Answered: The radius of a certain segment of pipe… | bartleby

Related questions

Question

The radius of a certain segment of pipe is reduced to 85% of its original value due to buildup. At the same time, a thinner reduces the viscosity of the flowing liquid to 90% of its original value. By
what factor must the pressure difference along this segment of the pipe increase in order to maintain the original rate
of liquid flow?

Expert Solution

Step by step

Solved in 4 steps

SEE SOLUTION Check out a sample Q&A here

Blurred answer

Similar questions

A cube of unknown material is 0.200 m on each side and has a mass of 17.6 kg. It is suspended in a vat of honey (densityh=1.42 x 103 kg/m³) so that its top surface is at a depth of 2.00 m below the surface of the honey (see figure-not to scale). What is the magnitude of the buoyant force on the cube from the honey?
volume flow rate and (b) the A M ra. The pressure difference between the two regions is 7.90 x10 Pa. What are (a) the A liquid of density B40 kg/m flows through a horizontal pipe that has a cross-sectional area of 2.90x 10 m in region A and a cross sectional area of 9.30 x 10 12. (a) Number Units Units
A cubical block of wood, 10.0 cm on a side, floats at the interface between oil and water with its lower surface 1.50 cm below the interface. The density of the oil is 790 kg/m3. (a) What is the gauge pressure at the upper face of the block? (b) What is the gauge pressure at the lower face of the block? (c) What are the mass and density of the block? Oil 10.0 Wood cm 10.0 Water cm
A solid block is suspended from a spring scale. If the reading on the scale when the block is completely immersed in water is 25.0 N, and the reading when it is completely immersed in alcohol of density 806 kg/m3 is 25.7 N, what are (a) the block’s volume and (b) its density?
In the figure, a cube of edge length L = 0.633 m and mass 1040 kg is suspended by a rope in an open tank of liquid of density 1.03E+3 kg/m³. Find (a) the magnitude of the total downward force on the top of the cube from the liquid and the atmosphere, assuming atmospheric pressure is 1.00 atm, (b) the magnitude of the total upward force on the bottom of the cube, and (c) the tension in the rope. (d) Calculate the magnitude of the buoyant force on the cube using Archimede's principle. (a) Number 18340.3 (b) Number i 3992.2 (c) Number i 14348.1 (d) Number i 3992.2 Units L N Units N Units Units N N L/2 ◄► ◄►
A spherically shaped balloon has a radius of 11.5 m, and is filled with helium. How much extra mass can a cargo lift,assuming that the skin and the cargo of the balloon have a mass of 800 kg? Neglect the buoyant force on the cargovolume itself.(The density of air is 1.29 kg/m3 and the density of helium is 0.179 kg/m3)
Water has a density of 1500 kg⋅⋅ m-3. One section of a horizontal pipe has a cross-sectional area that is 0.74 times another section. The gauge pressure at the smaller section is 18.5 ××104 Pa, and water flows through the section at a speed of 15.1 m⋅⋅s-1. Calculate the gauge pressure (in ×× 104 Pa) in the wider section of the pipe.
A pumping station uses a Venturi tube to measure the flow rate of gasoline. The density of the gasoline is p = 7.40 x 102 kg/m3, the inlet and outlet tubes, respectively, have a radius of 2.80 cm and 1.40 cm, and the difference in input and output pressure is P, - P, = 1.20 kPa. (a) Find the speed (in m/s) of the gasoline as it leaves the hose. m/s (b) Find the fluid flow rate in cubic meters per second. m3/s