The ship at A has just started to drill for oll on the ocean floor at a depth of h-4000 ft. Knowing that the top of the 8-in.-diameter steel drill pipe (G-11.2 x 106 psl) rotates through two complete revolutions before the drill bit at B starts to operate, determine the maximum shearing stress caused in the pipe by torsion. The maximum shearing stress caused in the pipe by torsion is ksl.

The ship at A has just started to drill for oll on the ocean floor at a depth of h-4000 ft. Knowing that the top of the 8-in.-diameter steel drill pipe (G-11.2 x 106 psl) rotates through two complete revolutions before the drill bit at B starts to operate, determine the maximum shearing stress caused in the pipe by torsion. The maximum shearing stress caused in the pipe by torsion is ksl.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

1. A drive shaft to the blades of a helicopter transmits 800 kW at 200 rev/min. Neglecting transmission losses; determine the minimum external and internal diameters of the hollow circular section aluminum alloy shaft, when the maximum permissible shear stress in the shaft is limited to 30 MPa. It may be assumed that the external diameter of this shaft is twice its internal diameter. What will be the resulting angle of twist of this shaft over a length of 2 m, given that the modulus of rigidity, C 26900MPA.
For the bronze segment AB, the maximum shearing stress is limited to 8000 psi and for the steel segment BC, it is limited to 12 ksi. Determine the diameters of each segment so that each material will be simultaneously stressed to its permissible limit when a torque T = 12 kip-ft is applied. For bronze, G = 6 × 106 psi and for steel, G = 12 × 106 psi. Bronze Steel B 4 ft 6 ft
Determine the maximum shearing stress in a helical steel spring composed of 20 turns of 20-mm diameter wire on a mean radius of 80 mm when the spring is supporting a load of 2 KN.
The compressed-air tank AB has a 250-mm outside diameter and an 8-mm wall thickness. It is fitted with a collar by which a 40-kN force P is applied at B in the horizontal direction. Knowing that the gage pressure inside the tank is 5 MPa, determine the maximum normal stress and the maximum shearing stress at point K. (Round the final answers to one decimal place.)
The mechanism below consists of a solid shaft with a diameter of 2 in between A and B and a hollow shaft with an outside diameter of 7 in and a thickness of 1/2 in between B and C. A torque T = 3 kip-in is applied as shown at A and two forces, each P = 322 lb, are applied as shown at the ends of the levers connected to Point B. Determine the shear stress that occurs on the exterior of the hollow shaft between B and C. Express answer in nearest whole psi.
The design specifications for the steel shaft AB require that the shaft acquire a strainenergy of 34 N.m as the 2.8 kN.m torque is applied. Using G = 72 GPa, determine(i) the largest inside diameter of the shaft that can be used,(ii) the corresponding maximum shearing stress in the shaft.
please indicate illustration
8. pls answer...
Draw the moh'r circle
Under normal operating conditions, the electric motor exerts a torque of 2.4 kN·m on shaft AB. Each shaft is solid with diameter d 52 mm. In order to reduce the total mass of the assembly, a new design is being considered in which the diameter of shaft BC will be smaller. Determine the smallest diameter of shaft BC for which the maximum value of the shearing stress in the assembly will not be increased. The smallest diameter of shaft BC is mm.