The overhanging beam ABC of span 5.4 m is constructed of a W360 X 216 rolled-aluminium shape. It carries uniformly distributed load, ω of 35 kN/m and point loads of P1 = 30 kN and P2 = 25 kN. b) Find the maximum shear force and maximum bending moment of the beam. After that, Evaluate factor of safety for the beam shown, if the ultimate normal stress for aluminium is 110 MPa.

Q: Find the maximum stress in the beam if it is fixed at the left end, free at the right end subjected…

A:

Q: A simply supported beam of length 30-in diamater 2-in is supported at A and D, subject to load P at…

A:

Q: Wo d B C kN/m Answer: Wo

A:

Q: 5. The rigid beam rests on two short posts AC and 80 as shown Post AC is made from steel with E-200…

A:

Q: show all steps/solution

A:

Q: A simply supported beam is shown. The maximum bending moment is at B. Use the method of sections to…

A: Given Data: The allowable bending stress for the beam is, σb=24 ksi=24 ksi×144000 lb/ft2ksi=3456000…

Q: Ql: For the simply supported beam shown below, calculate the maximum stresses in the steel and wood…

A: To calculate the N.A. of the section:

Q: A simply supported wood beam of length L = 8 ft carries a concentrated load Pat midspan, as shown.…

A:

Q: A simply supported wood beam with a span of L = 24 ft supports a uniformly distributed load of wo =…

A: Given: The length of the beam, L = 24 ft The intensity of load, wo = 350 lb/ft The maximum bending…

Q: A WT305 x 41 standard steel shape is used to support the loads shown on the beam. The dimensions…

A: Given:Load at point A, Uniform load between point BC, Length AB, Length BC, Length CD, Total length…

Q: AW410 x 60 standard steel shape is used to support the loads shown on the beam in the figure. Assume…

A:

Q: 1.Calculate total deformation 2. Minimum stress of the beam 3.Maximum stress of the beam Question 2…

A:

Q: For the next Beam in Cantiléver; Calculate the Maximum Compressive and Tensile Stresses Due to…

A:

Q: 10c The 9.75 m long beam is simply supported at A and B shown below with a uniformly distributed…

A:

Q: The beam cross-section shown below has 90 kip-ft of bending moment applies to it. calculate the…

A: Bending moment acting the beam is, Consider following given figure.To find:The maximum bending…

Q: A 38-mm-diameter solid steel shaft supports loads PA = 1230 N and Pc = 2170 N, as shown. Assume LAB…

A: Given data:Find:Determine the magnitude and location

Combined Loading

Any functioning component, such as machine parts, structural members, pressure vessels, and so on, are all under the influence of more than one force. When anybody is under the influence of more than one force such as shear forces, bending moments, axial forces, torsion, and so on, then such body is said to be under combined loading. A very practical example of combined loading is the crankshaft of an internal combustion engine (IC engine). The crankshaft of the IC engine is under high rpm, which is caused due to the torsional forces. Due to the presence of piston, counterbalances, and internal imbalances, the crankshaft experiences lateral forces and due to the rise in temperature, the crankshaft undergoes thermal expansion, which pulls the crankshaft along the axial direction and lateral direction. The presence of unbalanced loads along the periphery of the crankshaft also induces a bending moment.