The most common standard electronic current transmission signals range fron to mA.

Q: Draw the signal for C, D, and E on the timing diagram below. Initial condition, C=0, D=1, E=1.

A: In the given circuit the output waveform of the JK flipflop and the SR flipflop needs to be obtained…

Q: Noise caused by random fluctuation of electrons in an electronic device is

A: In the electronic devices noise unwanted signal that is superimposed on the input signal and then…

Q: 1. The Primary sensing element used in the given figure is Electrical output signal Bellows Pressure…

A: Explanation: Here bourdon tube is the primary sensing element. which is placed between the below and…

Q: A Demultiplexer accepts inputs. O a. Three O b. Single O c. Multiple O d. Two

A: A demultiplexer takes one single input and then decodes the signal and then switches it to any one…

Q: Apply the J, K, and CLK waveforms to the JK FF and determine the Q and Q' waveform. For a Negative…

A: apply the J, K and CLK waveforms to the JK FF and determine the Q and Q' waveform. for a negative…

Q: 1. The JFET is (a) a unipolar device (b) a voltage-controlled device (c) a current-controlled device…

A: 1.  A junction field-effect transistor (JFET) can have either electron or hole as the charge…

Amplitude modulation

A radio signal can carry information in the form of sound or image for broadcasting or communication. For it to be sent to a greater distance, the signal must be changed or modulated in some way. One of the easiest way is to change the amplitude of the signal with variations of the video or the audio signal. This is called Amplitude Modulaton. In this modulation information of message is carried in amplitude of carrier signal.