The resistors in the following circuit have a value of R1=R2=R3=120, the emf has a value of 16V, and the capacitor has a value of 24 µF. The capacitor is initially uncharged when the switch is closed at t=0 sec.Part B- at t=0 sec, what is the current through R3 or C? PartD D- If now the capacitor is replaced by an inductor, which is initially uncharged, i.e. IL = 0A, at t=0, what is the voltage over the inductor? Part E- at t=infinity, what is the current through the inducot? Note:- • Do not provide handwritten solution. Maintain accuracy and quality in your answer. Take care of plagiarism. • Answer completely. • You will get up vote for sure.

The resistors in the following circuit have a value of R1=R2=R3=120, the emf has a value of 16V, and the capacitor has a value of 24 µF. The capacitor is initially uncharged when the switch is closed at t=0 sec.Part B- at t=0 sec, what is the current through R3 or C? PartD D- If now the capacitor is replaced by an inductor, which is initially uncharged, i.e. IL = 0A, at t=0, what is the voltage over the inductor? Part E- at t=infinity, what is the current through the inducot? Note:- • Do not provide handwritten solution. Maintain accuracy and quality in your answer. Take care of plagiarism. • Answer completely. • You will get up vote for sure.

Related questions

Q: In the circuit shown in the figure (Figure 1), S1 has been closed for a long enough time so that the…

Q: In (Figure 1), E₂ = 2.0 V. Figure R₁ = 205 &=6V R₂ = 1Ω E₂ R₂ = 40 1 of 1 ▼ Part A Find the current…

Q: The switch is at point a for a long time. What is current through R2 immediately after the switch is…

Q: Figure www 6.0 V 2.0 Ω ww 9.0 V 4.0 Ω < 1 of 1 5.0 Ω www ▼ Part Determine the magnitude of the…

Q: A ΔV = 2.9 V battery loses E = 6.5 J of energy each day (t = 24 hrs) powering a cell phone.…

Q: In the section of circuit below, R1= 11.597 N, R2= 0.870 N, and the voltage difference Va-Vp= 4.000…

Q: A 5.50 m length of 1.9 mm -diameter wire carries a 780 mA current when 23.0 mV is applied to its…

Q: A circuit is constructed with four resistors, one capacitor, one battery and a switch as shown. The…

A: After the switch is closed for a long time, the capacitor is fully charged and it acts as an open…

Q: The circuit shown has a battery and two resistors, with R1 > R2 . Which resistor dissipates the…

Q: R Two uncharged capacitors and a resistor are connected as in the figure. If V = 5V,C = 2200 uF ve R…

Q: A capacitor, resistor, and an open switch are attached in series as seen below. Initially the switch…

Q: Resistor Circuit HA Ez. b Ic R₂ R₁ E2 R3 A circuit consists of four resistors and three power…

Q: Part A Find the current through each resistor using the rules for series and parallel resistors.…

Q: Copy and complete table 6, quoting the values of ‘ln (V)’ to three significant figures. b) Plot a…

Q: A circuit is constructed using two batteries and three resistors. What is the current I2 through…

A: This can be solve by two methods, one is Kirchhoff's Voltage law and other is Nodal Analysis

Q: Switch S in in the figure is closed at time t = 0, to begin charging an initially uncharged…

A: Resistance (R) = 21.2 ohm Capacitance (C) = 17.2μF Let the potential of the battery = V

Q: An ideal emf e = 12 V is wired into a circuit with resistors R1 = 4.0 N and R2 = 8.0 N, as %3D shown…

A: According to Ohm's law, V = I×R where, V = Voltage I = Current R = Resistance Also, equivalent…

Q: R₁ ww www R₂ In the circuit shown above, determine the current through R2 if V1 = 32.6 V, V2 = 24.1…

Q: In the circuit shown, V1= 1.50 V, V2= 2.50 V, R1= 4.00 ohms and R2= 5.00 ohms. What is the current…

Q: Find the current through all three resistors in the circuit of the figure. Be sure to include proper…

Q: The capacitor in an RC circuit (R = 130 , C = 50 μF) is initially uncharged. Part A Find the charge…

A: Given, Resistance, R=130Ω Capacitance, C=50μFC=50×10-6F The time constant for the RC circuit,…

Q: A circuit is constructed using two batteries and three resistors. R, What is the current I2 through…

Q: 4. Determine in the current in each resistor given that R1 = R2 = R3 = 112, the capacitance C = 0.5…

Q: Problem 3: A circuit made up of 6 resistors is shown in the figure, with resistances R1 = 25 Q, R2 =…

A: In the given circuit, We have to determine the equivalent resistance in the given circuit.

Q: In the circuit of (Figure 1), each resistor represents a light bulb. Let Rj = R2 = R3 = R4 = 4.56 N…

A: To find the current in R2, we need to find the total current flowing through the circuit. R4 has…

Q: Switch S in in the figure is closed at time t = 0, to begin charging an initially uncharged…

Q: Problem 4: In the circuit above S is initially open and the capacitors C1 and C2 are initially…

A: All the three parts have been explained in detail. If any doubt please feel free to askExplanation:

Q: A 4500 resistor is connected across a charged 0.810 nF capacitor. The initial current through the…

Q: In (Figure 1), suppose that E64.0 V, R=210.0 and L-0.160 H. With switch S, open, switch S₁ is left…

Q: The capacitor in an RC circuit (R= 100 2. C= 50 uF ) is initially uncharged. Find the charge on the…

Q: In, suppose that & = 50.0 V, R=240.0 2 and L = 0.170 H. With switch S₂ open, switch S₁ is left…

Question

CO
The resistors in the following circuit have a value of R1=R2=R3-120 , the emf has a
value of 16V, and the capacitor has a value of 24 uF. The capacitor is initially uncharged
when the switch is closed at t=0 sec.
R₁
ww
www
R₂
www
M
R3

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1: Determine the given data:

VIEW

Step 2: B) at t=0 sec, what is the current through R3 or C:

VIEW

Step 3: D) At t=0, what is the voltage over the inductor:

VIEW

Step 4: E) at t=infinity, what is the current through the inductor:

VIEW

Solution

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 5 steps with 9 images

SEE SOLUTION Check out a sample Q&A here

Similar questions

Consider the circuit below. The capacitor has a capacitance of 11 mF and starts out uncharged. The switch is closed at time t = 0. @ 2 W V = 12 V F2 R₁ = 20 Diagram Description R₂=402 # 3 a. At time t= 0 (immediately after the switch is closed), what is battery? Hint for (a) At time t= 0, the current from the battery is b. A long time after the switch is closed (and capacitor is fully charged), what is the current flowing out from the battery? Hint for (b) 80 F3 R₂ = 30 A long time after the switch is closed, the current from the battery is c. What is the charge on the capacitor a long time after the switch is closed? Hint for (c) The charge on the capacitor a long time after the switch is closed is E m $ R₁ = 30 F4 R % 5 current flowing out from the F5 T 6 F6 Y A. mC. & 7 AA F7 U * 00 8 DII FB ( 9 8 F9
Item 5 A large capacitor has a charge + q on one plate and -q on the other. At time t = 0, the capacitor is connected in series to two ammeters and a light bulb. Immediately after the circuit is closed, the ammeter connected to the positive plate of the capacitor reads Ip and the ammeter connected to the negative plate of the capacitor reads IN (Figure 1) Each ammeter reads positive if current flows through the circuit in a clockwise direction (from the + to the terminal of the meter). Figure + g(t) +||| q(t) A IN 1 of 1 Correct This is a fundamental result that reflects the law of conservation of charge. In a circuit where all elements are arranged in series, the current is the same through all the elements. Otherwise, the electric charge would, in effect, "accumulate" or "disappear" somewhere in the circuit. Part C In a circuit where all elements are arranged in parallel, the current may be different in different branches. This result is formalized in Kirchhoff's junction law: The…
Question 2 -12 Use the following constants if necessary. Coulomb constant, k = 8.987 x 10° N m2 /C2. Vacuum permitivity, €o = 8.854 x 10 Permeability of vacuum, µo electron, me = 9.10938356 x 10 31 kg. Unless specified otherwise, each symbol carries their usual meaning. For example, µC means micro coulomb F/m. Magnetic 12.566370614356 × 10 H/m. Magnitude of the Charge of one electron, e = -1.60217662 x 10-19 C. Mass of one Ri Rz P E3 Ry ww Ra
The capacitor, C1 = 1.2 pF, in the circuit below begins with no stored charge. At t = 0 seconds, the switch is closed. What is the current (in mA) through the resistor, R1 = 9.1 MQ, at t = 4.2 usec? R1 +12V ww
A = 60 B = 70 C = 170 D = 7
In the circuit shown, the potential difference R, VA = V8 = 16.0 V and the resistance R = R2 = R3 = R4 = 255 2. The arrows for currents IA and Ig indicate the direction of positive current flow. The arrows do not necessarily indicate the direction of the actual current flow at those points. R. R. Determine the current IA. R, 7.94785 IA A Incorrect Determine the current Ig. 7.92695 Ig = A Incorrect
Consider the following RC circuit with a 5 MQ resistor and 1000 nF capacitor in series. The battery provides a potential of 10 V before the switch is closed at time t=0, the capacitor is uncharged. a. what's the time constant? b. what fraction of the final charge Qf is on the capacitor at t=30 s? C. what fraction of the initial current Io is still flowing at t=30 s? E +1
A 4600 resistor is connected across a charged 0.850 nF capacitor. The initial current through the resistor, just after the connection is made, is measured to be 0.241 A. Part A What magnitude of charge was initially on each plate of this capacitor? Express your answer in microcoulombs. V— ΑΣΦ q= Submit Part B t = Request Answer How long after the connection is made will it take before the charge is reduced to of its maximum value? Express your answer in microseconds. V— ΑΣΦ Submit Request Answer μC ? us
Consider following circuit with R1 = 60 Ω, R2 = 18 Ω, R3 = 60 / 10 Ω, R4 = 18/10 Ω and and ξ=18 V d. Write Kirchhoff’s potential difference rule for right loop e. Calculate currents i1 , i2 and i3 ? f. Calculate the potential difference of R2 ? g. Calculate the potential difference of R3 ? h. Calculate the heat dissipation of R2 resistor i. Cross sections through two long conductors of the same length and material, with square crosssections of edge lengths are shown below. Conductor Y fits snugly within conductor X, Rank theresistance of X and Y?
a)What is the current through R1 immediately after the switch S is closed? b) What is the current through R2 after the switch S has been closed for a very long time? Assume that the battery does not go dead.
A 6.00 μF capacitor that is initially uncharged is connected in series with a 4600 resistor and a 507 V emf source with negligible internal resistance. Part D Just after the circuit is completed, what is the current through the resistor? Express your answer in amperes. || ΑΣΦ IR = Submit Part E Vc, VR = Submit A long time after the circuit is completed (after many time constants), what are the voltage drop across the capacitor and across the resistor? Express your answers in volts separated by a comma. Part F Request Answer Q = Submit IVE ΑΣΦ Request Answer ? Request Answer A A long time after the circuit is completed (after many time constants), what is the charge on the capacitor? Express your answer in coulombs. Π ΑΣΦ ? ? V
You connect a battery, resistor, and capacitor as in (Figure 1), where & = 36.0 V, C = 5.00 μF, and R = 140 2. The switch S is closed at t = 0. Figure < 1 of 1 Switch open i=0 q=0 Lowell a b R C Part A When the voltage across the capacitor is 8.00 V, what is the magnitude of the current in the circuit? Express your answer with the appropriate units. LO μA B ? I = Units Submit Request Answer Part B At what time t after the switch is closed is the voltage across the capacitor 8.00 V? Express your answer with the appropriate units. 0 ΜΑ ? t = Value Units Submit Request Answer ☐ Value