The pin-connected structure consists of a rigid bar ABCD and two axial members. Bar (1) is bronze [E = 116 GPa] with a cross-sectional area of A₁ = 550 mm². Bar (2) is an aluminum alloy [E = 71 GPa] with a cross-sectional area of A2 = 290 mm²2. A concentrated load of P = 62 kN acts on the structure at D. Assume L₁=800 mm., L₂=560 mm., a-590 mm., b=430 mm., and c=1160 mm. Determine: (a) the normal stresses 01, 02 in both bars (1) and (2). (b) the downward deflection vp of point D on the rigid bar.

Q: The compound bar has an assembly shown. AB is steel (E,-200GPaa, =11.7x106/C) BC is brass (Ep =105…

A:

Q: An axial force of 100 kN is applied to the assembly shown by means of rigid end plates. Determine…

A: Given: The axial force is 100 kN. The modulus of elasticity for the brass core is 105 GPa. The…

Q: The rigid bar AD is pinned at A and attached to the bars BC and ED, as shown below. The entire…

A:

Q: f = M * C I Compound stresses O Shear stresses Flexural stresses Torsion stresses

A: Using flexural stress equation

Q: Knowing that each rod is solid and has a d twist (a) at B, (b) at C. A m - Brass B Aluminum m C 100…

A:

Q: Problem 1 A rigid bar AC is loaded and supported as shown. Bar AB and CD are unstressed before the…

A: The given information is as follows:

Bars

In civil engineering, bars refer to steel reinforcement bars or rebars. These are structural members primarily used for reinforcement purposes in masonry works. A bar is characterized by its cross-sectional area, which is negligible compared to its length. Bars are usually manufactured by steel which is uniform throughout the length, or by meshing multiple steel wires. Other materials of the bar include carbon steel, glass fiber, carbon fiber, and basalt fiber. The reinforcing bars are coated with epoxy resins and other materials to enhance some of their properties including corrosion resistance.