The one end of a hollow square bar whose side is 10 in with 1 in thickness is under a tensile stress 102,500 psi and the other end is connected with a U bracket using a double-pin system. Find the minimum diameter of pin is used according to shear strength. Take the factor of safety as 1.5 and Oal 243 ksi for pin material.

The one end of a hollow square bar whose side is 10 in with 1 in thickness is under a tensile stress 102,500 psi and the other end is connected with a U bracket using a double-pin system. Find the minimum diameter of pin is used according to shear strength. Take the factor of safety as 1.5 and Oal 243 ksi for pin material.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Show that the same rebound can be expected for any position of knob K.
Correct and complete solution
Please give the proper solution don't copy from online sites I will report.
2q A revolving pillar jib cranes can rotate 3600 are provided with stops at the end of the jib to prevent over travel of hoist. Select one: True False
Determine the F.B.D of figure 1
What type of preloading system of ball screws is shown on the figure below? Tension Nut B Nut B Spacer Fao- Nut A Fao Tensile preload Compression Nut B Compressive preload Spacer Screw shaft Spacer Tension Screw shaft Nut A Compression Nut, A
Question 1: A team of engineers from the Department of Mechanical Engineering are task to design a hoist equipment using a reverted epicyclic gear train shown in Figure 1. The drum must be keyed at the centre of the arm E using the same shaft. The pinion gear A is keyed to a second shaft which carries a chain wheel. Whereas the chain must be operated by hand. The two shafts have common axis but can rotate independently. The gear wheels B and C are compound and rotate together on a pin carried at the end of arm E. The gear wheel D has internal teeth and is fixed to the outer casing of the block so that it does not rotate. The wheels A and B have 16 and 36 teeth, respectively, with a module of 3 mm. The wheels C and D have a module of 4 mm. D- B E A- Figure 1: Top view of a reverted epicyclic gear train. 1.1. Draw the side view layout of the gear system to be designed. Clearly indicate the positions of all components. 1.2. Determine the number of teeth of wheel D. 1.3. Make use of the…
Identify atleast 10 work holding or clamping devices and their use.
If the deflections of the drive belt of a lathe machine exceeds 8 mm tensioners are used for adjusting. Select one: True False
Radial load which acts on a gear tooth is the a. considerable load. b. horizontal component of normal load. c. vertical component of normal load. d. both a & c. Clear my choice
(8) A 5,000-lb gearbox is provided w/ a steel eyebolt for use of moving it. What should be the size of the eyebolt: (a) if UNC type is to be used? (b) if UNF type is to be used?
A hollow square tube connected with a U bracket using a double-pin system.-Draw the defined shape.