The robot moves the particle A (mass M) in the vertical plane using polar coordinate formulas r(t) = 1,2-0,6sin(2πt) [m] θ(t) = 0,5-1,5cos(2πt) [rad] in accordance with. Determine the angular position θ of the arm at time t0 = 1.9 s Use radians in the calculations, but GIVE ANSWER TO THIS QUESTION IN DEGREES !! GIVE ANSWER TO THREE DECIMALS

The robot moves the particle A (mass M) in the vertical plane using polar coordinate formulas r(t) = 1,2-0,6sin(2πt) [m] θ(t) = 0,5-1,5cos(2πt) [rad] in accordance with. Determine the angular position θ of the arm at time t0 = 1.9 s Use radians in the calculations, but GIVE ANSWER TO THIS QUESTION IN DEGREES !! GIVE ANSWER TO THREE DECIMALS

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

9
Advanced Applied Mathematics - Circular Motion 1. When an airplane touches down at 1 = 0, a stationary wheel is subjected to a constant angu- lar acceleration a = 110 rad/s until / = 1 s. (a) What is the wheel's angular velocity at t = 1 s? (b) At 1 = 0, the angle 0 = 0. Determine 9 in radians and in revolutions at / = 1 s. 2. A small box B of mass mkg is placed on a rough horizontal rotating disc. B is metres from the centre of rotation as shown in Fig. 1 below. The coefficient of friction between the disc and B is u. Find, in terms of u, r and g, the maximum speed v that can be given to B without it slipping. 3. One end of a light inextensible string of length L metres is attached to a fixed point C. A small brass hall Ro
I need help with this question please. thank you
A man is about to throw a stone by rotating his fully extended arm. If the stone moves at v = 2 due to the motion of his arm, what is the angular velocity for the stone if the man's arm is 550 mm long? т
Please make it simple. Ans around 7.8rad/s [not sure]
A wheel in fixed axis rotation spins at 300 rpm and decelerates at α = 3 rad/s2. How long does it take for the wheel to come to a complete stop?
The position of the EOAT (gripper hand) of the SCARA Robot in Robotics Factory in BGSU can be expressed by cylindrical coordinate system. Mechatronics student wrote a code that moves the EOAT from position P1 into position P2 at constant angular velocity of 2rad/s. The path generated between these two points, measured from base of the robot follow radial path r = cos m. Calculate the velocity magnitude of EOAT at 0 = 30°. A) 1 m/s B) 2 m/s C)2cos30 m/s D) None of the above.
In the system on the picture the bigger wheel is not moving, the smaller wheel is connected to the center of the bigger wheel with the rod and it can rotate around the bigger wheel. the smaller wheel starts its movement with angular acceleration ε=10rad/s^2. find the acceleration of point B (marked in a drawing) after 1 full rotation. The radius of the bigger wheel is equal to 0,3m. The radius of the smaller wheel is equal to 0,1m.
The piston of the hydraulic cylinder gives pin A a constant velocity v = 3 [ in the direction shown for an interval of its motion. For the shown instant where 0 = 60°, solve the following: (a) Draw the polar unit vectors at the current location of the pin. (b) Determine the values of r, 0,7 and Ö where r = OA
topic: Space Coordinates & Relative MotionI need the Answer ASAP please, thank you.
The rod AB has a mass of 36 kg and a length of 1.9m. The spring is unstretched when 0- 45°. The spring constant k is 226 N/m. B Find the angular velocity of rod AB at 0 - 0. if the rod is released from rest when 0. 45°. Give your answer with 2 decimals.
Find the angular velocity and angular acceleration of the wheel according to the values given in the motion of the system seen at this position.