The paper of an old map drawn to a scale of 100 m to 1 cm has shrunk so that a line originally 10 cm has now become 9.4 cm. There was also a note on the plan that the survey done with Gunter’s Chain was 10 cm too short. If the area measured now is 65 sq- cm. Find the correct area on the ground in sq- cm and sq- km.? If any data is missing you can assume it yourself

Q: Given the following data of a quadrilateral: ZABC=104°, ZBCD=89°, ZABD=60°, ZACD=53°, and AD=1000 m…

A: To Determine Angle CAD

Q: Fill in the blank

A: In geodetic survey the surface of earth is considered to be curved . This type of survey is very…

Q: Situation 2] A surveyor was tasked to cut off a required area by a line through a given point. In…

A:

Q: what will be maximum error permitted

A:

Q: In the given contour map, what is the elevation of point "F"? A 2200 2287) 2100 Q 2000,

A: Reference : Survey Engineering, Contour maps reading. Given : A contour map with various points and…

Q: Write F if true and T if false. 3. Geophysical Surveys can help identify resources without the need…

A: Asked: To check if the given statement is true of false.   Given statement: Geophysical Surveys can…

Q: ▾ Part A On a map drawn to a scale of 1:1600, contour lines are 0.5 inches apart at a center…

A:

Q: The coordinates of three points A, B, and C in a hydrographic survey are given as shown. A:…

A:

Q: The plan area of an old survey plotted to a scale of 10 m to 1 cm presently measures 82.5 cm². It is…

A:

Q: A parcel of land has been surveyed in the field and the lengths and bearings of the various sides…

A: Given: Required to find: 1. What is the total area included within the traverse in acres. 2. what…

Q: A 30 m chain used for a survey was found to be 30.10 m at the beginning and 30.30 m at the end of…

A: Given- Measured lengths of the chain L1'=30.10 mL2'=30.30 mActaul length L=30 mScale-S=1 cm : 8…

Q: 4. Explain what is mcant by geomctric dimensioning and tolerancing (GDT). Describe the geometric…

A: Tolerances : Tolerances in construction are variations in a dimension, a construction restriction,…

Q: 4.) Figure shows the existing ground levels on a 16m square grid for a plot of land which is to be…

A:

Q: Explain what you mean by "dirty data," and then name at least five (5) distinct potential sources of…

A: Data that is erroneous, incomplete, or otherwise unusable is referred to as dirty data. Biased data:…

Q: The paper of an old map drawn to a scale of 100 m to 1 cm has shrunk, so that a line originally 10…

A: Given: The scale of the map drawn is 100 m to 1 cm. The original length of the line is 10 cm. The…

Q: Using a 30-m tape that is 0.05m too long, the laid-out distance from X to Y is 140.42m. What is the…

A: Let's say nominal length of the tape L = 30m Actual length of the tape L' = (30+0.05) = 30.05 m…

Q: A Geodetic Engineer surveyed a lot and observed the following coordinates of points. POINT A. N =…

A:

Q: The area of the plan of an old survey plotted to a scale of 10 m to 1 cm measures 97.6 sq. cm as…

A: Given- Scale S=10 m to 1 cm, Measured area = 97.6 cm2, Original length = 9.8 cm, It is needed to…

Q: 1. Given in the accompanying tabulation are the observed data for a traverse obtained from a…

A: Convert the given quadrantal bearing to a whole circle bearing:LineDistance,…

Q: A line XY is to be laid out with a 30-m long tape. The length of the line is 357.842m. When compared…

A:

Q: Refer to the figure, calculate the area (DMD) enclosed by the traverse 1, 2, 3 and 4. Tabulate…

A: The given data is: S. No. Line Length Bearing Whole circle Bearing 1. 1-2 15.12 m N44°13'W…

Q: 3. Calculate surface are of the site "ABCDE", if the survey results are: Distance (ft) Right Angle…

A: Make a proper diagram to some scale (roughly). Divide the area into small triangles. find out the…

Q: For all the computed values with decimals, use four (4) digits after the decimal. Given in the…

A:

Q: vorking in groups of four came up with 10 different measurements as follows: 920.45, 921.05, 921.65,…

A: Formula used- Em=Es/nand Es=±0.6745∑V2/(n-1)where Es= probable error in single…

Q: The plan of a survey plotted to a scale of 10 m to 1 cm is reduced in such a way that a line…

A: Scale 1 cm = 10 m 10 cm long line measures 9 cm, Area of reduced plan = 81 cm2, It is needed to find…

Q: The plan area of an old survey plotted to a scale of 10 m to 1 cm presently measures 82.5 cm². It…

A: Given data: The plan area of an old survey plotted to a scale of 10 m to 1 cm presently measure 82.5…

Q: Leveling is the process of determining the elevation of points on, above or below the surface of the…

A:

Q: Show your complete solutions and underline/encirde your Final Answer. Example 9.2. From two…

A: We have to determine the value of coordinate of C as per the given data.

Q: Complete the missing data. Plot the traverse using an appropriate scale. LINE DISTANCE (meter)…

A:

Q: On a 1/4000 scale map, the area of the lake is 8740 mm2. How many acres is the area of the lake…

A: A scale is defined as the ratio that dimension on the plan bears corresponding to the distance on…

Q: The following are the observed values of angles of a triangle in a triangulation survey: A = 87°35'…

A:

Q: What are the proper steps in performing a topographic survey? Make sure that you are specific and…

A: topographic survey : A topographic survey collects information on the land's natural and man-made…

Q: A Geodetic Engineer measures a line AB to be 465.392 m with a tape which is 0.05 m too long compared…

A: We will use the relation, Incorrect length×incorrect tape length= Correct length× correct tape…

Q: 1.10 Describe the steps a land surveyor would need to do when performing a boundary survey.

A: Note:- Hi! Thank you for the question As per the honor code, We’ll answer the first question since…