The information in an analog waveform, whose maximum frequency fm34000Hz, is to be transmitted using a 16-level PAM system. The quantization must not exceed ±1% of the peak-to peak analog signal. (a) What is the minimum number of bits per sample or bits per PCM word that should be used in this system? (b) What is the minimum required sampling rate, and what is the resulting bit rate? (c) What is the 16-ary PAM symbol Transmission rate?

The information in an analog waveform, whose maximum frequency fm34000Hz, is to be transmitted using a 16-level PAM system. The quantization must not exceed ±1% of the peak-to peak analog signal. (a) What is the minimum number of bits per sample or bits per PCM word that should be used in this system? (b) What is the minimum required sampling rate, and what is the resulting bit rate? (c) What is the 16-ary PAM symbol Transmission rate?

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

solve part (iv), let the writing easy to read pls.. thanks
Q2: The information in an analog signal voltage waveform is to be transmitted over a digital communication system with an accuracy of The analog voltage waveform has a bandwidth of 200 Hz and an amplitude range of -8 to +8 volts. Determine 1- The Minimum bit rate. 2- Minimum absolute channel bandwidth required for the transmission of the signal.
What will be the minimum bandwidth for a PCM system which has a 10 kHz input signal and 8 bits per sample transmission mode.
4. How to use the PLL circuit and the logic circuit to comprise a doubler frequency circuit?
1- Consider a PCM system for a sinusoidal signal 2 cos2л 2000t. It is desired to represent this signal such that the signal to quantization noise ratio is 20 dB. Determine: (a) Sampling frequency required. (b) The quantizing step size. (c) The number of bits per word (per sample). (d) Bit rate and bit duration. (e) The channel bandwidth needed.
What is the "Nyquist-Shannon sampling theorem," and how does it impact digital data transmission?
The output signal from a frequency inverter will appear on a scope screen as a: A. pure sine wave of different frequencies. B. triangular-shaped waveform with distorted peaks. C. distorted square wave. D. distorted sine wave.
3/ An analog signal is converted to a binary PCM signal and transmitted over a band-limited channel at 100 kHz. band-limited channel at 100 kHz. Thirty-two quantization levels are used. a/ Calculate the maximum bit rate that can be transmitted. b/ Calculate what is the maximum bandwidth that the analog signal can have.
Define and explain the difference between analogue and digital signals elaborating on the advantages and disadvantages of both.
2. Draw the circuit diagram of linear voltage regulator for fixed output voltage using IC78xx and IC79xx. Describe its principle of operation at input voltage. increasing