The mutual inductance between two coils is 3.25 mH. A changing current in the primary coil resulted in a current of 5.45 mA in a nearby secondary coil with a resistance of 9.0 Ω. What is the rate of change in the primary current?

The mutual inductance between two coils is 3.25 mH. A changing current in the primary coil resulted in a current of 5.45 mA in a nearby secondary coil with a resistance of 9.0 Ω. What is the rate of change in the primary current?

Physics for Scientists and Engineers with Modern Physics

10th Edition

ISBN:9781337553292

Author:Raymond A. Serway, John W. Jewett

Publisher:Raymond A. Serway, John W. Jewett

Chapter31: Inductance

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: The current in a coil drops from 3.5 A to 2.0 A in 0.50 s. If the average emf induced in the coil is…

Q: What inductance would be needed to store 1.0 kWh of energy in a coil carrying a 200 A current? (1…

A: Given in question : Energy stored in the inductor (E) = 1 KWh = 3.6 x 106 J Current in the coil (I)…

Q: The terminal voltage of a 2-H inductor is v=10(1-t) V. Find the energy stored in it at t=4s. Assume…

Q: The coil in an AC generator consists of 8 turns of wire, each of area A = 0.090 0 m2, and the total…

A: Given Data The number of turns N = 8. The area coil is A = 0.09 m2. The total resistance of the wire…

Q: An inductor that has an inductance of 15.0 H and a resistance of 30.0 Q is connected across a 100-V…

A: An RL circuit is made by connecting a resistor and an inductor in series or in parallel. The…

Q: What is the inductance of a coil in which the average emf induced is 21V when the current in the…

Q: A conducting coil, with current i(t) = 4.00e-0.0250t sin(120at), with i in amperes and t in seconds,…

Q: When the 20.0 A current through an inductor is turned off in 1.50 ms, an 800 V emf is induced,…

Q: A transformer has Np = 500 turns on the primary coil and Ns = 60 turns on the primary coil…

A: The number of turns in secondary winding should always be less than the number of turns in the…

Q: Current in a circuit falls from 5.0 A to 0.0 A in 0.1 s. If an average emf of

A: Given: The initial current is 5.0 A. The final current is 0.0 A. The time is…

Q: What is the inductance of a coil if it produces an emf of 8.46V when the current in it changes from…

A: Given: Current ranges from -28.3 mA to 33.2 mA emf is 8.46 V

Q: a circuit having an inductance of L=2mH has a current that varies with time as I=t^3e^-t. find the…

A: Emf induced can be given by, ∈=LdIdt where L is inductance and I is current and t is time. To be…

Q: One billiard ball is shot east at 2.5 m/s. A second, identical billiard ball is shot west at 1.2 m/s…

Q: A toroid has 250 turns, a cross-sectional area of 5.5 x 10 - 4 m2, and a mean radius of 0.025 m.…

Q: The current in a coil drops from 3.8 A to 1.8 A in 0.51 s. If the average emf induced in the coil is…

Q: ull speed, and it draws 2.0 Aw s 10 02. The motor operates at

A: Given: V=120 V I =0.5 A Resistance can be 10 ohm

Q: What inductance would be needed to stor 1.0 kWh of energy in a coil carrying a 200 A current (1…

A: Inductance is the tendency of an electrical conductor to oppose a change in the electric current…

Q: EMF of 0.218V is induced in a coil when the current in a second coil is changing at a rate of…

Q: A coil has 3.45 Ω resistance and 450 mH inductance. If the current is 3.92 A and is increasing at a…

A: The equation for the potential difference across the coil can be given by the equation

Q: A coil of wire with a resistance of 0.15 Ω has a self-inductance of 0.083 H. If a 5.0-V battery is…

Q: A 10-turn ideal solenoid has an inductance of 7.0 mH. When the solenoid carries a current that is…

Q: A thin wire is tightly wrapped around a dowel (a wooden cylinder of radius 5.49 cm, length 0.28 m)…

A: Given that:Cylinder radius, r=5.49 cm or 0.0549 mCylinder length, l=0.28 mTurns in each layer,…

Q: During a 74-ms interval, a change in the current in a primary coil occurs. This change leads to the…

Q: A 1.61 H inductor and a 19.8 ohm resistor are connected in series and the circuit is connected to a…

Q: A direct current of 25A creates a flux of 1.4 X 10-4 Wb in a coil of 500 turns. What is the…

A: We’ll answer the first question since the exact one wasn’t specified. Please submit a new question…

Q: what isthe current in the circuit after 1 μsec?

A: The equation for the current here is

Q: The current through a coil as a function of time is represented by the equation I(t) = Ae-bt…

Q: A pair of adjacent coils has a mutual inductance of 1.5 H. If the current in one coil changes from 0…

Q: A coil has an inductance of 8.00 mH, and the current in it changes from 0.200 A to 1.50 A in a time…

A: Given,L=8.00mH∆I =1.50A-0.200A∆t =0.350s

Q: A coil has an inductance of 1.5 H and a resistance of 0.6 ohm. If the coil is suddenly connected…

A: Given: Inductance L=1.5 H Resistance R=0.6 ohm Emf of battery E=12 V Required: Time for the current…

Q: A coil of wire with a resistance of 0.15 n has a self-inductance of 0.083 H. If a 5.0-V battery is…

A: We know that,Energy stored in an inductor , U=12LI2 Equation 1Given that,L=0.083HFrom ohm's…

Concept explainers

Voltage Across Inductor

An actor is a passive electrical component that consists of a coil bent in the form of wire which uses electromagnetism to produce electric current through the coil. When the electric current flows through a conductor that is the coil, a magnetic flux is developed around the conductor. This flow of current through the coil creates a magnetic field based on Fleming's Right-hand thumb rule. If there is any decrease in the current passing through the inductor, then the magnetic field will also decrease and energy is released through the generation of electric current. There is also a secondary voltage inducing in the same coil due to the magnetic flux, since it opposes any changes in the electric current flowing through the circuit. An inductor is also called choke, coil, or solenoid. A choke is designed to block certain frequencies when the DC current passes. A winding coil is coated with insulation to give extra insulation and protect the circuit. They are usually tightly wrapped around a central core which is cylindrical in nature so that the magnetic flux can be induced. The solenoid is a three-dimension coil that is used to exhibit electromagnetism when the magnetic field is developed due to the current flowing through the coil. The sign convention of the inductor is the same as the power dissipating device. When the current flows into the positive side of the voltage across the inductor, the value is positive and the inductor dissipates power whereas when the inductor releases the power back to the circuit, the current has a negative sign convention. 

Question

100%

(Can I get the answer in not more than an hour please? Thank you!)

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

An emf of 0.40 V is induced across a coil when the current through it changes uniformly from 0.10 to 0.60 A in 0.30 s. What is the self-inductance of the coil?
An emf of 9.7 × 10-3 V is induced in a coil while the current in a nearby coil is decreasing at a rate of 2.7 A/s. What is the mutual inductance of the two coils?
A coil with a self-inductance of 2.0 H carries a current that varies with time according to I(t) = (2.0 A)sin 120t . Find an expression for the emf induced in the coil.
A toroidal coil has a mean radius of 16 cm and a cross-sectional area of 0.25 cm2; it is wound uniformly with 1000 turns. A second toroidal coil of 750 turns is wound uniformly over the first coil. Ignoring the variation of the magnetic field within a toroid, determine the mutual inductance of the two coils.
Suppose that a rectangular toroid has 2000 windings and a self-inductance of 0.040 H. If h = 0.10 m, what is the current flowing through a rectangular toroid when the energy in its magnetic field is 2.0 × 10-6 J?
At the instant a current of 0.20 A is flowing through a coil of wire, the energy stored in its magnetic field is 6.0 × 10-3 J. What is the self-inductance of the coil?
The mutual inductance between two coils is 3.25 mH. A changing current in the primary coil resulted in a current of 5.45 mA in a secondary coil with a resistance of 9 ohms. What is the rate of change in the primary coil?
During a 68-ms interval, a change in the current in a primary coil occurs. This change leads to the appearance of a 4.1-mA current in a nearby secondary coil. The secondary coil is part of a circuit in which the resistance is 12 2. The mutual inductance between the two coils is 3.2 mH. What is the change in the primary current?
During a 58-ms interval, a change in the current in a primary coil occurs. This change leads to the appearance of a 5.5-mA current in a nearby secondary coil. The secondary coil is part of a circuit in which the resistance is 12 02. The mutual inductance between the two coils is 3.2 mH. What is the change in the primary current? Alp=
During a 74-ms interval, a change in the current in a primary coil occurs. This change leads to the appearance of a 6.6-mA current in a nearby secondary coil. The secondary coil is part of a circuit in which the resistance is 12 Q. The mutual inductance between the two coils is 3.2 mH. What is the change in the primary current? Alp=
Two coils are placed close together in a physics lab to demonstrate Faraday's law of induction. A current of 7.00 A in one is switched off in 1.30 ms, inducing a 3.00 V emf in the other. What is their mutual inductance (in mH)?
Two coils have a mutual inductance of 1.93x10-4 H. The current in the first coil increases at a uniform rate of 665 A/s. If the resistance of the second coil is 10 ohms, what is the magnitude of the induced current in mA in the Second coil?