The longest footbridge in the world is found in San Francisco California. You are a civil engineer in charge of reconstructing the said bridge with a span of 50 meters. What will be the change in length of the steel deck of the span when the temperature increases from 71 degrees celcius to 95 degrees celcius

Q: a. The Swiss mathematician 'Leonard Euler' derived an equation for buckling load of columns. The…

A: According to Euler's column theory, the critical load (P) on the column for different types of end…

Q: We are putting up a very tall building, which weighs 200,000 tonnes. This weight is to be carried on…

A: Given Data: Weight of building is W=200000 Tonnes. Number of steel I-beams used is n=500. Yield…

Q: Water is flowing at a rate of 700 gpm through a horizontal 6 inch schedule 80 commercial steel pipe…

A: Given :

Q: Two people, at the ends of a uniform beam that weights 400 N, hold the beam at an angle of 25…

A: Weight of beam = 400N Beam held at 25° with horizontal

Q: What is the time Rate of Capillary Rise?

A: The capillary rise is defined as “the ability of water to flow upward due to the force produced by…

Q: hot air (50 degrees Celsius) from a compressor will flow at an average speed of 120 m / s and flux…

A: Given: Diameter of pipe=4cm Mass flux=0.1kg/s Average speed,V=120m/s Density of hot air at…

Q: You are the second engineer designing a building for a large machinery workshop, how do you avoid…

A: Calculate the bearing capacity factor a building for a large machinery workshop,  Bearing capacity…

Q: A rectangular block of wood 12 cm high floats on water. If the specific gravity of the wood is 0.75…

A:

Q: What is the location of the resultant force on a vertical triangular gate (1.2 m high x 1.5 wide)…

A:

Q: * نقطة واحد If the wall high is 20 ft, long = 30 ft and the water level is 15 ft, what is ? the…

A:

Q: A mass of 30kg is hung from a steel wire of radius 7cm and length of 40m. What should be the minimum…

A: Given data : Mass (M)=30 kgLength (L)=40 mRadius (R)=7 cmMaximum stress (σ)=2.4×108  N/mm2

Q: Calculate the modes and frequencies for the following 2-story flat building, considering the masses…

A: Given Data:P1=10ton=98.07kNP1=20ton = 196.13kNM2=0.80mEc=Fc=250kgf/cm2

Q: A stone dropped from a bridge strikes the water in 5 seconds. Find the speed with which it strikes…

A: The basic formula used are v=u+ats=ut+12at2 Here v is the final velocity, u is the initial velocity,…

Q: what is the smallest clearance from the top of the tank so that the truck can pass under the bridge

A: This question is from civil engineering

Q: A slab of concrete used in highway construction is set in place when the ambient temperature is 20…

A: Given -

Q: Help Save & Exit S Archimedes, when asked by King Hiero if the new crown was pure gold (SG = 19.3),…

A:

Q: Explain Formula Used in head loss due to Friction.

A: To explain :- the formula used in head loss due to friction. NOTE :- There are several formulas to…

Q: Thank you. How about the coefficient of friction when did you use it?

A: Kinetic friction can be described as a force that exists among surfaces that are shifting. A force…

Q: examples of designs on how buildings are designed to adapt against thermal expansion or contraction.…

A: Thermal expansion refers to the tendency of matter to alter shape, area, volume, and density in…

Q: Strength of materials. A steel cable is 2.0 centimeters in diameter and 5.0 x102 meters long. How…

A:

Q: A built-up steel I-girder is 2 m deep over the flanges, each of which consists of four 1 cm plates,…

A:

Q: A man is standing near a window. The window is 5.69 meters tall. The man watches a falling stone…

A: Window tall = 5.69 m Time t= 0.34 sec V2-U2=2as= 2*9.81*5.69= 111.6378 m…

Q: Determine the change in length of a 72 m run of 53 trade size rigid steel conduit in a temperature…

A: Given data: Length of rigid pipe, L=72 m Temperature range, ∆T=25-(-40)=65° C To find: Change in…

Q: A piece of wood floats in water with 15cm projecting above the water surface. When placed in oil,…

A:

Q: Does changing the shape of a column increase axial capacity? Does splicing the column maintain the…

A: This question is related to reinforced concrete Stuctures. There are multiple questions in a single…

Q: An 18-ft high column shortens by 0.4 in. under a load.  What is the resulting strain in the column?

A: Given, L = 18 ft  δL = -0.4 in

Q: 4. The auditorium in Hancock Hall located on the campus of Virginia Tech is situated at 37°13'49"…

A: coordinate of Patton Hall=N37°13'49"…

Q: 5. The drag coefficient of a complete structure such as an aircraft includes a) Form drag b)…

A: The drag coefficient of a complete structure such as an aircraft includes _____ a) Form drag b)…

Q: A block of wood requires a force of 40N to kee it immersed in water and a force of 100N t keep it…

A: GIVEN DATA:-⇒Force required to keep wood immersed in water= 40 N⇒Force required to keep wood…

Q: What is the flexural stress in psi, 3 inches from the top of the beam and 2 feet from the left end…

A:

Q: If a wire weighing 0.10 lb/ft is stretched between points 100ft. apart until the tension reaches…

A:

Q: Hello, can you explain more about the theory in simpler terms? Why would they need to use this…

A: Euler-Bernoulli beam theory is a method to analyze a slender beam (a slender beam has a length much…

Q: (a) What is the value of the Reynolds number? (b) What is the magnitude of the pipe wall roughness?

A: The values given in the question are as follows: Water flow rate(Q)=700 gpm or 2695 in3/sec Diameter…

Q: The weight of 4 feet of 1-inch copper tubing is 2.62 pounds. Find the weightof 20 feet of the…

A: The weight of one-inch copper tubing can be calculated very easily by using the unitary method. The…

Q: ello What is the difference between structures 1 and 2 under the same load? In fact, the question…

A: Rigidity is nothing but the ability of material of an object to resist the shear force i.e. how much…

Q: Ib/ft acting along the entire length of the beam, a concentrated om the right-hand support, and a…

A:

Q: Explain which time we have torsion on our structure members?

A: Torsion is also known as twisting which acts when the ends of structure are subjected to twisting…

Q: We are putting up a very tall building, which weighs 200,000 tonnes. This weight is to be carried on…

A:

Q: 60cm Figure 6

A: Given data Height of the house above street level = 60 cm. We have to find the lowest value of the…

Q: A 50 ft. piece of tubing weighs 1.7 lb. What is the weight of a 27-ft. piece of tubing?

A: Solution  The solution of the above question is in the second step

Q: A Building has interior columns spaced at 8 m apart in two perpendicular directions. Given design…

A:

Q: A 6-ft wide by 6-ft tall gate is hinged at the top and holds a reservoir of water (specific weight =…

A: Gate dimensions6 ft wide6 ft tallFind:(a) Pressure on the bottom of the gate(b) What is the force of…

Pressure and Stress