The rigid beam ABC is supported by a pin connection at C and by steel rod (1), which has a diameter of 12 mm. If the normal stress in rod (1) must not exceed 225 MPa, what is the maximum uniformly distributed load w that may be applied to beam ABC? Use dimensions of a = 350 mm, b = 700 mm, and c = 525.0 mm. Dota A Answer: W = ↓↓ a i 1 B W b (1) ↓↓ kN/m 9

Q: Q1) (A) Two solid circular cross-section bar as shown in the Figure. If the stress in left portion…

A: Given figure  A)given data  left portion =  150 MN/m² total elongation of the bar =  0.2mm. Young's…

Q: ented ass shown. Determine the stress at point would the stress be at point A if the couple M is o…

A: find the principal axis ;average moment of inertia ,  corresponding to the point E  substitute…

Q: 4 - A rectangular block is loaded with a 180 kN axial force and a moment M, as shown in the figure.…

A: Given data:-  Axial force =180 kN the maximum allowable tensile stress = 50 MPa To find:- the…

Q: Q3) a) Draw the free-body diagram for beam shown in the figure and determine the internal normal…

A:

Q: A simple pin connected truss is loaded and supported as shown. The truss is constructed from three…

A:

Q: A hemp rope L = 10 m long and d = 46 mm in diameter is supported from one of the roof beams in a 50…

A:

Q: A simply supported T-shaped beam of 6m in length has to be designed to carry an inclined central…

A: W = 448.6NExplanation:Step 1: Solve for the location of the centroid and moment of inertia. Step 2:…

Q: Problem 2: A concentrated load P=36 kN is applied to the upper end of a pipe. The outside diameter…

A: Given data: concentrated loadP=36 kNoutside diameter of pipeD=220 mminside diameter of piped=200 mm…

Q: Q1) Three bars AB, CD and ED are used to support ACE beam. The three bares have modulus of…

A: We need to calculate the normal stress in each bar

Q: A simply supported hollow cylinder beam is subjected to a uniform load w of 2700 N/m, and an inner…

A:

Q: What is the maximum length of a uniformly loaded, simply supported beam based on the maximum…

A: The given information in the problem is shown in the following attached image:

Q: a vertical hollow circular shaft of aluminum shown below fixed at the top has a load P equal to…

A:

Q: A simply supported reinforced concrete beam carries a uniformly distributed load of 2 kN/m on a span…

A: The uniformly distributed load is w=12 kN/m. The length of the span is L=4 m. The modulus of…

Combined Loading

Any functioning component, such as machine parts, structural members, pressure vessels, and so on, are all under the influence of more than one force. When anybody is under the influence of more than one force such as shear forces, bending moments, axial forces, torsion, and so on, then such body is said to be under combined loading. A very practical example of combined loading is the crankshaft of an internal combustion engine (IC engine). The crankshaft of the IC engine is under high rpm, which is caused due to the torsional forces. Due to the presence of piston, counterbalances, and internal imbalances, the crankshaft experiences lateral forces and due to the rise in temperature, the crankshaft undergoes thermal expansion, which pulls the crankshaft along the axial direction and lateral direction. The presence of unbalanced loads along the periphery of the crankshaft also induces a bending moment.