The mass of the flat belt is 0.6kg/m and the tension on the tight side of the belt is 1.7kN the coefficient of friction between the belt and the pulley is 0.2 and the angular speed N of the belt is 400rpm.Angle of lap fita and the diameter D of the pulley 150°and 50cm respectively.with the addition of centrifugal tension Design the belt drive by determine velocity belt centrifugal tension tension on the slack side of the belt power transmitted at this speed in kilowatts maximum power delivered

Q: Consider the following diagram. m1320 kg and m2= 10 kg. The system is being pulled by an applied…

A:

Q: 3. Find the tension in each wire, neglecting the masses of the wires. S. 45° System of interest- 30°…

A: Since you have posted multiple questions, we will provide the solution only to the first question as…

Q: 120N 60N 60°

A:

Q: AW-16-lb weight block is lifted vertically by a force of F-27 lb. Determine its acceleration. (Hint:…

A:

Q: A block with a mass of m = 1.8 kg rests on a wooden plank. The length of the wooden plank is 20 m…

A:

Q: PRACTICE PROBLEM 8.2 two minecarts are connected as shown below. Friction is negligible. Assume that…

A: It is asked to write the differetial equation of the system shown above

Q: The 70.62-kg climber in the figure is supported in the “chimney” by the friction forces exerted on…

A: Given: Mass of the climber=70.62kgCoefficient of friction between shoe and the wall…

Q: Consider a solid cylinder of mass 5 kg and radius 0.3 m on a surface with insufficient friction so…

A:

Q: F= 250N 40 9 Black = 3,5m/52 M= friction Block m= 8kg coefficient btwn black and channel 250M force…

A:

Q: However, I don't understand why the Force of Friction is going in the same direction as the…

A: Given Data:   To Find: Why the Force of Friction is going in the same direction as the displacement…

Q: 106 lb crate is initially stationary. Coeffi- cients of friction between crate and inclined surface…

A:

Q: A 0.3-kg block is placed against a rotating hollow cylinder of inner radius = 0.7 m. The cylinder…

A: Given data: Draw the free-body diagram of the block.

Q: The two ramps pictured here each have a region of length L with kinetic friction coefficient uk and…

A: As we all know that friction opposes the motion of an object. When the friction act on a body the…

Q: A cylinder of radius r = 0.15m and massm-8kg with an initial counterclockwise angular velocity w…

A: Given:To find:Momentum and impulse diagramsNormal and friction forcesTime to come for rest

Q: In the figure shown, a 10 kg block rests on an inclined plane that has a co-efficient of friction u…

A:

Q: Don't Use Chat GPT Will Upvote And Give Handwritten Solution Please

A: thank you

Forming and Shaping

Metal forming is a category of metalworking process through which the material can be given the desired shape and size by subjecting it to plastic deformation, where the component undergoes bulk deformation process upon application of loads. Unlike the shearing and machining process, the material does not undergo up to a failure point as indicated in the stress-strain curve. Hence, the stresses induced during the forming process are greater than yield strength but less than the failure strength of the material. The process does not lead to the loss of material, so it can be said to be an economical process. During forming, the material is subjected to tensile forces, compressive forces, bending, and shearing loading conditions. The material should possess the property of ductility to undergo the forming process.