The tank of water in Fig. 1 is (12 em) wide into the paper. If the tank is accelerated to the right in rigid-body Motion at 6.0 m/s2, compute (1) the water depth on side AB after movement and (2) the water-pressure force on panel AC. Assume no spilling.

The tank of water in Fig. 1 is (12 em) wide into the paper. If the tank is accelerated to the right in rigid-body Motion at 6.0 m/s2, compute (1) the water depth on side AB after movement and (2) the water-pressure force on panel AC. Assume no spilling.

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: A half parabolic gate 3m in tall and 1m wide is submerged and there are two different liquid on each…

A: Given- hg=3mb=1mGL=0.85GR=1.00

Q: Rx P2 2 F 150 mmø 300 mmø

Q: q3

Q: Q1. Water, assumed frictionless, flows from a large tank and exits through a vertical, constant…

Q: *10-4. If air at a temperature of 100'F flows through the smooth circular duct at 10.5 ft'/s,…

A: Q=AVv=10.5π4×8122=10.8ftsReynolds number :at 100°F ν=…

Q: Gas having an internal pressure of 4 MPa is housed in the 3-meter-high pressure tank below. It…

A: A tensile Stress acting in the direction tangential to circumference is called circumferential or…

Q: A circular door having a diam. of 3m closes a horizontal duct from a small diam. as shown. The…

Q: Q2:B) Calculate the power required to pull (1.5m x 1.5m) flat plate at speed (1 m/s) to the left…

Q: 4ft Locate the center of gravity along the y-axis of the homogeneous "bell-shaped" volume formed by…

Q: = The horizontal wye fitting shown splits the flow of water into two flow rates, in which Q₁ Q₂ +…

A: Q1 = 4 cfs P1 = 20 psiP2 = 19.5 psi

Q: The water level in a tank is 34 ft above the ground. A hose is connnected to the bottom of the tank…

Q: A pump transfers water from a large 0pen tank to another tank above it. At the suction side, the…

A: Frictional losses = 6.4 ft Vapor pressure of water= 0.46psi= 0.46*2.3= 1.06 ft NPSHA = 15 ft

Q: A sprinkler with unequal arms issuing jets of area 0.8 cm² at each end and facing same direction…

Q: 10.83 The steel pipe shown carries water from the main pipe A to the reservoir and is 2 in. in…

Q: 4-75. Water flows into the tank through two pipes. At A the flow is 400 gal/h, and at B it is 200…

Q: The friction factor in valve accounts for: OA. All of the above B. Complete disturbance

A: Following is required answers :

Q: Q4) Panel BC in Figure 3 is circular. Calculate: (4 Marks) A) The hydrostatic force of the water on…

A: step 1-

Q: 1. Water flows through a horizontal, 0.5-m-diameter pipe at a rate of 0.9 m³/s (Figure below). It is…

Q: Compute the magnitude and direction of the resultant acting on the roller. 9N 30N/m 1m 4m 2m 100N/m…

Q: (Bernoulli/continuity) Water flows steadily through the pipe shown in the figure below such that the…

Q: A SDOF system has damping factor of 6.2%. Mass at roof level is 17.5 x 105 kg and is supported by…

Q: R1 50 kN 2m m 20 kN/m 10 kN/m 7m R₂ 40 kN 3 m

Q: 3-116E A 3-ft-diameter vertical cylindrical tank open to the atmosphere contains 1-ft-high water.…

A: Given: Diameter of the cylindrical tank, D = 3 ft Initial height of the water, h0 = 1 ft To find:…

Q: A pump draws water from a 20 cm diam suction pipe and discharges through a 15 cm diam pipe in which…

A: Given,

Q: The pressure at section (2) shown in the figure below is not to fall below 70 psi when the flowrate…

Q: The water is flowing through a P, 39.24 N/cm D, 20 cm Problem 6.4 pipe having diameters 20 cm and 10…

A: Given :

Q: Water flows through the pipe at A at 6 m/s. Determine the pressure at A and the velocity of the…

Q: Q- In a free cylindrical vortex flow, at a point in a fluíd at a radius of 200 mm and at a height of…

A: Given- Radius r1=200 mm=0.20 m, Height Z1=100 mm=0.10 m, Velocity V1=10 m/s, Pressure…

Q: A 30m long, 20mm diameter steel pipe is used to drain an oil tank determine the discharge when the…

Q: The water is flowing through a P, 39.24 N/cm D, 20 cm Problem 6.4 pipe having diameters 20 cm and 10…

Q: The tank of water in Fig. 1 is (12 cm) wide into the paper. If the tank is accelerated to the right…

Q: The pressure of compressed air on water surface in the tank shown in Fig. No. 2 is Pca 981 (KN/m2).…

Q: Q#2 The 5-in diameter water jet as shown in Fig. 2, moving at Reg.No/100 ft/sec, is split so that…

A: Given data in question Diameter Velocity Discharge towards each portion Angle To find out…

Q: solve

A: Given data- Power = 100 hp Flow rate/discharge (Q) = 20 ft³/s Diameter of pipe (d) = 12 in

Q: urrent Attempt in Progress A 1-m³ volume of water is contained in a rigid container. Estimate the…

Q: ntet pump 20 NP SH A. ? static discharge Head static suction head

Q: The water is flowing through a P, 39.24 N/cm D, 20 cm Problem 6.4 pipe having diameters 20 cm and 10…

Concept explainers

Pressurized pipe flow

A 15-kilometer-long pipe with a pipe diameter of one meter transports water at a speed of one meter per second. The pipe has a friction coefficient of 0.005. Calculate the frictional head loss?

Question

A:.9
A docs.google.com
Q 2: *
The tank of water in Fig. 1 is (12 cm) wide into the paper. If the tank
is accelerated to the right in rigid-body Motion at 6.0 m/s2, compute (1)
the water depth on side AB after movement and (2) the water-pressure
force on panel AC. Assume no spilling.
9 cm
Water
ax
Fig-1
24 cm
Option 1
اختيارات الخاصة بالسؤال الثاني يحب : 2 Q
* اختيار اختيارين صحيحة
The water depth = 16.34 cm
The water depth = 14.34 cm
%3D
The water depth = 15.34 cm
%3D
F =25.4 N
F =26.4 N
O F =24.4 N

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

p shown Ex: (Single pipe with pump) Without the pump in Fig. P8.13R it is determined that the flowrate is too small. Determine the horsepower added to the fluid if the pump causes the flowrate to be doubled. Assume the friction factor remains at 0.020 in either case IF for entrance K.-0.5 Water 10 Pump 5 ft D-0.30 ft V (2) -90 ft
Determine the pressure at point C in psi. Determine the pressure at point D in psi. Determine the flow rate in cfs. Determine the velocity at the pipe with 18 inches diameter in ft/s.
nat7
Solve and get an upvote . Please help
*6-8. The nozzle has a diameter of 40 mm. If it discharges water with a velocity of 20 m/s against the fixed blade, determine the force exerted by the water on the blade. The blade divides the water evenly in the vertical plane at an angle of 0 = 45°. 40 mm B
Q6
3-160 A 5-m-long, 4-m-high tank contains 2.5-m-deep water when not in motion and is open to the atmosphere through a vent in the middle. The tank is now accelerated to the right on a level surface at 2 m/s2. Determine the maxi- mum pressure in the tank relative to the atmospheric pressure. Answer: 29.5 kPa 1.5 m 2.5 m Vent Water tank FIGURE P3-160 5 m 2 m/s2
ANSWER ASAP THANKS
Determine vertical support reaction
8.7
A thin 6-ft-wide, right-angle gate with negligible mass is free to pivot about a frictionless hinge at point O, as shown in the figure below. The horizontal portion of the gate covers a 2-ft diameter drain pipe, which contains air at atmospheric pressure. Determine the minimum water depth, h, at which the gate will pivot to allow water to flow into the pipe. Width 6ft- Right-angle gate Hinge 39000 0. 4 ft Water 2ft-diameter pipe