The results of the analysis for two methods are shown in the table: 1,2 1,54 1,95 2 1,7 A B 1,56 1,77 1,6 1,85 1,67 Indicate if there are significant differences (P = 0.05) between the means of the concentrations obtained by each method. Data: F4.4(tabulated, 2-tailed, P = 0.05) = 9.605, F4.4(tabulated, 1-tailed, P = 0.05) = 6.388

The results of the analysis for two methods are shown in the table: 1,2 1,54 1,95 2 1,7 A B 1,56 1,77 1,6 1,85 1,67 Indicate if there are significant differences (P = 0.05) between the means of the concentrations obtained by each method. Data: F4.4(tabulated, 2-tailed, P = 0.05) = 9.605, F4.4(tabulated, 1-tailed, P = 0.05) = 6.388

Chemistry

10th Edition

ISBN:9781305957404

Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Chapter1: Chemical Foundations

Section: Chapter Questions

Problem 1RQ: Define and explain the differences between the following terms. a. law and theory b. theory and...

See similar textbooks

Similar questions

a dilution is needed to prepare a standard of 10 mg Zn/L from 0.5g Zn/L. To carry out the dilution we have the following available bulb pipettes: 1ml,2ml,5ml,10ml,20ml and 25 ml and the following volumetric flask: 50ml,100ml,250ml,500ml. which bulb pipette and which corresponding volumetric flask you would choose to carry out the dilution?
Introductlon In Part (a) of this experiment you will prepare a primary standard. Potassium hydrogen phthalate (KHP) is a monoprotic acid with the formula KHC,H.O. In this experiment KHP is used as the primary standard. A standard solution is one whose solute concentration is accurately known. If a solute can be obtained in a very pure, stable, weighable form, a primary standard solution of it can be prepared directly. You will then use the standardized sodium hydroxide solution to determine the acetic acid content of a dilute unknown solution. Procedure (0) Preparation of a Primory Standard Potassium hydrogen phthalate (KHP) is a primary standard. Weigh accurately by difference, approximately 0.8 g of KHP in a clean, dry weighing bottle and transfer it into a 250 ml conical flask. Add 75 ml of distilled water. Swirl gently. Cover the flask and leave to dissolve, swirling periodicaly. Cautlon: KHP is not highly soluble and care must be taken to ensure it is all dissolved before you…
I have set up my spreadsheet and was able to reproduce the result with a pKa of 4.64. TRUE OR FALSE
Thank you, but the answer is not accepted by the platform when I input it, I have tried calculating it but I get the same answer. What could be wrong?
3.) The following Beer's Law calibration plot was collected at 391.9 nm using the five mixtures listed above. The trendline equation was y = 4617.1x. A saturated solution of lead(II) chromate had an absorbance of 0.0025. Calculate its solubility, in molarity. Molar Solubility of PbCrO4: x 107 M ABSORBANCE VS CHROMATE CONCENTRATION AT 391.9 NM 1.40 1.20 y = 4617.1x R-0.9972 1.00 0.80 0.60 0.40 0.20 0.00 C 0.00005 0.0001 0.00015 0.0002 0.00025 0.0003 Chromate concentration (mol.L)
VIII. A primary standard of HCI is sodium carbonate, Na2CO3. A measured mass of solid Na2CO3, mNa2CO3' in grams, is dissolved in water and then titrated with HCI solution using methyl 2 NaCl + CO2 + H2O. orange indicator. The reaction is: Na2CO3 + 2 HCI- Complete the following formulas using the context described above: MHCI × VHCI in mL at the methyl orange endpoint = mNa2CO3 × ( )= mol of Na2CO3 mol of Na2CO3 X (— ( - - )= mol of HCl
A solution contains 0.10 M Sr(NO3)₂ and 0.20 M Bi(NO₂). When solid Na AsO is added to the solution a precipitate forms. What concentration of AsO ³ maintains maximum separation of Sr²+ and Bi³+? Ksp of Sr₂(AsO₂)₂ = 4.29 x 10-1⁹ and BIASO = 4.43 x 10-1⁰ 4 4/2
A spectrometry method was applied to determine component A in solution. The result is shown in the table. Supposing an unknown sample gives result of 525, 536, 529, please calculate the concentration of A in the sample. \table [[C (u),0.00, 1.00, 2.00, 4.00, 8.00, 16.00], [1, 1.2, 110, 216, 445,869, 1750]] A m J c 1) A spectrometry method was applied to determine component A in solution. The result is shown in the table. Supposing an unknown sample gives result of 525, 536, 529, please calculate the concentration of A in the sample. CA (ug/ml) 0.00 1.00 2.00 4.00 8.00 16.00 I 1.2 110 216 445 869 1750