The open tank has a four (4) liquids inside. The absolute pressure at the bottom is 250 kPa and the specific gravity of three (3) liquids oil, water, and mercury is 0.88, 1, and 13.6 respectively. The olive is one (1) of them, determine its specific gravity if the height of four (4) liquids oil, water, olive and mercury is 1.45 m, 2.45 m, 2.8 m, and 0.39 m respectively. And draw the open tank with a consecutive layer of four (4) liquids. Notes: 1. atmospheric pressure is 101.03 kPa 2. Since the tank is open, the atmospheric pressure is included.

The open tank has a four (4) liquids inside. The absolute pressure at the bottom is 250 kPa and the specific gravity of three (3) liquids oil, water, and mercury is 0.88, 1, and 13.6 respectively. The olive is one (1) of them, determine its specific gravity if the height of four (4) liquids oil, water, olive and mercury is 1.45 m, 2.45 m, 2.8 m, and 0.39 m respectively. And draw the open tank with a consecutive layer of four (4) liquids. Notes: 1. atmospheric pressure is 101.03 kPa 2. Since the tank is open, the atmospheric pressure is included.

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

Please indicate the given, assumption and iluustration A steel pipe, 3.5 km long x 80 cm diameter x 1 cm wall thickness, conveys water at the rate of 1.75 m3/s. Determine the increase in pressure when a valve provided at the downstream end of the pipe is closed instantaneously. Consider pipe to be elastic and take bulk modulus of water K = 2x109 N/m2; Modulus of elasticity of steel E = 2x1011 N/m2. After determining the surge of pressure in the pipe, compute the following: A) The Longitudinal Stress of the Pipe in Pascal. B) The Circumferential Stress of the Pipe in Pascal.
Please explain so I can understand
Three liquids given the following properties are poured into the cylindrical container with a diameter of 3 meters and a height of 6 meters. First fluid poured: sg = 1.0 , V = 17.6715 m^3 Second fluid poured: sg = 0.81 , V = 10.6029 m^3 Third fluid poured: sg = 2.94 , V = 7.0686 m^3 Assuming that the container is closed after pouring the fluids and the stable state in the container is reached, determine the pressure at the height of 4-m from the bottom of the tank
Q/ Design the liquid storage tank if water capacity = 725,000 liters and with following specifications:- == fc' 35 Mpa, fy =420 Mpa Water height Hw-2.5m, Soil height H,= 2m, Ground water height Hg=1.5m Water density Yw= 10 kN/m³, Soil density y= 17.5 kN/m³ and 0 =30.
PROBLEM 6 Oil with specific gravity of 0.88 flows through a plpe which changes from 6 In. at section A to 18 In. at section B. Section A Is 12 ft lower than B and the pressures are 13.2 psl and 8.75 psl, respectively. If the flow rate Is 5.17 cfs, determine (a) The velocity (ft/s) at section A. (b) The velocity (ft/s) at section B, (c) The head lost (ft) between the two polnts, and (d) The direction of flow. Is It from A to B or B to A?
Assignment-1: Water fills the vessels shown in the figure below. Specific gravity of manometric liquid is 0.9: (a). Find the difference in pressure intensity at m and n when h = 1.25 m and z = 0.3 m; (b). Instead of water mercury in the vessel and manometric liquid has specific gravity of 1.6; find in the pressure intensity at m and n if h = 0.6 m and z = 1.0 m. ARARA POR nannnnnng
two vertical tanks, one with circular section 3.0m in diameter, the other square section 1.33 x 1.33m are connected by a short tube ( area is 0.725 sq. cm) near bottom.initially, the head of oil in the first tank is 4.0m, while in the second tank the head is 60m. After a quick opening of the tube valves, find the time for the oil surfaces to equalize. Assume the tube properties to be similar to that orifice, with c= 0.78
5-64. A thin rubber tube of 25 mm inside diameter is used to siphon water from the large tank of Figure 5.56. To prevent the tube from collapsing, the pressure inside the tube can not be less than 50% of the pressure outside the tube. Determine the smallest value of h to prevent the siphon from stopping due to collapsing of the tube. 2.5 m 5 m Figure 5.56 System for Exercise 5-64. THANK SUNTETICE Full Michifo Nas s itset SCH
03. Find the pressure difference between A and В Oil RD = 0.8 Water 0.4m 0.2m 0.3m Water 0.4m 0.4m B (a) 1692 Pa (b) 1913 Pa (c) 2141 Pa (d) 2551 Pa
Oil with specific gravity of 0.88 flows through a pipe which changes from 6 in. at section A to 18 in. at section B. Section A is 12 ft lower than B and the pressures are 13.2 psi and 8.75 psi, respectively. If the flow rate is 5.17 cfs, determine (a) The velocity (ft/s) at section A, (b) The velocity (ft/s) at section B, (c) The head lost (ft) between the two points, and (d) The direction of flow. Is it from A to B or B to A?
A). If Liquids A, B and C, in the containers shown, have SG of 0.60, 1.00 and 1.60 respectively. At what elevation (EL. A) will the liquid A stand in each of the piezometer tubes? B). If Liquids A, B and C, in the containers shown, have SG of 0.60, 1.20 and 1.60 respectively. At what elevation (EL. C) will the liquid C stand in each of the piezometer tubes?
A suspended gate that’s able to pivot from the top seperates two liquids. There is a stopper that prevents the gate opening anti-clockwise. The gate has a height of 0.5m. The liquid on the right is three times as dense as the liquid on the left. The liquid on the left has a depth of 0.3m. 1) What is the minimum depth of liquid on the right for the gate to open. 2) Comment on the ability to solve this question if the liquid on the left was 0.5m (filled to the top)