The interior angles of a hexagon were observed and recorded as follows: A = 122 degrees 31'02", B = 123 degrees 26' 17", C = 130 degrees 05'07", D = 120 degrees 15' 47", E = 160 degrees 50' 35" and F = 62 degrees 53' 07". Find the discrepancy of the measurement.

Q: The interior angles of a hexagon were observed and recorded as follows: A = 122 degrees 31'02", B =…

A: To find correct angle D

Q: An upright aerial photograph is taken using a camera focal length of 150.7 mm, where there are 2…

A:

Q: The following interior angles of a five-sided figure were measure with the same precision. ANGLE…

A: The given data is shown below:

Q: Four interior angles of a five-sided polygon traverse were observed as A = 110°4759", B =…

A:

Q: an angle with radian measurement of -2π/3 has a reference angle equal to ?choose from the choices 60…

A: Option (a) 60 degree: This option is correct because −2π​/3 radians is a negative angle. To convert…

Q: 1. What is the distance between the stadia hairs on the instrument's scope? (answer in mm) 2. What…

A:

Q: Four interior angles of a five-sided polygon traverse were observed as A = 110°4759", B =…

A: Observation Station  Interior Angle  A 110°47'59" B 121°06'12'' C 122°33'32" D 114°02'25"…

Coordinate Geometry of Survey

Coordinate geometry (COGO) is a method of inserting surveying or engineering data into geographic information system (GIS), computer-aided design (CAD), or mapping software. These data can be collected on the proposed construction site using standard surveying techniques and instrumentation or may be taken from existing maps, engineering plans, drawings, or records. Data gathered on the site includes coordinates of points, bearings, and distances between points. The data are noticed and noted through conventional surveying procedures, like a traverse or layout measurement series and it can be either digital or non-digital. The maps and plans are inclusive of boundaries, divisions, and other components, and these features are shown with coordinate values, the lengths, offset distance, and bearings between them.