The rope running over two fixed cylinders carries the 4-kg mass at one end. Determine the force P thatmust be applied to the other end to initiate motion. The coefficient of static friction between the rope andthe cylinders is 0.15.50 mm150 mm400 mm4 kgO 64.1 N63.1 N65.1 NO 62.1 N

Answered: Image /qna-images/answer/2046ba3a-03a8-4429-a6bd-fb2775c43988.jpg

Answered: The rope running over two fixed…

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

A 40- kg block is placed on the uniform 10-kg beam, that is supported by the cable, which is attached to the end of the beam. The cable wraps around the pulley, and the cable is connected to the block. If the coefficient of the static friction between the block and the beam is u,-0.6. Neglecting friction forces in the pulley. Determine the maximum distance that the block can be placed from 0 and still remain in eqilibrium. Assume the block will not flip. Distanc Fig. (6) m B Pulley 30 cm
Kindly do it asap and handwritten
A wooden sled supporting a large stone is pulled up the track inclined at 15ᵒ with the horizontal. The combined mass between the sled and the stone is 750 kg and the coefficient of friction between the sled runner and the track is are μs = 0.40 and μk = 0.30. Determine the force P required to: a. start the sled up the track b. keep the sled from moving after it has been started c. to prevent the sled from sliding down.
.
The 449-N force is applied to the 81-kg block, which is stationary before the force is applied. Determine the magnitude and direction of the friction force F exerted by the horizontal surface on the block. The force is positive if to the right, negative if to the left.
The man pushes on the roller with force P through a handle that connects to the central axle of the roller. If the coefficient of static friction between the 49-lb roller and the floor is s = 0.22, determine the maximum force Pthat can be applied to the handle, so that roller rolls on the ground without slipping. Assume the roller to be a uniform cylinder. Please pay attention: the numbers may change since they are randomized. Your answer must include 2 places after the decimal point, and proper unit. Take g = 32.2 ft/s2. 1.5 ft 30° Your Answer: Answer units
The two 200-lb blocks are pushed apart by the 15° wedges of negligible weight.The angle of static friction is 12° at all contact surfaces.Determine the force P required to start the blocks moving.
The man pushes on the roller with force P through a handle that connects to the central axle of the roller. If the coefficient of static friction between the 43-lb roller and the floor is g = 0.16, determine the maximum force P that can be applied to the handle, so that roller rolls on the ground without slipping. Assume the roller to be a uniform cylinder. Please pay attention: the numbers may change since they are randomized. Your answer must include 2 places after the decimal point, and proper unit. Take g = 32.2 ft/s². Your Answer: Answer 30° units 1.5 ft
For the given set up, the two cylinders on the left and right are movable horizontally, while the cylinder in the middle is fixed. Determine the distance a so that the system is in equilibrium and the tension T2 is equal to 2.5 N and T₁ is equal to 2.0 N. The radius of the three cylinders is equal to 20 mm, while the coefficient of friction between the cylinder and the rope (u) is 0.1529. T₁ T₂ a B
4. The three bars have a weight of WA = 20 lb, WB = 40 lb, and We = 60 lb, respectively. If the coefficients of static friction at the surfaces of contact are as shown, determine the smallest horizontal force P needed to move block A CCB=0.5 BR 0.3 AHAD 0.2 D P
The 89-lb force P is applied to the 200-lb crate, which is stationary before the force is applied. Determine the magnitude and direction of the friction force F exerted by the horizontal surface on the crate. The friction force is positive if to the right, negative if to the left. Assume μ = 0.52, k = 0.40. P Answer: F = i Hs HR lb
Force P is applied to the end of a rope being used to hold the 50-lb block on the 20° incline. The coefficient of static friction between the block and the incline is u. = 0.30. Determine the largest value of P for which the block is in equilibrium and will not begin to move up the incline when 0 = 15°. Hs = 0.30 20° The solution to this problem requires a free-body diagram of the block, and a sketch of the coordinate system used. Use the components of the forces with EF = 0 and EF, = 0 to y apply ΣF=0.

SEE MORE QUESTIONS

Recommended textbooks for you

Elements Of Electromagnetics

Mechanical Engineering

ISBN:

9780190698614

Author:

Sadiku, Matthew N. O.

Publisher:

Oxford University Press

Mechanics of Materials (10th Edition)

Mechanical Engineering

ISBN:

9780134319650

Author:

Russell C. Hibbeler

Publisher:

PEARSON

Thermodynamics: An Engineering Approach

Mechanical Engineering

ISBN:

9781259822674

Author:

Yunus A. Cengel Dr., Michael A. Boles

Publisher:

McGraw-Hill Education

Elements Of Electromagnetics

Mechanical Engineering

ISBN:

9780190698614

Author:

Sadiku, Matthew N. O.

Publisher:

Oxford University Press

Mechanics of Materials (10th Edition)

Mechanical Engineering

ISBN:

9780134319650

Author:

Russell C. Hibbeler

Publisher:

PEARSON

Thermodynamics: An Engineering Approach

Mechanical Engineering

ISBN:

9781259822674

Author:

Yunus A. Cengel Dr., Michael A. Boles

Publisher:

McGraw-Hill Education

Control Systems Engineering

Mechanical Engineering

ISBN:

9781118170519

Author:

Norman S. Nise

Publisher:

WILEY

Mechanics of Materials (MindTap Course List)

Mechanical Engineering

ISBN:

9781337093347

Author:

Barry J. Goodno, James M. Gere

Publisher:

Cengage Learning

Engineering Mechanics: Statics

Mechanical Engineering

ISBN:

9781118807330

Author:

James L. Meriam, L. G. Kraige, J. N. Bolton

Publisher:

WILEY

SEE MORE TEXTBOOKS

The rope running over two fixed cylinders carries the 4-kg mass at one end. Determine the force P that must be applied to the other end to initiate motion. The coefficient of static friction between the rope and the cylinders is 0.15.