Answered: The magnetic flux through the loop… | bartleby

Related questions

Question

=
The magnetic flux through the loop increases according to the relation g
6.0t² + 7.0t as show in the figure, where PB is in milliwebers and t is in seconds.
(a) What is the magnitude of the emf induced in the loop when t = 2.0 s? (b) Is
the direction of the current through R to the right or left?

Expert Solution

Step by step

Solved in 5 steps with 4 images

SEE SOLUTION Check out a sample Q&A here

Blurred answer

Similar questions

A 40 turn conductive loop encloses an area of 0.55 m?. At what constant rate should the magnetic field directed perpendicular to the loop change with time if the induced emf is to be 4.25 Volts? Consider only positive numbers here in your answer.
A solenoid with 500 turns and a cross-sectional area of 0.01 m² is placed in a magnetic fieldthat increases from 0 T to 1 T in 4 seconds. Calculate the average induced EMF in the solenoid.
A power line carries a current I = 100 sin(380t), where I is in amps and t is in seconds. A clever engineering student wants to steal power by inducing emf in a rectangular loop of copper wire as shown below. If the student wants to induce a maximum emf in the loop equal to 1.7 V, what should be the length L of the loop? Assume that the magnetic field produced by the power line is uniform inside of the rectangular loo and equal to the magnetic field at the center of the loop. 5 mi To equipment I 0.5 m
A metal rod moves with constant velocity along two parallel metal rails connected with strip of metal at one side as shown in Figure. A magnetic field B = 0.35 T points outof the page. If the rails are separated by distance ZL = 25 cm and the speed of the rod isv= 55 cm/s, find a) the induced emf and direction of induced currentb) the amount of heat released in this system in 3 min if the rod has resistance of 18 Qand the rails have negligible resistance.
What is the induced emf in the below coil if it is moving upward at 4.2 m/s in a uniform magnetic field of magnitude 0.82 T? What if instead, the field decreased as 0.82e-3t T over 0.1 s, now what is the induced emf? Also which way does the ENC go?
A 42 turn conductive loop encloses an area of 0.68 m2. At what constant rate should the magnetic field directed perpendicular to the loop change with time if the induced emf is to be 3.6 Volts? Consider only positive numbers here in your answer.
A 36 turn conductive loop encloses an area of 0.69 m2. At what constant rate should the magnetic field directed perpendicular to the loop change with time if the induced emf is to be 4.12 Volts? Consider only positive numbers here in your answer.