the LRT II Project, steel railroad rails of 10m long are to be installed. If the lowest mperature considered is 16C, and a maximum temperature of 36C is designed for, suming coefficient of thermal expansion of steel to be 11.6 x 10^-6 m/m-C and modulus elasticity of steel to be 207,000 MPa. Should the excessive high summer temperature 40C occur, determine the induced stress in the rails at that temperature. (Pa)

the LRT II Project, steel railroad rails of 10m long are to be installed. If the lowest mperature considered is 16C, and a maximum temperature of 36C is designed for, suming coefficient of thermal expansion of steel to be 11.6 x 10^-6 m/m-C and modulus elasticity of steel to be 207,000 MPa. Should the excessive high summer temperature 40C occur, determine the induced stress in the rails at that temperature. (Pa)

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

@12
Maximum principal stress
Steel railroad rails 10 m long are laid with end-to-end clearance of 3 mm at atemperature of 15°C. (a) At what temperature will the rails just come in contact? (b)What stress would be induced in the rails at that temperature if there were no initialclearance? Use a = 11.7 x 10-6 PC and E = 200 GPa.
A typical aluminum-alloy scuba diving tank is shown. The outside diameter of the tank is 200 mm and the wall thickness is 12 mm. If the air in the tank is pressurized to 14MPa, determine the maximum shear stress in the plane of the cylinder wall. 24.1 MPa 15.5 MPa 25.7 MPa 32.2 MPa 20.9 MPa
i need the answer quickly
Solve by hand please need urgent
Define the below ? Lateral strain is considered – Skempton–Bjerrum method
Situation 2: A hollow steel tube has an outer diameter of 90 mm and a thickness of 14 mm. Determine the maximum tensile load (kN) it can carry if the working stress is limited to 110MPa.
asap pls 15 mins
8 KN 2m 3m 6KN. Am 3m, 3m A B 2m 6KN cross-Section 300mm 150mm Only considering stresses that are normal to the cross-sections you're designing. Where omax is the maximum value of stress developing in the cross-sections. Calculate omax
The composite shaft shown in the figure consists of a bronze sleeve (1) securely bonded to an inner steel core (2). The bronze sleeve has an outside diameter of 35 mm, an inside diameter of 30 mm, and a shear modulus of G2 - 45 GPa. The solid steel core has a diameter of 30 mm and a shear modulus of G2 - 85 GPa. Assume L - 380 mm. The composite shaft is subjected to a torque of T- 800 N-m. Determine (a) the maximum shear stresses in the bronze sleeve and the steel core. (b) the rotation angle of end B relative to end A. (1) L B Answers: MPa (a) TI = MPa rad (b) PBIA =
Detailed description answer.