The magnetic bearing of a line AB was found 268°. If the local attraction at this station was 3° East and the declination was 12° West, calculate the true bearing of the line AB. 28. (a) S73° W (b) 277° (c) 253° (d) S79° W g E-mail: info@iesmaster.org

The magnetic bearing of a line AB was found 268°. If the local attraction at this station was 3° East and the declination was 12° West, calculate the true bearing of the line AB. 28. (a) S73° W (b) 277° (c) 253° (d) S79° W g E-mail: info@iesmaster.org

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: Using the method of components calculate the magnitude, direction, and location of the total force…

A: Given:- H=20m specific weight of water =1t/m3 specific weight of concrete=2.6t/m3 To find:- a)…

Q: A rectangular channel 2.5 m of width has a discharge of 0.30 m/see which is measured by a right…

A: Given: Width of rectangular channel, b= 2.5m Depth of rectangular channel,= d= 1.251m Discharge,= Q=…

Q: In terms of w, L, E, and I, determine the deflection and slope at x = L of the beam shown in Figure…

A: Draw the free-body diagram of the beam.

Q: The rod PQ of length L and with flexural rigidity El is hinged at both ends. For what minimum force…

Q: What is the prestress steel loss from steel relaxation at 356 days for a Grade 270 low-relaxation…

A: Given:- Initial stress = 190,000 psi Yield stress = 245,000 psi Time period = 356 days To…

Q: A 4.8-ft-long steel wire of 1/4 -in.-diameter is subjected to a 750-lb tensile load. Knowing that E…

A: This question is related to Strength of Material. In this question we calculate Elongated value of…

Q: Determine the magnitude of the resultant force acting on the hook in N if F 430 N and F= 260N 30° 30…

Q: Given data for column D = 350 Kips, L=250 Kips, 20 in x 20 in, 8#8 bars, fy = 50 ksi, f= 4 ksi, and…

A: The given data is shown below: D=350 kipsL=250 kipsSize of column=20 in.×20 in.fy=50 ksif'c=4…

Q: A wastewater sample is experimented for 5-day BOD at 20°C and it is found to be 120 mg/L. If the…

Q: A tower-mounted underwater turbine and a similar vertical-axis wind turbine both have rotors that…

Q: a) Reduce the plane forces system given in the figure to point O. b) Determine the influence line…

Q: Calculate the bottom width of a channel required to carry a discharge of 15.0 m/sec as a critical…

A: Given data : Channel=Rectangular channelThe value of discharge throgh rectangular channel Q=15…

Q: A beam is subjected to a 60 kN point load at C and a uniformly distributed load 10 kN/m at point A…

Q: In the figure, ideal fluid (water) flow from the infinity large basin through the atmosphere.…

A: Given:- absolute vapour pressure=0.025 kgf/cm2 absolute atmospheric pressure = 1kgf/cm2 AB dia=0.30m…

Q: Find the check value from the following levelling values: Station 1: BS 2.345, IS 2.33, FS 3.2,…

Q: Classify the following soils by the (1) USCS and (2) AASHTO classification system and give the group…

A: AASHTO soil classification system is based on, Grain size distribution Atterburg's limits…

Q: Please explain What pavement distresses that can be caused by having gap graded and dense graded…

A: "The certain evidence of inadequate or unfavorable pavement condition or symptoms of approaching…

Q: A 6.0m long simply supported reinforced concrete beam has a width of 350mm and an overall depth of…

A: Given : 350 X 470 mm beam, fc = 20.7 MPa, fy = 415 MPa 4 - 28 mm dia bars in tension side and 2 - 28…

Q: A ride in an amusement park consists of a rotating arm AB having a constant angular velocity wAB = 2…

Q: Find the Zero- Force Members at the shape: D. 10 A M 10 ft 10 t 10 A 10 A 10 ft 10 t 10 A 6 kips 6…

A: To find the zero force members-

Q: Find the forces in members EF, KL, and GL for the Fink truss shown. Forces are positive if in…

A: Given : A fink truss with loads as shown in the figure below Required: To find force in EF,KL and…

Q: If in a Dorry abrasion test the loss in weight is 21 gms, then the coefficient of hardness is b 13…

A: Given data : Loss in weight =21 gms

Q: A dam has its water face in the shape of a circular arc as shown in the figure below. Calculate the…

A: Consider the given diagram.

Q: At the bottom of a 2 m iameter vertical cylindrical tank is a sharp-edged orifice with a diameter of…

Q: A truss carries a concentrated load at points B, E F. and G as shown in the figure below. Using unit…

Q: If A is a 3 x 3 matrix such that A= 3, then 2adjA|

Q: At the exit of a toll gate with a single booth, vehicles arrive at random at a rate of 20 vehicles…

Q: The following table shows a compilation of a partial series of rainfall events for a location from…

A: Data Given:

Q: Question 3) Determine the forces in given (S,,S,,S,and S) members for the plane truss system in the…

A: The FBD of the section is shown below:

Q: Water is flowing. Calculate direction and aproximate magnitude of the manometer reading. 1Scm 15 m…

A: Fluid is an important part of the fluid mechanic's sector. Fluid can be compressible or…

Q: AW 18 x 40 of A992 steel and has two lines of 1-inch diameter bolts in each flange. There are four…

A: The section properties of W 18x40 is shown below: The design strength for LFRD as per net fracture…

Q: Given an E +0.15 and Ep -0.24, What is the Ec? -0.30 +0.62 -0.28 +0.28

A: given data: EL = + 0.15 ED = - 0.24

Q: The table below shows the composition of a municipal solid waste (MSW) sample. The typical moisture…

A: Component percent by mass percent moisture Density Food 30 70 290 Paper 20 6 85 Cardboard…

Q: raw Mohr's circle and determine the principal stresses. 30 MPa 30 MPa 40 MPa -9-

Q: a. A highway section has an average spacing of 10m under jam conditions and a free- flow speed of…

A: Spacing between vehicles under jam condition = 10 m ⇒Jam density = Kj=110 veh/m =0.1 veh/mor,…

Q: Find the characteristics of the horizontal curve (in feet), if the design speed 75 mph, e 0.06 and…

A: In creating a curve, the tangent distance must often be limited. Examples include crossings of…

Q: ) Find the support reactions and the forces at hinge of the plane frame system given in the figure.…

A: Introduction - A beam is a structural element with a cross section that is substantially smaller…

Q: Collar A starts from rest and moves upward with a constant acceleration. Knowing that after 8 s the…

Concept explainers

Site Plan Requirements

A site plan (also known as a plot plan) is a diagram or process to show the proposed improvements on an existing property. A site plan is important, as it provides information regarding the landscape features of a given plot of land. Zoning is done or can be understood with the help of a site plan.

Question

Asap

The magnetic bearing of a line AB was found
268°. If the local attraction at this station was
3° East and the declination was 12° West,
calculate the true bearing of the line AB.
28.
34.
(a) S73° W
(b) 277°
(c) 253°
(d) S79° W
In o
+rovor
dofloot
g E-mail: info@iesmaster.org

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

How would I go about finding E,F?
Find azimuth EA and AE
Where X =2
16 - please answer correctly
Complete the table below. STATION BM1 A с D E F BM2 BS 1.470 1.967 2.792 2.225 2.209 1.072 Highest elev of the line of sight Station with the highest elevation (excluding BM1 & BM2) Lowest rod reading Station with the Highest BS Lowest Elevation HI 368.382 369.414 370.245 370.780 370.278 371.138 FS 1.200 1.136 1.082 3.400 0.212 1.204 ELEV 367.182 368.278 369.163 368.555 368.069 369.934
At a given place the magnetic bearings of two lines are AB N35o28'E and CD S60o25'E. If the magnetic declination is 5o12'W, what are the astronomic bearings of the lines?
Compute the area
Deflection Angle Traverse Given the bearing of each line of a closed traverse ABCDEF, determine the deflection angles of each line. Line Bearing AB S 46°17’ E BC N 23°28’ E CD N 78°55’ W DE S 56°42’ W EF S 13°00’ W FA N 76°05’ E * Sum of Deflection Angle = 360° * Note: EXPRESS YOUR ANSWER UPTO 3 DECIMAL PLACES. (Please answer this problem with accurate and proven solution. Thank u)
Find div F and curl F if F(a, y, z) = 5y°z'i – 14x°2°j – 5xy'k. %3D | div F= curl F=
Survey- The observed magnetic bearing of a line OE was found to be 185°. It was later discovered that station O had a local attraction of + 1.5°. The true bearing of the line OE, considering a magnetic declination of 3.5° E shall be
HI! HELP ME PLEASE. TYSM
The people in Metropolis made a tribute for Clark Kent and performed a survey to form his crest as shown in the figure. The course of the traverse is alphabetical (A-B-C-D-E-A). Determine the following: a. The unknown angle at point E. b. The bearings and azimuths (from north and south) of all the lines of the traverse assuming that line AB has a bearing of S 75°30' E.