The state of stress at a point is shown on the element. Determine (a) the principal stress and (b) the maximum in-plane shear stress and average normal stress at the point. Specify the orientation of the element in each case. Show the results on each element.

Q: .

A: Find outA. Determine the shear stress component acting on the inclined plane AB. solve the problem…

Q: Determine the magnitude of the maximum shear stress on the stress element for which σx=-87 MPa,…

A:

Q: The internal loadings act on the section. Show the stresses with their directions that each of these…

A:

Q: 4 ksi The state of plane stress at a point is shown on the element. (a) Draw Mohr's circle neatly to…

A:

Q: (e) E = бу 30 MPa Txy 85 MPa Ox 120 MPa = =

A: GivenPart eσx=-120MPaσy=30MPaτxy=85Mpa part fσx=30MPaσy=-80MPaτxy=15Mpa

Q: The state of stress at a point in a member is shown on the element. Solve the problem using the…

A:

Q: The 20 mm diameter rod is subjected to the loads shown. (a) Determine the state of stress at point 4…

A: Diameter, d = 20 mmIt is asked to find the stress at point A and draw the state of stress using…

Q: 4 ksi The state of plane stress at a point is shown on the element. (a) Draw Mohr's circle neatly to…

A:

Q: A point on a thin plate is subjected to the two successive states of stress shown. Determine the…

A: Given: For the first element on the left. σx=85 MPaσy=85 MPaτxy=0θ=-45o For the second element in…

Q: Determine the equivalent state of stress on an element at the same Sig1 point which represents (a)…

A:

Q: 9-74 If the box wrench is subjected to the 50 lb force, determine the principal stresses and maximum…

A:

Q: The solid rod is subjected to the loading shown. Determine the state of stress at point A, and show…

A: Given data: The force in x direction is Fx = 100 kN. The force in y direction is Fy = 10 kN. The…

Q: In each case, the state of stress sx, sy, txy produces normal and shear stress components along…

A: (a) sx'=-5 kPasy'=0τx'y'=8 kPau=20°   The stress along the normal -axis:…

Q: The figure depicts the state of plane stress at a point. Sketch Mohr's circle for stress. Indicate…

A:

Stress transformation

The term stress indicates the measure of internal forces that develop due to an external force's application on an object. When a specific external force is applied to an object, internal stress generates in the material. The value of stress can obtain by taking the ratio of the externally applied force and cross-sectional area of the object. There are different types of stress depending on the type of external force.