The system shown starts from rest, and each component moves with a constant acceleration. If the relative acceleration of block C with respect to collar B is 60mm/s² upward and the relative acceleration of block D with respect to block A is 110 mm/s? downward, determine (a) the velocity of block C after 3 s, (b) the ch f block D after 5 s. D.

The system shown starts from rest, and each component moves with a constant acceleration. If the relative acceleration of block C with respect to collar B is 60mm/s² upward and the relative acceleration of block D with respect to block A is 110 mm/s? downward, determine (a) the velocity of block C after 3 s, (b) the ch f block D after 5 s. D.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

3. A bomb which is initially at rest explodes into three fragments. Fragment A of known mass ma moves at a known angle of 8 measured clockwise with respect to the positive y-axis with a known speed |val. Fragment B of unknown mass (but let's call it m3 ) moves at a known angle o measured counterclockwise with respect to the negative x-axis with a known speed |is|. A third fragment C of known mass mc moves off along the negative y-axis with an unknown speed (let's call it |vc]). Only the forces between the fragments are significant during the collision. a. Draw a diagram that shows the initial and final states of the bomb fragments. Label the velocity vectors and known angles. b. Define what you would like to include in your system. c. Write a Newton's 2nd Law equation for this system. d. Determine the speed of fragment C and the mass of fragment B in terms of the known quantities.
Activity 3. Two elevators operating in parallel shafts, approach each other from positions which are 120 m apart. The upper car has a downward acceleration of 0.50 m/s, and the lower car is being accelerated upward 1.0 m/s?. When and where will they pass each other if the lower car starts 1 second after the other?
In the mechanism shown, the block B is constrained to move vertically and is attached to the bar BD. The point A on the bar AD is fixed. Express all your answers in the component system shown. At the instant shown, the block B is moving downward at a constant speed of 2.6 ft/s, 9 45°, and 0 = 33°. If I = 14 in. and d = 8 in., determine the angular accelerations of bars AD and BD at this instant. = B a AD a BD = = 8 rad/s² | rad/s²
2. For a short period of time, the motor turns gear A with a constant angular acceleration, starting from rest. The cord is wrapped around pulley D which is rigidly attached to gear B. 2) if the radii are: A = 70 mm, r = 230 mm, and rp = 90 mm, the constant angular acceleration of gear A, AA is 4.4 rad/s², determine the angular acceleration of gear B, CB, in rad/s². Please pay attention: the numbers may change since they are randomized. Your answer must include 2 places after the decimal point. αA A P Your Answer: 1'B Answer -1'p'
8. The motor draws in the cable with an acceleration of 3 m/s2. The beam has a uniform mass of 20 kg/m , and the crate has a mass of 250 kg . Neglect the mass of the motor and pulleys.
The gear starts from rest and the angular position of line OP is given by e = 2t³ – 7t2 where O is in radians and t is in seconds. The magnitude of the total acceleration of point P when t = 2s is: а. 38 2-ft, b. 20 s2 с. 10 s2 32 d.
A test car starts from rest on a horizontal circular track of 115-m radius and increases its speed at a uniform rate to reach 95 km/h in 19 seconds. Determine the magnitude a of the total acceleration of the car 12 seconds after the start.
Knowing that in Figure 1 at the instant shown block A has a velocity of and an acceleration of both directed down the incline, determine (a) the velocity of block B, (b) the acceleration of block B. A spring AB is attached to a support at A and to a collar (Figure 2). The un-stretched length of the spring is l. Knowing that the collar is released from rest at and has an acceleration defined by the relation , determine the velocity of the collar as it passes through point C. [
To speed up the unrolling of a telephone cable the trailer with the reel of cable starts from rest and is given a constant acceleration of 2.1 ft/sec². Simultaneously, the tow truck pulls the free end of the cable horizontally in the opposite direction with a constant acceleration of 3.4 ft/sec². If both vehicles start from rest at the same instant, determine the magnitude of the total acceleration of point A on the forward end of the horizontal reel diameter (a) just as the motion starts and (b) at a time t = 1.5 sec after the start of the motion. 3.4 ft/sec² 1/9 2.7' A 2.1 ft/sec²
A test car starts from rest on a horizontal circular track of 95-m radius and increases its speed at a uniform rate to reach 90 km/h in 19 seconds. Determine the magnitude a of the total acceleration of the car 15 seconds after the start. 95 m
12. For the mechanism shown, collar A slides upward at a constant speed of v = 0.220 m/s. Collar P is free to slide horizontally but has a pin located inside the circular slot, that has a radius of R = 300 mm, which keeps the pin moving in the direction of the slot throughout the motion. a. Calculate the speed of the pin on P when y = 150 mm. b. Determine the magnitude of the acceleration of the pin P. 300
solve for tangential component of the acceleration