The switch has been in position a for a long time. At t=0, the switch moves from position a to position b. The switch is a make-before-break type so there is no interruption of the inductor current.

Q: Type UF cable shall not be used where subject to physical damage. A. True B. False

A: Generated power needs to be distributed to different loads. Cables are used for transferring power…

Q: The concept of the state of a dynamic system refer to a .maximum set of variables The root locus is…

A:

Q: explain insulation coordination and write method of insulation coordination

A: We have to explain insulation coordination and write method of insulation coordination.

Q: A No. 10 AWG copper conductor

A:

Q: Can I use the 66-block in telephone wire distribution to its outlets? How is it distributed?

A: According to the question, we need to explain the 66-block in telephone wire distribution.

Q: Which of the following statement is correct for the indoor substations?

A: A substation in which the contraption is prepared inside the substation building is called indoor…

Q: Vab=C --- ) v (a) 2.5 v (b) - 2.5 v (c) - 10 v (d) 10 V

A: The solution can be achieved as follows.

Q: Can we replace the Fossil Fuels? How?

A: Can we replace the Fossil Fuels? How?

Q: Find % Regulation for the given readings VR(Line to Line ) = 394 Volts, Vs(Line to Line ) = 458 %3D…

A:

Q: A high voltage transmission line transmitting 10 MW of power operates at a voltage of 105 KV…

A:

Q: Attach the proper eve

A:

Q: 4.a. The ___ calculated load is rarely placed on an electrical system. A. optional B. standard C.…

A: An electrical load is a part of a circuit or an electrical component that uses electricity.…

Q: In Aircrafts, why do you think the mechanic held a bucket below the IDG when attempting to service…

A: IDG- It is a Integrated Drive Generator system. It is placed in Aircrafts to control all the engines…

Q: Q4: Write the following compound words in the correct form as (one word, two words, or hyphenated):…

A: AirportFossil fuelCheck-in

Q: Give the other names of depletion region? (At least Two)

A: At the junction of p-type semiconductor and n-type semiconductor, in which there  is neither an…

Q: 5 - What should be done first when a person being electric shocked seen? A) Cut off the electricity…

A: If we seen person being electric shocked then we need to do take some necessary action

Q: 7. Which chapter of the National Electrical Code covers communications systems installations and…

A: In the National Electrical Code chapter 8 , covers the communications systems installations…

Q: Write a paragraph about your hopes and ambitions. In about 100 words

A: Hope and ambitions are the most important part of any human which can include the happiness of…

Q: 3 smallest change in the quantity that will produce the observable change in the reading is called

A: This question is related to instrumentations. It is based on concept of some terms related to…

Q: Define Phase Margin and Gain Margin for continuous and discrete systen

A: Brief idea about phase margin and gain margin

Q: Write information and introduction about UPS

A: An uninterruptible power supply(UPS) is an electrical device which provides emergency power to the…

Q: Consider a group of students that are sifting through a crate with broken or malfunctioning cables,…

A: Cable faults can be found by looking for Ethernet symbol errors on switch and router interfaces.…

Q: Q6) Explain by drawing a block diagram of a power supply?

A: Draw the block diagram of the Regulated power supply.

Q: Discuss as to how you would connect your landline and mobile to the local telephone exchange using…

A: Mobile Telephone Switching Office(MTSO) An operations center that connects the landline PSTN system…

Q: How would you design an 125 ohm microstrip transmission line?

A: Designing a 125 ohm microstrip transmission line involves determining the physical dimensions and…

Q: The information signal is always an analog signal. an analog signal in case of an analog carrier…

A: Given : Information signal is  a) always an analog signal  b) an analog signal in case of an analog…

Q: State the types of transmission lines.

A: Types of transmission lines are as follows  1. Co-axial line 2. Two wire line 3. Optical fiber…

Q: 9. a) When a mobile phone user attempts to make a call ,the cell phone connected to a base station…

A: Part (i):A transceiver is defined as the combination of transmitter and receiver in a single…

Q: Write down three situational questions and behavioral questions each to be asked while interviewing…

A: Write down three situational questions and behavioral questions each to be asked while…

Q: What is the meaning of calculated load?

A: Since many different loads are connected to an electrical supply, it is extremely important to know…

Q: 8: A solar cooker uses hot air to cook food. Select one: True False 19: text _____________ can be…

A: Solar cooker is device that converts direct sunlight to heat, cook food materials.

Q: Leee GH Ia

A:

Q: Briefly discuss the loaded and non-loaded telephone cables

A: Loading is the process to increase inductance of line by adding lumped inductors atpredefined…

Coulomb’s Law

Coulomb's law states that the attraction or repulsion force between two charged things is proportional to the product of their charges and inversely proportional to the square of their distance. It has an effect along the line that connects the two-point charges.