The smallest allowable outer diameter d of the washers is mm.

Q: 213 30 in 1 40 in -20 in-

A:

Q: The tension is 850 lb in cable AB and 950 lb in cable AC. y B 45 in. Wood Floor 40 in. C 60 in. 65…

A:

Q: What are forces on pin C and D

A:

Q: What is the distance between the axles of the two pulleys?

A: Given that: diameter of smaller pulley = 250 mm diameter of larger pulley = 500 mm wrap angle = 120…

Q: What is the maximum magnitude of the bending moment caused by force G? If none, enter zero. Do not…

A: It is required to determine the magnitude of the maximum bending moment by the force G.

Q: Need help on all questions. Please include all units, steps to the problem and information such as…

A:

Q: 3. if you had to lift a truck and had a pole, a rope and a fulcrum, you could do it! A kid could do…

A: for third kind of lever fulcrum lies at one end and object other...

Q: The distance y from the back of the shorter leg to the neutral axis XX is

A:

Q: calculate the hydraulic diameter of a two long flat plates with the measurement of 5 inches distance…

A:

Q: What is the magnitude of the Right Reaction force in pounds?

A: GIVEN: F=1.5 kpis =1500 lbf TO FIND: The reaction on the right side. Rb

Q: Write the equation of the Centroid of an area?

A: The centroid of an area is the center of gravity of that particular area where the entire mass can…

Q: A pulley system is combined with an inclined plane. The pulley system has an IMA of 3, an efficiency…

A: Given data: IMA = 3 The efficiency of the pulley system, ηpulley=96% weight of the box, W = 215 lb…

Q: 1- Draw three views of hexagonal nut for 24 mm diameter bolt according to rough rule dimension.

A: We can answer first question since the exact one is not specified. Please resubmit the question by…

Q: Which is greater in measurement A. Radius B. Diameter C. Chord D. Both b and C

A: Given that,  For a circle , there is a diameter , chord and radius.

Q: Compute the gallons of sealer required to seal a floor 120'x250'. The sealer being used will cover…

A:

Metrology of Screw Threads

Screw threads are a series of ridges having the profile of a helix. This helix profile runs continuously along the length of a uniform solid or a hollow bar of a circular cross-section at periodic intervals. These helix ridges are also formed over a conical bar. These continuous helical ridges are termed threads.