Answered: The signal r(t) consists of the…

The signal r(t) consists of the constant 5 plus a sine of amplitude 10 and frequency 15 rad/sec. If r(t) is sampled at the rate of 20 samples per seconds, what is the value of the 10h sample?

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: If the clock frequency is 2.5 GHz, what is the clock period in microseconds? Can you show the…

Q: What is the 3rd and 5th overtone for a 25MHz signal? Show your solution.

Q: A 100 Hz sinusoid is sampled at thrice the nyquist rate. Then how many samples are obtained in 2sec.

A: Given values are - f=100Hz Given that signal is sampled at thrice of nyquist rate.

Q: The difference between the desired output and actual output of the system at infinite time is called…

A: The difference between actual output and desired output as time (t) tends to infinity is called the…

Q: a coil of copper wire has a resistance of 5.45 at 75C what will be its resistance at 25C?

A: The proportionate change in resistance for each degree of temperature change is known as the…

Q: For the CRO display of a pulse waveform, the time/cm is on 21 ms/cm and the volt/cm switch is on 9…

Q: Complete the following time waveforms:

A: Given y1=(a+b)' When both values of a and b are low then only output will be high otherwise output…

Q: A sinusoidal voltage Vi= 10 sin 2t is passed through fullwave rectifier find the trigonometric…

A: Find the detailed solution in below images

Q: the folding frequency of a sinusoidal signal with sampling rate 30 khz and 6000 samples is

A: Given data Sampling rate of sinusoidal signal (f) = 30 KHz No of samples = 6000

Q: Two AC waveforms are described by the expressions V₁ - 160sin(4000nt) V V₂-70sin(4000xt+)V If V3 is…

A: In this question, we need to determine the resultant voltage V3 and frequency f. We solve this…

Q: Prove that the maximum efficiency occurs when the iron losses are equal to the copper losses…

A: To Prove: Maximum efficiency occurs at, Iron loss = Copper loss Considering the current as a…

Q: I would like to confirm if Dirac Pulse and Unit sample sequence is the same?

A: We need to explain about unit impulseand unit step sequence.

Q: Calculate the reactance of an capacitor of 0.2 uF at a frequency of 100 Hz. Select one: O a. 1061.03…

A: In this we will find capacitive reactance..

Q: 40 50 A V OE OC 41.17 09 09 S000- time Fig. 4 6) The waveform of iz can be expressed as: (1)…

A: It is cosine function with delayed

Q: Find out the period of the given signal x[n]=cos(pi/3)n What will be the unit of the period?

A: The general expression of a discrete-time signal is For the signal to be periodic, the following…

Q: Calculate the temperature when probability is 0.99 and Fermi energy level below energy level by 0.3…

Q: 10 20 10 (a) (c)

A: Average value is the total area under the curve to its Time period If area is under x axis then net…

Q: For the CRO display of a pulse waveform, the time/cm is on 18 ms/cm and the volt/cm switch is on 8…

Q: Determine the period of the digital wave form in Figure t (ms) 1 3 5 7 9 11 13 15 17

A: Digital waveform consists of voltage levels that changes between 0 and 1. The digital waveform is…

Q: For the circuit shown, determine the frequency of the output waveform Vo(t) . RI 1k Vo(t) 555 B1 9V-…

Q: What's the difference between these Sinusoidal Inputs: Half-wave Rectification vs Full-wave…

A: Half wave rectification of sinusoidal wave: The device which performs this rectification is called…

Q: 2. Find the correlation between the two waveforms shown below analytically.

A: Given:

Q: A technician is using a CRO to measure the frequency of a periodic waveform. The CRO's timebase…

A: Given information is shown below:Timebase setting: Horizontal span of one complete cycle: 4…

Q: The carrier frequency is 500 Hz, and the modulating signal is a single- tone sinusoidal signal. The…

Q: I need help creating a graph in Excel for the tables below. It needs to be Vce vs Ic and plots the…

A: The data of is given in 4 different tables. The each table is mainly differ by the average base…

Q: What is the frequency of a signal having a wavelenth of 30 meters? a. 30MHz b. 10MHz c. 80MHz d.…

A: Wave length = 30 meters Frequency = speed of light/ wave length Speed of light= 299,792,458 m/sec

Q: Which one is false A) Piezoelectric sensors are used to measure physiological displacements and…

A: We need to say which of the above answer is false.

Q: .5 times the rise time.

A: It is given that:- A Second order system, Peak timetp=πωn1-η2Rise time tr =π-ϕωn1-η2 tp = 1.5 tr

Q: Explain the following concepts related to sine signals: amplitude (A), phase angle (ϕ), frequency…

A: We need to explain the following for a sinusoidal signals amplitude (A) phase angle (ϕ) frequency…

Q: The rectangular waveform shown below (left figure) is between +20 and -20. What is its rms value?

Q: If the 3rd odd harmonic is 25KHZ, what is the fundamental frequency? a. 125KHz b. 8.33 KHz c. 75KHz…

Q: 11. There is 900 mA of current through a wire with 40 turns. What is the reluctance of the circuit…

A: Given information is shown below:To find:

Q: For the CRO display of a pulse waveform, the time/cm is on 31 ms/cm and the volt/cm switch is on 10…

A: Given Data: time/cm = 31 ms/cm Volt/cm = 10 V/cm width = 8.7 cm height = 4 cm

Q: 10:1 V in ŽRL Given that the peak voltage across RL is equal to 10 V. The root mean square value of…

A: The circuit diagram is shown below: The given full-wave bridge rectifier is centrally tapped.…

Q: Answer the following topic of Convolution 1. Create a low freq sine wave superimposed to a high…

A: Convolution:

Q: The carrier frequency is 600 Hz, and the modulating signal is a single-tone sinusoidal signal. The…

Q: Which of the following its not a dynamic property? Select one a saturation time b, response time c…

A: Saturation time is not a dynamic property. Saturation refers to the point at which…

Q: (a) Vp (b) Vp.P (c) Frequency (d) Period

A: Note :- As per guidelines we are supposed to answer only first 3 sub-parts of a question. So I…

Q: The frequency of the voltage given by the equation e=120 sin754t is:

Q: For the CRO display of a pulse waveform, the time/cm is on 12 s/cm and the volt/cm switch is on 2…

Q: Problem 1 Complete the time diagram below by drawing Q (initially Q = 0) CLK

Q: The relaxation time of mica (o = 10-15 mho/m, &r = 2) is 2.456 hrs 9.82 hrs 7.36 hrs 4.912 hrs

Question

4 Examples
(1) The signal a(t) consists of the constant 5 plus a sine of amplitude 10 and
frequency 15 rad/sec. If r(t) is sampled at the rate of 20 samples per seconds,
what is the value of the 10th sample?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

What is the value of your 3rd even harmonics if the fundamental frequency is 2KHz? a. 6KHz b. 4KHZ c. 8KHz d. 12KHz
Answer correctly with proper explaination, Do not give me wrong answer like earlier
Find the Zth of the circuit below 100 mH a 100 N 247.49 cos (1000t + 45°) V 10 μF 100 mH
an alternating current equation e=280 sin1256t what is the effective value of this signal a) 280 b) 560 c) 140 d) 395,92 e) 98,98 f) 197.96 g) 178.08
The relaxation time of mica (o = 10-15 mho/m, ɛ, = 2) is 4.912 hrs 7.36 hrs 2.456 hrs 9.82 hrs
7- If the sampling period of a 2500 Hz sinusoidal signal is 0.1msec. then the number of samples can be found in time domain is
The pulse voltage waveform displayed on a CRO, is shown in figure given below. Find, (a) Frequency. (b) Magnitude of the pulse. (c) The amplitude. 21 0.5 5 0.2 10 20-(Vicm 5 ms 100 us 50 ms time/om 500 ms 30- 40 50 2s
I(ms) 5 1 9 11 13 15 17 3 Determine the period of the digital waveform. • What is the frequency of the waveform? • Is the pulse waveform periodic or nonperiodic? • Determine the duty cycle of the waveform.
What is the difference between the pins under number 1 and the pins under number 4, and mention when we can use pins under number 1 and when we can use pins under number 4? 1 MADE IN ITALY DIGITAL (PWM-) OO UNO 10 2 ARDUINΟ -3 9. ANALOG IN 8. 6. AS E
Step by step and easy to understand thanks.
The relaxation time of mica (0 = 10-15 mho/m, &r = 3) is 9.82 hrs 2.456 hrs 4.912 hrs 7.36 hrs
The relaxation time of mica (o = 10-15 mho/m, &, = 3) is 2.456 hrs 4.912 hrs 9.82 hrs 7.36 hrs