The rod OA spins in the horizontal plane at theta=0.36t3 radians, while collar B slides outward along OA at r=21t2 mm. If t is in seconds in both examples, calculate the magnitude of the collar's acceleration (mm/s2) when it is 96 mm from O. Only the final answer stated in three decimal places is rounded off.

Q: When the gear makes 29 revolutions, it reaches an angular velocity of w = 20 rad/s, starting from…

A: The number of revolutions,(n)=29 rev. Final angular velocity of the gear,(ωf)=20 rad/s Determine the…

Q: 4. Figure 3 shows a bar AB with rollers on both ends sliding down a wall and sloped ground. At a…

A:

Q: Using cylindrical components, a. Determine the cylinders's radial and transverse components of…

A:

Q: The y-coordinate of a particle in curvilinear motion is given by y = 9.6t3 - 7.7t, where y is in…

A:

Q: The angular velocity of the bar for the position shown is 120rpm but its angular acceleration is…

A: Since in the given question it can be seen that the slider is also moving with some linear velocity…

Q: The y-coordinate of a particle in curvilinear motion is given by y = 5.2t3 -2.6t, where y is in…

A:

Q: Shown below is a power hacksaw. At this instant, the electric motor rotates counterclockwise and…

A:

Q: The z-y coordinate system is body fixed with respect to the bar. The angle 0 (in radians) is given…

A:

Q: e y-coordinate of a particle in curvilinear motion is given by y = 2.0t3 - 8.1t, where y is in…

A: Given:y=2.0t3-8.1tax=2.4t in/sec2ux=5 in/sect=2.4 sec

Q: For the following mechanism, rod AB is pinned to the two disks at point A and point B, and the two…

A:

Q: The y-coordinate of a particle in curvilinear motion is given by y = 10.5t³ -9.2t, where y is in…

A: Given data: y=10.5t3-9.2tax=5.7t in/s2vx=9.7 in/s                at t=0 sec Need to determine the…

Q: 1. The center O of the disk has the velocity and acceleration as shown in the figure. If the disk…

A: The relative velocity and relative acceleration approach is used to answer the given question.

Q: celer turns with it. P A

A: Given-Information:-To-Determine:-

Q: The x-coordinate of a particle in curvilinear motion is given by x = 3.8t³ - 2.6t where x is in feet…

A: Given:x=3.8t3-2.6tay=3.9tuy=5.2 ft/st=5.3 sec

Q: For the mechanism below, at this instant, angle = 41 rod BC has angular velocity W = 4.0 rad/s, and…

A: Givendata: θ=41°ω=4.0 rad/sα=2.0 rad/s2

Q: QI. Use the graphical method only, find the velocity of the piston for the system shown below and…

A: Graphical Method Means We Will Use Instantaneous Center Method. Number Of Instantaneous Center Is…

Q: The piston of the hydraulic cylinder gives pin A a constant velocity v = 2.1 ft/sec in the direction…

A:

Q: ft/sec Vp =t sin i+ cos

A: Calculated acceleration at t= 2 second.

Q: A7: Rod AB has the angular motion which is shown in Figure 7. Determine the acceleration of the…

A: Rod AB has the angular motion which is shown in Figure 7. Using Graphical Method (with appropriate…

Q: A wheel rotates for 5 seconds with a constant angular acceleration and describes during this time…

A:

Q: At the instant shown, car A is traveling at a constant speed of va = 55 mph. At the instant shown,…

A:

Q: 1. Shown below is a power hacksaw. At this instant, the electric motor rotates counterclockwise and…

A:

Q: The x-coordinate of a particle in curvilinear motion is given by x= 4.8t³-2.7t where x is in feet…

A:

Q: The linkage shown consists of 2 sliders, 1 bar, and a plate. The velocities of A and C are given to…

A:

Q: The disk shown in the figure rotates, at the instant shown, with a clockwise angular velocity of 40…

A: Given:ω=40 rad/sα=-5 rad/s2

Q: At the instant shown, car A is traveling at a constant speed of 4= 60 mph. At the instant shown, car…

A: “Since you have posted a question with multiple sub-parts, we will provide the solution only to the…

Q: The x-coordinate of a particle in curvilinear motion is given by x = 3.8t3 - 3.9t where x is in feet…

A:

Q: 10sqrt(2) ms ². Calculate the angular acceleration, in rad/s², of the connecting bar when theta = 45…

A: Length of slider L = 2mVelocity of slider V = 10 m/sAcceleration of slider a = 10 sqrt( 2) m/s2Find…

Q: The gear A on the drive shaft of an outboard motor has a radius of ½ inch while the meshed pinion…

A: Write the given data. rA=0.5 inrB=1.25 inαA=200 rad/s2t=3 s

Q: When block B is resting on the surface, pulley A is rotating at a constant angular acceleration αA =…

A: The angular acceleration of pulley A is .The distance is .The initial velocity of block B is .

Q: For the following mechanism, rod AB is pinned to the two disks at point A and point B, and the two…

A:

Q: 1- A particle moves along the x axis. Its position varies with time according to the expression…

A:

Q: The y-coordinate of a particle in curvilinear motion is given by y = 9.0t³ - 13.3t, where y is in…

A: Write the given data. y=9t3-13.3tax=4.3tv0,x=12.1 in/st=3.2 s   Consider the expression of y and…

Q: 5. Two cars are traveling around a circular track as shown below. Answer the following questions. a.…

A: “Since you have posted multiple questions, we will provide the solution only to the first question…

Q: In the system  on the picture the bigger wheel is not moving, the smaller wheel is connected to the…

A:

Q: The y-coordinate of a particle in curvilinear motion is given by y = 11.6t3 - 9.1t, where y is in…

A:

Q: The y-coordinate of a particle in curvilinear motion is given by y = 4.5t3 - 5.9t, where y is in…

A: Giveny=4.5t3-5.9twhen t=0ax=9.6tVx=12.9 in/st=1.4s

Conservation of Energy

In physics, the rule of the conservation of energy states that energy doesn’t disappear from the atmosphere; instead, it changes its form from one type to another. Energy is one of the most important physical quantities in nature, and it cannot be created or destroyed — only transformed.