The system receives 500 kJ from the cold reservoir and discharges 400 kJ to the hot reservoir while delivering net work to its surroundings in the amount of 100 kJ. There are no other energy transfers between the system and its surroundings. Evaluate the performance of the system using either statement of the second law.

The system receives 500 kJ from the cold reservoir and discharges 400 kJ to the hot reservoir while delivering net work to its surroundings in the amount of 100 kJ. There are no other energy transfers between the system and its surroundings. Evaluate the performance of the system using either statement of the second law.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Determine the work required (in kJ/kg) for a pump that is used to increase the pressure of a liquid water stream from 100 kPa to 1500 kPa isothermally at 20 °C. The specific heat of water (C) is 0.0035 kJ/kg.K. its specific volume is 0.001031 m³/kg and its volume expansivity (B) is 250x10 K
Water is being heated in a close pan on top of a range while being stirred by a paddle wheel. During the process, 30kj of heat are transferred to the water, and 5kj of heat is lost to the surrounding air. The paddle-wheel work amounts to 500 N*m. Determine the final energy of the system if its initial energy is 10kj.
As shown in the figure below, water behind a dam enters an intake pipe at a pressure of 24 psia and velocity of 5 ft/s, flows through a hydraulic turbine-generator, and exits at a point z₁ = 140ft below the intake at 19 psia, 45 ft/s, and a specific volume of 0.01602 ft³/lb. The diameter of the exit pipe is 5 ft and the local acceleration of gravity is 32.2 ft/s². Water Value = $i P₁ = 24 psia V₁ = 5 ft/s Z1 Dam /day Generatori Turbine H P2 = 19 psia 22=0.01602 ft³/lb V₂ = 45 ft/s = 5 ft Evaluating the electricity generated at 8.5 cents per kWh, determine the value of the power produced, in $/day, for operation at steady state and in the absence of internal irreversibilities. Water
A turbine receives steam at 2778.1 kJ/kg enthalpy and then converts it to shaft work. The steam leaves the turbine with 1200 kJ/kg enthalpy. Assuming no losses due to gravity, heat, and friction, determine the power produced in kW if 5 kg/s of steam flows at the inlet
2. Steam expands in a turbine from 4 MPa and 400°C to 50 kPa and 100°C at a rate of 2.3 kg/s. Heat is lost from the turbine at a rate of 58 kJ/s during the process. Find the power output of the turbine.
A closed system undergoes an adiabatic process. During the process, the system operates at the same elevation and is at rest. The system internal energy between its initial and final states increased by 10kJ. Calculate work in this process.
In a steady flow apparatus, a fluid enters with a specific volume of 0.30 m3/kg, a pressure of 540 kPa and a velocity of 25 m/s. The inlet port is 40m above the floor and the outlet port is at the floor level. The fluid exits with a specific volume of 0.82kg/m3, a pressure of 100 kPa and a velocity of 280 m/s. The apparatus produces 140kJ of work per kg of fluid and a 12 kJ/kg of heat loss occurs between the inlet and outlet ports. Determine the amount of change in internal energy in the apparatus in kJ/kg. Is the internal energy increases or decreases?
A gas contained in a vertical cylindrical tank has a volume of 11.12 m3. The gas receives a paddle work of 7.5W for 1hour. If the density of the gas at the initial state is 1.5 kg/m3, determine the specific heat gain or loss if the specific internal energy of the gas increases by 16.2kJ/kg.
A pump rated at 1800 W is used to transfer water from an open tank to another open tank. The surfaces of the two tanks are kept 20 m apart, vertically, while the mass flow of the water is 5 kg/s. Determine the efficiency of the pump
None