The portable floor crane in the automotive shop is lifting a 350-lb engine. For the position shown compute the magnitude of the force supported by the pin at C and the oil pressure p against the 3.58-in.-diameter piston of the hydraulic-cylinder unit AB. Assume a = 5 in., b = 33 in., c = 17 in., e = 36 in., and 26°. C=? LB p=? Lb/in^2

The portable floor crane in the automotive shop is lifting a 350-lb engine. For the position shown compute the magnitude of the force supported by the pin at C and the oil pressure p against the 3.58-in.-diameter piston of the hydraulic-cylinder unit AB. Assume a = 5 in., b = 33 in., c = 17 in., e = 36 in., and 26°. C=? LB p=? Lb/in^2

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

ASAP dont round off initial values pls, round off only in final ans
A 140 mm height of cylinder of 70 mm diameter is used as a short column and carries a pressure of -100 MPa as shown in below. Knowing that E= 105 GPa and u = 0.34,
The hydraulic press shown in Figure 9 is filled with oil with sp.gr. 0.82. Neglecting the weight of the two pistons, what force F on the handle is required to support the 10 kN weight? 75 mm Ø Hinge 10 kN oil 25 mm | mm| Figure 9 400 mm 25 mm Ø F
The cylindrical tank weights 500 lb. Determine (a) FH, (b) FV, (c) FR and (d) ϴx. Use 2 decimal places in every solved value.
Determine the force P required to (a) raise and (b) lower the 50-kg cylinder at a slow steady speed. The coefficient of friction between the cord and its supporting surfaces is 0.3. Answers: (a) P = (b) P= i i 50 kg N ! N
For the beam and loading shown below, determine the beam deflection at point H. Assume that EI = 6.9 × 104 kN·m2 is constant for the beam; w = 6.4 kN/m, LHA = 3.0 m, LAB = 6.0 m.
just need final answers
The tank shown has one curved surface restraining a body of static fluid with 3.55 kPa air pressure above the fluid and sg = 0.88, with the following dimensions: w = 5.50 m h1 = 2.1 m D1 = 0.85 m Required Compute the magnitude of the resultant force, in kN, to the nearest 100th. Fluid sg = given hl D1
4G. 40 6:51 10 ... 94 Quizzes A transmission tower shown below is subjected to lateral loads as shown. A =3.7 kN, B =4.6 kN, C =6.4 kN Determine the magnitude of the axial force in member EG (in kN). Answer in two decimal places. Numerical values only. Don't indicate units here, just on the submitted solution. A-KN 1.5 m K 1.8 m B-KN 1.8 m C-KN F 1.8 m 2.55 m 2.55 m II
I need the answer as soon as possible