimum density for the high-speed freeway data set is assumed to be 40 miles per hour and…

Q: 3(a) A section of a highway highway has a speed-flow relationship of the form: q = av² + bv. It is…

A: i) speed when flow is 1400      veh/hr is     V= 78.98 Km/hr ( uncongested condition)    V= 17.01…

Q: Data obtained from aerial photography showed 8 vehicles on a 356 m-long section of road. Traffic…

A: The given data is shown below:

Q: vay tm= 2.5 seconds (gap) in sQ = 200 vehicles per hour,

A:

Q: The data shown below were obtained by time-lapse photography on a highway. Use regression analysis…

A:

Q: 5) In contrast to the Greenshield's model of traffic flow that considers a linear relationship, the…

A: Given that :-The Greenberg model of traffic flow assumes a non-linear relationship between…

Q: Use the following data to construct a headway distribution curve. If the minimum gap accepted is 3.0…

A: To construct a headway distribution curve, we need to calculate the cumulative distribution function…

Q: We know that q=ku for traffic flow. If we measure speeds and densities at three points within a mile…

A: 6) If we consider 3 points within a mile of a road then we will find that if at a certain point u is…

Q: way sp the Greenshields model, and use it to determine: The mean free flow speed The jam density b.…

A:

Capacity and Level of Service at Intersections

The term capacity is associated with transportation engineering. Capacity helps to understand how many pedestrians or vehicles can be handled by a transport facility. Level of service is also a term associated with transportation engineering. The level of service indicates the performance of the transport facility.