The solid cylinders AB and BC are bonded together at B and are attached to fixed supports at A and C. Knowing that the modulus of rigidity is 3.7E6 psi for aluminum and 5.6E6 psi for brass, determine the maximum shearing stress in cylinder AB And cylinder BC in ksi.

Q: The linkage supports a force of 500 lb and rides along the top and bottom flanges of the crane rail.…

A: In the image, the object of interest is the linkage. We can see that the linkage is supported by a…

Q: The temperature of the cylindrical rod is heated to 45°C which is fixed in between A and C rigid…

A:

Q: Prob. 3.4-6. A magnesium-alloy rod (E = 6.5 x 10 ksi) o × 11 15 x diameter d. 1 in. is encased by a…

A:

Q: s to be made of steel having an ultimate shearing stress of 400 MPa, determine: (a.)The diameter of…

A:

Q: 8 ksi, øy = -4 ks The normal stresses at a point in a steel member are ox 10 ksi. Using E = 29 × 10³…

A: Given data in question  Stresses Elasticity modulus  Poissons ratio To find out  Normal strains

Q: When the normal stresses are at their maximum or minimum values, the shear stresses are zero. We can…

A: 1- Yes when normal stresses are maximum or minimum, then at that element shear stress is zero. 2-…

Q: Knowing that each rod is solid and has a d twist (a) at B, (b) at C. A m - Brass B Aluminum m C 100…

A:

Q: 1 1 Portions of a x-in. square bar have been bent to form the two machine components shown. Knowing…

A: A square section of dimension  in2 is bent into two sectionsSquare sectionDiamond sectionThe…

Q: Part A If the bolt is subjected to a compressive force of P = 21.9 kN, determine the magnitude of…

A: Length of bronze and steel rod is same.The change in length of steel is equal to the change in…

Q: 2- The Tensile stress of AISI 1035 Cold-dra (a) 550 MPa. (b) 500 MPa. (c) 450 MPa.

A: AISI stands for American Iron and Steel Institute- AISI 1035 is a water resistance carbon steel.…

Q: -1000 mm- Weid P -500- 175 1 75 25- 200 150 mm 25 -||-|- 25

A:

Bars

In civil engineering, bars refer to steel reinforcement bars or rebars. These are structural members primarily used for reinforcement purposes in masonry works. A bar is characterized by its cross-sectional area, which is negligible compared to its length. Bars are usually manufactured by steel which is uniform throughout the length, or by meshing multiple steel wires. Other materials of the bar include carbon steel, glass fiber, carbon fiber, and basalt fiber. The reinforcing bars are coated with epoxy resins and other materials to enhance some of their properties including corrosion resistance.