(the Greek letter phi). The first alternator Assessment activity 4.2 alternating current. dynamo electric ge based on Michael Work in pairs. principles. amplitude of 12 V and a frequency of 50 Hz. Your sketch should show one cycle only, i.e. 360°. 1. Sketch a graph of voltage over time for a sine wave with an a) Determine the periodic time. 2. An AC current completes one cycle in 10 ms. c) Sketch the waveform if the maximum value is 2,5 A. Sketch one cycle only, i.e. 360°. 3. What do you understand by the following terms related to a sine wave? a) frequency b) amplitude 9 periodic time 4. What is the frequency of an AC current if it completes five cycles in 10 ms? 5. If the frequency of an AC supply is 10 kHz, determine the periodic time in us. b) Determine the frequency.

(the Greek letter phi). The first alternator Assessment activity 4.2 alternating current. dynamo electric ge based on Michael Work in pairs. principles. amplitude of 12 V and a frequency of 50 Hz. Your sketch should show one cycle only, i.e. 360°. 1. Sketch a graph of voltage over time for a sine wave with an a) Determine the periodic time. 2. An AC current completes one cycle in 10 ms. c) Sketch the waveform if the maximum value is 2,5 A. Sketch one cycle only, i.e. 360°. 3. What do you understand by the following terms related to a sine wave? a) frequency b) amplitude 9 periodic time 4. What is the frequency of an AC current if it completes five cycles in 10 ms? 5. If the frequency of an AC supply is 10 kHz, determine the periodic time in us. b) Determine the frequency.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

a) A sinewave is having a frequency of 60 Hz and instantaneous voltage of 100 Volts at 1.5 milli seconds. Find: i) The maximum value of sinusoidal voltage waveform ii) The value of voltage at 2.1 milli seconds. b) An alternating voltage is given by v=300 sin(120TTT +0.25) volts. Find: (i) Peak Value of Voltage (ii) r.m.s Value of voltage (iii) Phase angle in degrees with respect to 300sin(120Ttt). (iv) The instantaneous value of voltage when t=0 (v) Draw the sine wave of 300sin(120tt).
Suppose that at any given time t (in seconds) the current i (in amperes) in an alternating current circuit is i= cost + sint. What is the peak current for this circuit (largest magnitude)? The peak current for this circuit is amperes. (Type an exact answer, using radicals as needed.)
A double beam oscilloscope displays 2sine waveforms A and B. The time/cm switch is on 100us/cm and the volt/cm switch on 2V/cm. The width of each complete cycle is 5cm for both the waveforms. The height of waveforms A and B are 2cm and 2.5cm respectively. Determine their a) frequency, b) phase difference, and c) peak and r.m.s value of voltages. The difference between the two waveforms is 0.5 cm.
1. Impedance is the total opposition to an AC circuit caused by electric penalty tions, the tra capa multiple pacitive systema 62 Fundamentals of AC Electricity Questions for This C a. 1. Draw a diagram of an AC sine wave and identify its peak voltage and peak-to-peak voltage levels. b. 2. Explain the term frequency as it refers to AC electricity. c. 3. Discuss the difference between a load center and a fused disconnect. 2. WE wa 4. Explain how you would test for voltage in a fusible dis- connect on the line-side and load-side terminals. vi ci 5. Trace the path of a generated AC voltage from the generat- ing station where it is produced to the point where you would connect it to a machine in a factory. Be sure to iden- tify all the important parts of the system between the gen- eration station and the disconnect on the machine. a. be 3. True or False inductive reactance, capacitive reactance, and resistan 2. The units of impedance are
A sinusoidal voltage has a value of 100 volts at 2.5 milliseconds and completes one cycle.It takes 20 milliseconds. Then find the maximum cost and the time to reach it for the first time
a. A circuit with half-wave rectified signal has a dc voltage of 0.318Vm. The rms value of the ac component of the output signal is 0.385Vm. Calculate the percentage ripple of a half-wave rectified signal.
i need the answer quickly
HomeWork e P/Given the Wavefom shown below, Calculat the Areraga Yalue off one cycle of the wanform. 13 IS T7 19 21 -5 L15 LAnse2.308 v P2l For the fallowieg waveform, Calenlate. the Volue. to %3D 13 16 -20 [Ans:5.625 V] 20
Problem # 4 For the waveform shown below. Vertical sensitivity is 1 volt per division, and horizontal sensitivity is 1 mS to per division. a. What is the peak value of the waveform? b. What is the peak to peak value of the waveform? c. What is the period of the waveform? d. What is the frequency of the waveform?