The three Portal Structure Itself is focused on joints A and D and connected with hinges S as seen in the following figure. The evenly distributed load works along AB and DC, the centralized load works on the hinge S, and at the end of the rod E there is also a moment load and a centralized load. 100 kN 25 kN 40 kN.m 22 kN/m, 8m A 1m D. 44 kN/m 6m 4m 4m 2.Calculate the reaction of the focus at S and show the direction of the

Q: A 2. Find the reactions at Pin A and roller B. The beam is 18 feet long, and the two forces are…

A:

Q: 20 KN T 4 m 6 m 30 kN C A 8 m- 40 kN D B 12 kN/m 7m

A:

Q: Determine the reactions at A and B for the steel bar and loading shown, assuming a close fit at both…

A: Given data:- Conditions given-Remove restriction at A and solve for the reactions Below bar figure…

Q: Replace the 21-kN force acting on the steel column by an equivalent force-couple system at point O.…

A:

Q: The A-frame shown supports the 250-N load and 85-N load acting on horizontal member. It is hinged at…

A: To find pin reaction at B, C,D

Q: Situation B. The rigid frame in the figure is subjected to a horizontal load and a vertical load as…

A:

Q: Determinate the horizontal and vertical components of reactions at the pin connections at A, B, and…

A:

Q: Solve for the Reactions at Roller A and Pin B

A: It is required to determine the support reactions.

Q: A propped beam is simply supported at A and foxed at B. It carries a uniform load of 400 KN/m. Point…

A: Step 1:Step 2:Step 3: Step 4:

Q: The Three Portal structure itself is centered at joints A and D and connected with hinges S as seen…

A:

Q: 5 ft A 1 k/ft 4 ft 10 k 4 ft 12 k 4 ft 3 k/ft B

A: A beam is inclined with 5ft vertical and 12 ft horizontal and is supported by a roller at one end…

Q: iii) The structural member below is subjected to a couple moment M and forces F₁ and F₂. Replace…

A:

Q: Find the reactions at pins A, B, C, and D as well as roller E. Members ABC and CDE are continuous…

A: Calculation of reactions at pin A,B,C,D, as well as at roller E of given structure

Q: Replace the loading by a single resultant force, and specify the location of the force measured from…

A: (a) Replace the loading by a single resultant force, and specify the location of the force measured…

Q: Determine the reaction at A and the force in each member of the left half of the truss.

A:

Loads and Reactive Forces

Loads are the external influences that a beam experiences under its working conditions. For instance, a beam may be subjected to shear loads, twisting loads, bending moment, and axial loads during its working conditions. Engineers primarily deal with beams and trusses in the civil engineering domain. Due to the influence of loads, it is very crucial to determine the induced stresses and deformation values. These values give an insight into the critical area of the beam that needs to be worked upon to make it fail-safe.