The three forces shown is to be replaced by a single resultant force. Determine the distance d (in mm) below point A to which the single resultant force must be applied. 100 N 600 mm A 600 mm 160 N 600 mm 240 N

Q: R20

A:

Q: A horizontal curve on a three-lane highway with 12-ft lanes has a PC located at station 10+00 and PT…

A: 3 lane road with 12 ft lanes  = 25o e = 4% or 0.04Clearance distance = 40 ft

Q: QUESTION 5 Which of the following represents the location of the horizontal plastic neutral axis (X,…

A: Solution Find the location of horizontal plastic neutral axis

Q: 400 N 800 N B D E IC F2 m

A: Given  Concentrated loads of 400 N and 800 N are acting at B and D respectively.

Q: Explain a Contact Curve?

A: A contact curve is a mathematical concept that describes the set of points where two curves in a…

Q: can u get the

A:

Q: Define deflection angles.

A: A deflection angle is an angle between the onward extension of the previous leg and the line ahead.…

Q: What is the description of portion "C"? O NE1/4 of the SE1/4 O NW1/4 of the SE1/4 O NW1/4 of the…

A: To describe the position of portion C, the north, south, east, and west directions are indicated in…

Q: What is the type of traverse shown in the picture? (select all that apply) Az Mk (a)

A: Given that:

Q: Identify and circle others Simply Supported Beam and continous Beam at structural drawing

A: To Identify Simply Supported Beam and continuous Beam at structural drawing, other than that which…

Q: Name this force system         Question 19 options:   Non-planar parallel…

A: Given a system of force system

Q: Breaks the selected object .between two points You can create arc or line between two specified…

A: Given- Breaks the selected object .between two points   a) You can create arc or line between two…

Q: The net area in shear, Anv, of the L6x6x3/8 angle shown in the figure is equal to

A: The shear will act parallel to the gusset plate and will be from left end of gusset plate to the…

Q: ] Use graph paper to draw simplified sketch of the gear and the rack shown in problem 5/64(79). What…

A: Figure is as shown

Connections

In steel structures, connections are the members that join two or more steel members. The connections are the most important members of any steel structure, and hence, they are designed more carefully. The majority of the construction cost of steel structures is incurred due to the connections. The design of connections is done as per the recommendations and specifications of the American Institute of Steel Construction (AISC).