the solubility of silver sulfate in water is determined to be 570 mg/100mL based on the given chemical species and parameters contained in the problem, what type of titrimetry is involved? a. direct b. indirect c. residual

the solubility of silver sulfate in water is determined to be 570 mg/100mL based on the given chemical species and parameters contained in the problem, what type of titrimetry is involved? a. direct b. indirect c. residual

Fundamentals Of Analytical Chemistry

9th Edition

ISBN:9781285640686

Author:Skoog

Publisher:Skoog

Chapter21: Potentiometry

Section: Chapter Questions

Problem 21.13QAP

See similar textbooks

Related questions

Q: 44. In which solution will 0.0010 M AgNO3 form a precipitate? a. 2.0x10-7M NaCl (Ksp of…

A: For the precipitation to occur: [Ag+][X-] > Ksp

Q: 48. A solution is 1.0x10-20M CO32-, F-, and PO43- each, and 1.0x10-10M Ca2+(Ksp for the calcium…

A: Рreсiрitаtiоn reасtiоns оссur when саtiоns аnd аniоns in аqueоus sоlutiоn соmbine tо…

Q: Solid Nal is slowly added to a solution that is 0.010 M in Cu* and 0.010 M Ag*. a. Which compound…

A: given that, NaI is added to 0.010 M Cu+ and 0.010 M Ag+

Q: Under the influence of common-ion effect which is a mass-action effect, the correct statement…

Q: Based in the principles of Precipitimetry. Precipitates form when the ions concentrations exceed the…

A: If the product of the ionic concentration higher than ksp,it will form precipitation.

Q: B. Molar Solubility of Calcium Hydroxide in the Presence of a Common Ion Trial 1 Trial 2 Trial 3 1.…

A: 5.) Volume of HCl added is calculated using formula : Volume of HCl added (mL ) = Final buret…

Q: Can serve as an indicator for the argentometric determination of chloride, bromide and cyanide ions…

A: Titration can be defined as a quantitative chemical analysis which is used to determine the…

Q: A silver nitrate soluti on contains 14.77 g of primary standard AGNO3 , in 1.00 L what volume of…

A: Given mass of AgNO3=14.77gvolume of Na2S=50.00 mLMolarity of NO2S=0.01808 M

Q: Will lead(II) chloride (PbCl2) precipitate when 325 mL of a 0.145 M solution of Pb(NO3)2 is added to…

A: 325 mL of 0.145 M PbNO32solution is added to the 185 mL of 0.0425 M NaCl solution.Ksp of PbCl2 is…

Q: In Hinsberg test, dissolution of precipitate is done using 10% KOH and not 10% HCl. Why? Explain in…

A: Hinsberg test: The chemical reactions which used in organic chemistry to distinguish between…

Q: Which of the following combination of two techniques will lead to the LOWEST yield in barium sulfate…

A: >10min digestion time, ashless filter paper.

Q: 28. What is the molar solubility (S) of Ba3(PO4)2 in terms of Ksp? S= a. Ksp 27 Ksp Ksp b. c. d. […

Q: Looking at your solubility results, did the solubility increase, decrease, or stay about the same in…

A: Adding a common ion decreases solubility. Adding a common ion to a dissociation reaction causes the…

Q: Calculate the solubility (g/L) of Pbl2 in 1.0 M Pb(NO3)2 solution. а. 1.4 x 10-8 b. 1.2 x 10-4 C.…

Q: 1. Analysis of a water sample yield the following result: DESCRIPTION Volume of silver nitrate for…

Q: 0.2 g of iron wire is dissolved in acid and then reduction is done using ............... solution.…

A: A reducing agent is one of the reactants of an oxidation-reduction reaction which reduces the other…

Q: In precipitation gravimetry, the particle size is influenced by (Tick all possible answer) A. pH of…

A: It is an analytical technique which is used for the separation and analysis of compounds on the…

Q: Which of the following conditions would lead to an increase in the relative supersaturation of a…

A: In most cases as we increase the temperature solubility will also increase. As compared to room…

Q: This type of analysis implies that the constituent determined was present in very, very low…

Q: 4. What is the Ksp of the salt MX2 (s) if its molar solubility is 1.4 x 10-2 M? a. 1.1 x 10-5 d. 2.0…

Q: Be sure to answer all parts. Solid NaBr is slowly added to a solution that is 0.033 M in Cut and…

A: [Cu+] = 0.033 M [Ag+] = 0.033 M

Q: a. Will silver chloride precipitate from a solution that is 0.010 M AGNO, and 0.010 M NaCl? b. Will…

A: a. We have to tell whether silver chloride will precipitate from a solution that is 0.010 M of AgNO3…

Q: 7. What specific chemicals are used to identify each of the methods? (Volhard's Method, Fajan's…

A: As per the rules only the first question can be answered

Q: AA Learning Learning prod03-cnow-owl.cengagenow.com Login Learning × Online tea... y dr. marlow...…

A: 1.) The balanced equation for the precipitation reaction between ammonium bromide (NH4Br) and silver…

Q: Addition of a dilute hydrochloric acid solution to a saturated solution of barium fluoride would…

A: Effect of adding HCl on the solubility of BaF2 Le chaterlier principle: If a reaction at equilibrium…

Q: Which of the following can be used to determine the turning point in a complexometric titration? A.…

A: In titrations using EDTA for metal cations, complexometric indicator is used to determine when the…

Q: If 2.00 ml of 0.200 M NAOH are added to 1.00 L of 0.100 M CaCl2, will a precipitate form? Ksp…

Q: 5. Give the name of a reagent that you whe precipitate Aso ions as MgwthqASOg- म् 6. Name the…

A: (5) For this precipitation, magnesia mixture reagent is use. This mixture is formed of MgCl2, NH4Cl,…

Q: Suppose that when the saturated solution was generated there was no precipitate observed and the…

A: The point of saturation can only be confirmed when the precipitation occurs in the solution. Hence,…

Q: Write the chemical equations involve in the analysis of group II cations. Guide Question:…

A: Qualitative analysis is used to identify and separate different cations and anions. Group II cations…

Q: In order to adjust the Potassium Permanganate solution, 0.0544g Na2C2O4 was taken and necessary…

Q: Add 0.3 M AgNO3 to each of the cold sample solutions until AgCl is observed to coagulate. Determine…

A: Solutions- Determine the approximate amount of needed AgNO3 by calculating the volume that would be…

Q: 1. Identify the reagent (and its concentration) that is used to confirm the presence of each of the…

A: We’ll answer the first question since the exact one wasn’t specified. Please submit a new question…

Q: The addition of strong acid to a saturated solution of calcium hydroxide causes a decrease in mass…

A: Le Chatelier's Principle - It states that variations to a system's volume, concentration,…

Question

the solubility of silver sulfate in water is determined to be 570 mg/100mL

based on the given chemical species and parameters contained in the problem, what type of titrimetry is involved?

a. direct

b. indirect

c. residual

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Given

VIEW

Answer

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, chemistry and related others by exploring similar questions and additional content below.

Similar questions

4. Analysis of a water sample yield the following result: DESCRIPTION Volume of silver nitrate for sample titration Volume of silver nitrate for blank titration Normality of silver nitrate solution Volume of sample taken Calculate chloride (mg/L as Cl) content of the water sample. DATA 5.6 mL 0.56 mL 0.0154 N 100 ml
17. This type of analysis implies that the constituent determined was present in very, very low concentration. a. Macro analysis b. Semi-macro analysis c. Micro analysis 18. Which of the following does not happen during digestion? The crystals dissolve and re-precipitate under equilibrium conditions. b. Weakly bound water are lost from the precipitates. c. Filterability improves d. None of the choices
7. What specific chemicals are used to identify each of the methods? (Volhard's Method, Fajan's Method. and Mohr's Method) 8. What color reactions are expected at the end of the equivalence point? 9. How does acid-base titration differ from precipitation titration?
A. Separation of Ni²+ and Fe³+ from Zn²+ and Al³+ B. Test for Iron(III) Ion 17b 13b 11 11f C. Test for Nickel Ion E. Test for 17b Zinc Ion 13b D. Test for Aluminum Ion 17b The Next Step 11f To digest the precipitate: to make the precipitate more compact 11f The Experimental Procedure is written for a single reference solution. If you are simul- taneously identifying cations in both a reference solution and a test solution, adjust the procedure accordingly. If the test solution is a sample with an environmental origin, then gravity filter 10-15 mL before beginning the Experimental Procedure. Prepare the hot water bath for use in Parts A and D. 1. Separate the hydroxide precipitates from the amphoteric hydroxides. To 2 mL of the reference solution (in a small test tube) add 10 drops of 6 M NaOH (Caution!) (see Dry Lab 4.A). Centrifuge and save the precipitate. Test for complete precipita- tion (see Dry Lab 4.B) by adding several drops of 6 M NaOH to the supernatant. Decant the…
0.2 g of iron wire is dissolved in acid and then reduction is done using ............... solution. The Fe2+ ion in the obtained solution is titrated to the 0.1 M Ce4+ standard solution. Which of the following is not suitable for the blank above? A. Walden reductant B. Sodium bismuthate C. Tin(II) chloride D. Jones reductive
A 25.0 mL sample of 0.723 M.....
A 1.067g sample of magnesium oxide of 84.736% were treated with 50mL of 1.017 N Sulfuric Acid, and a 5.195mL volume of sodium hydroxide is required in the back titration. 1. What is the equivalent weight consumed by the acidic titrant? A. 5.281 g-meq B. 55.150 g-meq C. 5.723 g-meq D. 50.850 g-meq 2. What is the difference of milliequivalent weight consumed in the reaction? A. 45.127g-meq B. 56.573g-meq C. 50.850g-meq D. 55.150g-meq 3. What is the amount (in mg) of the analyte that is equivalent to 1 milliliter of the tirant at its equivalence point? A. 22.060mg B. 40.680mg C. 44.12mg D. 20.340mg
Can serve as an indicator for the argentometric determination of chloride, bromide and cyanide ions by reacting with silver ion to form a brick-red silver chromate precipitate in thr equivalence point. Sodium Chromate b. Sodium Thiosulfate c. NaCl d. Iodine
What is the main difference between the indicators used for redox titration and other titration methods? a. The true redox indicator responds to a change in potential of the system at the equivalence point. b. The true redox indicator changes color at the equivalence point. c. The true redox indicator responds when a species disappears at the equivalence point. d. The true redox indicator responds when a species is formed at the equivalence point.
Which of the following combination of two techniques will lead to the LOWEST yield in barium sulfate precipitate? a. 10 min digestion time, ordinary filter paper d. >10 min digestion time, ashless filter paper
AA Learning Learning prod03-cnow-owl.cengagenow.com Login Learning × Online tea... y dr. marlow... Member L... 1req 1req Use the References to access important values if needed for this question. The Solubility Product Constant for silver bromide is 3.3 x 10-13 Solid ammonium bromide is slowly added to 75.0 mL of a 0.0663 M silver acetate solution. The concentration of bromide ion required to just initiate precipitation is M.
Choose the answers from the box Please answer 13,14,15